How do I Resolve This Problem?
When I start up my Pavilion g6 it says "SMART Hard Disk Error" "The smart hard disk check has detected an imminent failure. To ensure not data loss, please backup the content immediately and run the hard disk test in system diagnostics." But when I Press Enter Key to Continue Startup, it takes me to a screen that says " Boot Device Not Found, Please install an operating system on your hard disk" I press f2 for system diagnostics, and press F4 for "Hard Disk Test" It says "Hard Disk Not Exist". How do I fix this?
Your hard drive has failed. All your data is almost certainly lost. You must replace your hard drive and re-install Windows.
Similar Messages
-
Color Nook can no longer access library . . How can I resolve this problem?
I have a Color Nook. Recently it was updated automatically. Since the update I can no longer enjoy reading the library books I once could. I used Overdrive and Adobe Digital Editions to access my county library in the past but can no longer access it.. I get an error message of E_AUTH_BAD_DEVICE_KEY. Apparently I have lost authorization to the AdobeID server.
How do I resolve this problem?Well, you could start by asking in the Digital Editions forum,
http://forums.adobe.com/community/adobe_digital_editions
This is the Reader one. -
My ipad is disabled and it says i need to connect to itunes when i connect it to itunes, it says it wont recognize it until i put my passcode into my ipad, but with my ipad disabled, this is immposible, how can i resolve this problem?
You may need to put the iPad into recovery mode : http://support.apple.com/kb/ht1808 - you should then be able to reset the iPad an resync your content to it
-
I receive the follwing error message when trying to open my ipod touch/itunes "the itunes libary.itlfile is lockedon a lockdisk or you do not have write permission on this file. How do I resolve this problem?
Repair iTunes Security Permissions
Right-click on your main iTunes folder and click Properties, then go to the Securitytab and click Advanced. Use the Change Permissions... button grant to your account (or the Users group) and SYSTEM full control of this folder, subfolders and files, then tick the option to Replace permissions entries... which will repair permissions throughout the library. When complete switch to the General tab, click in the Read-only check box to clear it, then click Apply.
If you don't have the option to change the permissions then use the Owner tab and Edit... button to take ownership from an account with administrator privileges. Tick the option to Replace owner on subcontainers and objects.
Repeat with the media folder if it isn't stored inside the main iTunes folder.
If you've brought over the library from another computer you may also want to remove any "mystery" identities (S<string of dashes & digts>) that have come over from the old computer...
The images above are from Windows 7. Hopefully the system isn't too different in Windows 8.
tt2 -
while updating iphone, itune gave me error of 1015 which tells that my iphone is much better than from which that i am updating. But now my iphone is still in restoring mode how i can resolve this problem.please tell me
I just had the same problem with my iphone, only thing i could do was completely restore factory settings, lost a bunch of pics and contacts in the process... hope you have better luck than me
-
hi i have downloaded fifa 13 from the itunes in my laptop to put it in the ipad 2 but when i come to sync it it says fifa 13 failed instillation the problem is that i paid money for that game so like how can i resolve this problem, i didnt buy it with my account my friend bought it and he sended it for me so i really dont know what to do cause i didnt have a visa card so he bought it , and i paid him
sami1958 wrote:
... i didnt buy it with my account my friend bought it and he sended it for me ...
The issue is that it is tied to your friends Apple ID and not yours...
Anything Downloaded with a Particular Apple ID is tied to that Apple ID and Cannot be Merged or Transferred to a Different Apple ID. -
There is a charge on my acct for a $107.00 for a game that i didn't buy, how do i resolve this problem?
change your password, and if you can, change the email associated with your account.
If you use gmail, you can insert a "." anywhere in your address to fake a different email account.
ex:
[email protected]
[email protected]
Whoever broke into your account obviously has/had the username and password to access it.
If you change your email account AND password, they have neither.
I made the mistake of changing only my password at first, then I got locked out of my account because they tried to access it again with the wrong (old) password. This won't happen if they don't even have the right user name (email). -
My Mac OS X 10.9.2 is unable to read any disc since I updated the operating system to Marverick a few months back. How can i resolve this problem because I need to retrieve very important information on my discs. Help! Thank you... paul
Paul,
Your problem has nothign to do with your installation of Mavericks. I assume you are referring to your SuperDrive not being able to read any discs, is that correct? If so then please advise what troubleshooting steps you have taken? -
i have downloaded adobe acrobat from adobe assistant and after the installation it is asking for serial number even though i opt for trial usage. how can i resolve this problem?
