Has anyone had problems with Domayne using generic third party RAM for memory upgrades? My RAM is now faulty and had to be removed, but Apple wont replace it under Apple Care because its not a genuine component?

The computer was purchased in the knowledge that all components and hardware were genuine and subsequently covered by the Apple Care warranty.
Domayne replaced the genuine components (8GB stick) with generic components (2x 16GB sticks) to save money and boost margin.
Apple should not allow this misleading, profiteering behaivour. This behaviour is brand damaging. Apple must maintain more control over their supply chain.
Has anyone had any expirenece with this problem?
Has anyone made Domayne or other third party resellers acountable for this misleading behaviour?
Thank you.

Stick with Brand name RAM and reputable distributors.  Mac is finicky about low quality RAM
Try OWC http://www.macsales.com/
Crucial http://www.crucial.com/
Most RAM comes with Lifetime guarenntee so return it where you got it.

Similar Messages

  • D800 file compatibility:  Has anyone experienced problems with loading D800 files onto the iPad using the camer connector kit?  I have tried both RAW and JPEG using SDHC and CF cards and the iPad(3) doesnt recognise any of the files.

    Has anyone experienced problems with downloading Nikon D800 files to the iPad3 using the camer connector kit?  I have tried .RAW and JPEG (of various sizes) on both SD and CF cards, but the iPad doesn't recognise the files. 
    I have seen various forums discussing Lightroom and PSE updates that are required to process .NEF files but I can't find anything on the iPad/camera connector issue.
    I dont have any problem if I put the SD card straight into the SD slot in my iMac and Aperture will process the files fine, but I would really like to be able to download and view files on the move on the iPad.
    Any advice appreciated?
    PS - saw something that suggested the iPad had a maximum file size of 16mb for photos, not sure if this is correct, but I have tried smaller JPEG files and they still aren't recognised.

    If your camera supports both PTP and Mass Storage Device modes, it may be necessary to use both modes to import all media content.
    If some files do not import as expected using one mode, try switching to the other mode and importing again.
    Note: Some cameras may refer to PTP as Pictbridge or PTP/Pictbridge.

  • Has anyone experienced problems with Mackeeper? I did not complete downloading this software. Yet, occasionally when on the internet, I will have the MacKeeper multi-colored circle replace my pointer. How do you deal with this?

    Has anyone experienced problems with Mackeeper? I did not complete downloading this software. Yet, occasionally when on the internet, I will have the MacKeeper multi-colored circle replace my pointer. How do you deal with this?

    Welcome to Apple Support Communities
    Don't download MacKeeper. Users complain about this app and it damages OS X. Also, Mac OS X knows how to take care of itself, so you don't need any other cleaning application that may damage OS X. See > https://discussions.apple.com/docs/DOC-3691

  • Has anyone experience problems with loading the latest Flash Play?

    Has anyone experienced problems with loading the latest Flash Player?  I have done this several times and the same results come up - Install the latest Flash Player.  I run Microsoft Vista.

    What is your browser?  If IE see
    http://forums.adobe.com/thread/885448
    http://forums.adobe.com/thread/867968

  • Has anyone else had problems with the macbook pro after the OS X Yosemite upgrade?

    has anyone else had problems with the macbook pro running slow after the OS X Yosemite upgrade?

    Same for me! my iphone 4s gets extremely hot whit IOS 7.0.2.

  • Problems with enhancers, haxies, other third party apps?

    Many posts in Apple Discussions have blamed haxies and various third party apps for many opperational problems. I found the Dock so irritating (and the Launcher) that I primarily used OS 9 until 3 haxies were released with the classical drop down Apple Menu. I installed FruitMenu, Xounds and Application Enhancer November 11 2002 on 2 computers. I also have 3 GUI's installed. I have installed every OSX update and have had no problem of any type with computer operations. With each OSX update you should update your third party apps when required.

    Stick with Brand name RAM and reputable distributors.  Mac is finicky about low quality RAM
    Try OWC http://www.macsales.com/
    Crucial http://www.crucial.com/
    Most RAM comes with Lifetime guarenntee so return it where you got it.

  • Has anyone encountered problem with VIRSA_CC_ACTUSAGE missing some data?

    Has anyone encountered a problem where the VIRSA_CC_ACTUSAGE table is missing some transaction activity?
    We have a situation where the monthly ST03 file shows that a user executed the MI31 transaction some time back in August.  However our ACTUSAGE table does not show this user performing MI31 for any day in August. 
    It does have records of other people using MI31 in August.  It also has records of this same user performing other transactions in August.  It even has records showing other transactions this same user performed in August.
    This is now an issue with our external Auditors.
    We are on GRC 5.3 SP 13.
    Thanks.

    Hi Bob,
    VIRSA_CC_ACTUSAGE holds information on the transactions executed by users and it gets the data from STAD. Did you notice the time user has spent in the MI31 transaction code (I know even if the user hasn't spent more time, it should be recorded), but this another step to isolate the issue.Also, check SM21 logs on that specific day, and see if there are any events registered during that time related to STAD. I think it was not able to collect the data.
    Also, check VIRSA_CC_ALTCDLOG. This is the Alter log table that stores information of ACTUSAGE. The purge utility will only delete the data from the ACTUSAGE, but it remains in the ALTCDLOG.
    Refer to SAP Note 1512020 for additional details on the Alert files.
    Hope this helps!!
    BR,
    Raghu

  • Has anyone experienced problems with Outlook after installing Mavericks?

    Has anyone else experienced problems using Microsoft Outlook after installing Mavericks?  The computer seems to want to continue reloading emails.

    RobertRTillman wrote:
    1. Apple has removed sync services in OS X Mavericks. Therefore, you cannot sync Outlook 2011 with Contacts or Calendar.
    2. Apple has removed the ability to sync through iTunes in OS X Mavericks, so that, even if you use Contacts and Calendar on the Mac, you can only sync them with your iPhone through iCloud, thus exposing all your contacts and calendar information to the mercies of the Web.
    3. Microsoft does not not support CalDAV and CardDAV in Outlook, so there is no way to sync directly through iCloud, except perhaps by setting up a Microsoft Exchange account.
    4. Apple makes it extremely difficult (virtually impossible) to revert to a version of OSX that is earlier than OS X Mavericks once Mavericks is installed.
    In short, we are screwed and neither company seems to care.
    In fact Microsoft does support Cal and CardDav in Outlook, just not in the Mac version of Outlook.
    Reverting back from Mavericks requires nothing more than a backup of the system to restore from, if you do not elect to make backups that is a choice, but I would venture that it is a bad choice.

  • Has anyone experienced problems with outlook mail after ios6

    Starting with the release of iOS6 I have had a problem with mail making it to my desktop. I never had this problem before.  The mail arrives fine on my iPad and iPhone, but it's not in my ourlook inbox.  Any ideas?  I have the iPhone 4 and the original iPad.  I have checked the settings and the "mail" option is set to "on" on both devices.

    RobertRTillman wrote:
    1. Apple has removed sync services in OS X Mavericks. Therefore, you cannot sync Outlook 2011 with Contacts or Calendar.
    2. Apple has removed the ability to sync through iTunes in OS X Mavericks, so that, even if you use Contacts and Calendar on the Mac, you can only sync them with your iPhone through iCloud, thus exposing all your contacts and calendar information to the mercies of the Web.
    3. Microsoft does not not support CalDAV and CardDAV in Outlook, so there is no way to sync directly through iCloud, except perhaps by setting up a Microsoft Exchange account.
    4. Apple makes it extremely difficult (virtually impossible) to revert to a version of OSX that is earlier than OS X Mavericks once Mavericks is installed.
    In short, we are screwed and neither company seems to care.
    In fact Microsoft does support Cal and CardDav in Outlook, just not in the Mac version of Outlook.
    Reverting back from Mavericks requires nothing more than a backup of the system to restore from, if you do not elect to make backups that is a choice, but I would venture that it is a bad choice.

  • HT5815 has anyone experienced problems with this update.

    After insaling it I cannot log on to my mac? had to restore to my latest timemachine backup

    Quite a few people have problems with every update. Almost always it is tied to third-party software incompatibility.
    If you run into a problem like that, boot into Safe Mode. If that succeeds, it is definitely a third-party software issue.
    http://support.apple.com/kb/HT1455
    Some company's just can't be bothered making their software compatible with each release.

  • Has anyone noticed problems with loading contacts into car phone books after updating to ios6?