Maheedhararao if you are unable to install in trial mode then it is likely the trial period for that computer has expired. I would recommend evaluating the software on a different computer.
-
I used itunes11 to restore my iphone, causing an error 1015 did not restored, pls' tell me, how could i resolve this problem.
Errors related to third-party security software
Error 2, 4 (or -4), 6, 1000, 9006
Follow Troubleshooting security software. Often, uninstalling third-party security software will resolve these errors.
There may be third-party software that modifies your default packet size in Windows by inserting a TcpWindowSize entry into your registry. Your default packet size being set incorrectly can cause these errors. Contact the manufacturer of the software that installed the packet size modification for assistance or follow this article by Microsoft: How to reset Internet Protocol (TCP/IP).
Verify that access to ports 80 and 443 are allowed on your network.
Verify that communication to albert.apple.com or phobos.apple.com is not blocked by a firewall, or other Internet security setting.
Discard the .ipsw file, open iTunes and attempt to download the update again. See the steps underAdvanced Steps > Rename, move, or delete the iOS software file (.ipsw) below for file locations.
Restore your device while connected to a different network.
Restore using a different computer. -
How can I resolve this problem? The audio engine was not able to process all required data in time. (-10011)
Could you do this?
Go to Finder
Go to Applications
Go to Utilities folder
Launch Activity Monitor app
go to its Memory tab on top
tell us what you see at the very bottom?
Here is a sample of mine.
I bet your page/swap amount will be huge.
If there is not enough RAM, OS X temporarily stores RAM data on the harddrive and tries to retrieve it back into RAM when needed, unfortunately that is so slow that GB throws an error as it cannot play it all in real time. -
TS1424 I cannot buy songs on itunes. how do i resolve this problem?
I cannot buy songs on itunes. How do i resolve this problem?
Vague.
Why can you not buy songs?
What happens when you try?
Any info about your issue at all? -
windows explorer stopped working everytime i plug my iphone. how can i resolve this problem?
http://support.apple.com/kb/TS1538
-
I wanna ask about my iMessages, because everytime that I am using my apple ID it is always saying that my username and password was incorrect.But I am really sure that I have input the correct username as well as my password.How can I resolve this problem?
You can not merge accounts.
Apps are tied to the Apple ID used to download them, you can not transfer them. -
itunes wont allow me to sync even though i have already authorized my computer , how can i resolve this problem?
Vague.
What happens when you try?
Error message?
What does it say?
Any info about your issue? -
I downloaded the album the gap band greatest hits,but one song didnt play all the way through.the song was party train..i paid for the whole album,but didnt get what i paid for..how can i resolve this problem??
If your country's iTunes Store allows you to redownload purchased tracks, I'd delete your current copy of the track and try redownloading a fresh one. See the following document for instructions:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Otherwise, I'd report the problem to the iTunes Store.
Log in to the Store. Click on "Account" in your Quick Links. When you're in your Account information screen, go down to Purchase History and click "See all".
Find the item that is not playing properly. If you can't see "Report a Problem" next to the item, click the "Report a problem" button. Now click the "Report a Problem" link next to the item.
Maybe you are looking for
-
Af:tree with master-detail doesnt work
Hi, I created master-detail(used updateable VO's) and test it from the application module and everything worked as expected. Now I try to show all master and detail data in af:tree component. At the runtime I can see only master data, but there's no
-
Firefox crashes after windows update of Adobe REader XI (11.0.02)
I applied a windows 7 update some days ago and until now I haven't really used Firefox much. But now I started it up and it gave me a crash report. What to do? I tried re-installing it 2 times. Once with removing data and once with not removing data.
-
Erlang: wx graphical user interface does not work in R16B-1
After upgrading erlang to R16B-1, the wx GUI subsystem does not work anymore. 1> wx:demo(). ok =ERROR REPORT==== 5-Mar-2013::23:13:11 === ERROR: Could not find 'wxe_driver.so' in: /usr/lib/erlang/lib/wx-1.0/priv Should I install some additional packa
-
What procedure to call to reject the Import data load?
Hi All, When i am importing the data i have an after insert trigger which will validate the data going to be inserted.Now if the validation fails i need to reject the data load.Is there any way to do that means manually i want to throws or return som
-
JvmStatsManager taking up PermGen space
The following is taking up about 100MB of PermGen on our iPlanet (7.0.9) instance. Anyone know what this might be and if it can be disabled? (java.lang.OutOfMemoryError: PermGen space, PermGen space), stack: java.lang.OutOfMemoryError: PermGen space