    My iPhone 4S will now load onlycontacts listed in my Favorites.  Previously it loaded everyone in my contacts list.  Since I haven't changed vehicles nor phone, I can only assume its a software issue.  Unfortunately since I chose replace when giving my car directions I lost all the contacts previously loaded.

    hi, 
    i updated my Nokia N8-00 last night with Nokia Suite and symbian Belle was successfully installed in it. . 
    It worked for few hours and i installed few applications from Nokia Store and was everything fine. . 
    But suddenly in the morning my phone switched off and never started again. . I treid to start but only Nokia was appearing on the screen and it was unable to boot further. . right now i gave the phone in Nokia Care, they told it takes around 10-12 days to get the phone back from Company. .
    Kindly guide me for the problem as i am completely helpless without my Phone working. . 
    Regards,
    Dhaval Aghera
    djaghera

  • Itunes wont lets me download a song because its not authorized?

    itunes says the song is on my ipod but its not and when i download my ipod it says some songs arent authorized....i tried to authorized it with my husbands account but it still says its wrong

    You need to login to the account for which you purchased the music with. First log out of that account (iTunes store, top right hand corner email, click the tiny arrow on that, sign out). Then sign in with the one you purchased the music with (iTunes store, top right, click on sign in). Then go up to the store menu in iTunes and click it.  Click authorize account. That should fix it. Using your husbands account will not work unless that account purchased the music. It is apple's way of dealing with piracy

  • HAD PROBLEMS WITH MY IMAGE QUALITY AFTER REFILLING CARTRIDGES FOR HP COLOR LASERJET 5225

    CAN SOME ONE REALLY COME TO MY AID.AFTER REFILLING THE CARTRIDGES HP CE740a, 741, 7421 742, 743A and reinstalling in the the printer hp color lasejet 5225 i have double images. i even tried to replace some of the drums and had no improvement.Please i would be grateful if someone can give me a clue to resolving this problem.thanks

    Please install a brand new HP cartridge to see if that resolves the issue.
    Say thanks by clicking the Kudos Thumbs Up to the right in the post.
    If my post resolved your problem, please mark it as an Accepted Solution ...
    I worked for HP but now I'm retired!

  • Problem with the installation of Third party softwares

    Hi
    I've installed Windows server 2008 R2 Enterprise Edition on my server. Installation was successful.
    Now I've problem with installing third party Applications. While installing one of the IBM product on my machine it's throwing an error in the middle saying that ERROR:1704 and ERROR:1719 saying windows installer service could not be accessed.
    Kindly help me in this issue asap.
    Thank you.
    Regards,
    Shivaji Alluri

    Hi Shivaji Alluri
    You might want to restart the server.
    After that, you right-click on setup.exe and Run as administrator
    Error 1704 Install for program is currently suspended. You must undo the changes made by that install to continue.
    Suggestion: go to regedit, HKLM\Software\Microsoft\Windows\CurrentVersion\Installer\InProgress
    and remove the value.
    Error 1719 Windows Installer service could not be accessed
    Suggestion:
    1) Run Fix It Tool (http://support.microsoft.com/mats/Program_Install_and_Uninstall)
    2) download and re-install Windows Installer

  • Has anyone encountered problems with installing so...

    I have a problem.. there are some themes and software that I cannot install because i receive an error message that saiz :"expired certificate " or something like that..
    I have to mention that the install all software box is checked.. so is there any solution ?
    regards Ionut

    I downloaded and installed the 10.6.8 Combo this morning and immediately thereafter when I tried printing a document on my OfficeJet Pro 8500 from HP the system paused for two minutes and THEN printed the document.  I tried printing several other documents with the same result.  However, I then shut down and restarted my iMac, and when it had finished rebooting, I tried printing again and the pause in the system for printing was gone.  Problem solved!
    Hope this helps.

Maybe you are looking for

  • Double click on a JTable row.

    I got and run a sample about double click on a JTable and it works fine. This sample defines a TableModel as shown at the end this note. On the other hand, I have an application in which I have defined a JTable using the DefaultTableModel as follows

  • Add text layer to all files in folder: what about files that already are searchable?

    Hi everyone I'd like to make my scanned PDF documents searchable using the OCR feature of Adobe Acrobat X Standard. The scanned PDF files are stored in one folder (or its subfolders respectively). In principle I could just go to the OCR feature, tell

  • Poor service response times

    My entire system has crashed, no tv, no telephone and no internet! The power supply for the fios equipment has failed, and I have to wait two days for a service call that will only take 5 minutes to fix! **bleep**! Thank God my commitment is over and

  • Sales order triggering???

    I have used some bapi function modules for sales order creation in a z program. But the clients requirement is that whenever a sales order is created ,then automatically an idoc needs to be generated and sent to the CRM server ( through ALE).       D

  • I can't hear the music on my IPOD 60Gig 5th generation and can not see my videos

    I can not hear the music, I can not see the videos on my IPOD 5th generation. I have restored it to the original settings and it still does not work.