How many 7920 phones can be supported on one Cisco 1131AG access point?

hi all,
who knows that how many 7920 phones can be supported on one 1131ag AP? Thanks a lot...

Hi Alomar,
Hopefully this info will help;
Number of 802.11b Phones per AP
Before any discussion about network planning can take place, it helps to understand the basics of the overall network capacity.
The following network capacity guidelines apply to sizing the Wireless IP Telephony network:
No more than 7 concurrent G.711 calls per AP.
No more than 8 concurrent G.729 calls per AP.
Note These design recommendations assume that Voice Activity Detection (VAD) has been disabled on the Cisco 7920 Wireless IP Phones. Use of VAD on the Cisco 7920 phones can conserve bandwidth, but Cisco recommends that you disable VAD on all Cisco CallManager servers to provide better overall voice quality.
In addition to determining how much bandwidth is needed for an 802.11b VoIP call, you must also consider overall radio contention for a particular RF channel. The general rule is that you should not deploy any more than 20 to 25 802.11b endpoints per AP. The more endpoints you add to an AP, the more you reduce the amount of overall bandwidth and potentially increase transmission delays.
The maximum number of phones per AP depends on the calling patterns of individual users (based on Erlang ratios). Cisco recommends no more than 7 concurrent calls using G.711 or 8 concurrent calls using G.729. Beyond that number of calls, when excessive background data is present, the voice quality of all calls becomes unacceptable.
From this doc;
http://www.cisco.com/en/US/products/hw/phones/ps379/products_implementation_design_guide_chapter09186a00802a0a05.html
Hope this helps!
Rob
Please remember to rate helpful posts.....

Similar Messages

  • How many airport express can be supported by software remote at one time.

    how many airport express can be supported by software remote at one time?
    I mean remote software can control at one time

    Well Apple makes an iOS application called 'Remote' it's used to control iTunes on a Mac, Or to control an Apple TV Multimedia features.
    Apple also makes "AirPort Utility" for iOS. Airport Utility can be used to configure Aiport Extrem, Airport Express And Time Capsul using an iPad, iPhone or iPod Touch. You can use it to connect to one device at a time. While connected to the device you can configure it to work as part of a larger Airport network. If you want to configure muliple device, you would connect to one device,  configure it,  And then connect to the next device, and configure it, and so on and so fourth.
    I haven't found a limit.
    How big of a network are you trying to make?

  • How many Iphone 5 can you open under one account ??

    Just a simple question , how many iphone 5 can you open under one account ? is it 5 or more ??? anyone know . I've been a verizon customer for a little bit over 5 months ..... any input ??? thank you

    I'd call Customer Service and ask, because the Share Everything plan is supposed to allow 10 lines:
    http://support.verizonwireless.com/clc/faqs/Calling%20Plans/share_everything.html

  • How many apple tv can I connect with one account?

    how many apple tv can I connect with one account?

    there are 2 recent posts that suggest issues over 5, one where someone was trying to troubleshoot for a friend or client as they couldn't keep more than 5 connected, and the other where somone had more than 5 but was using 2 separate itunes libraries to share the load - not sure if that was with the same or differing AppleIDs.
    I guess there is always the possibility that things kight vary from one itunes version to the next even unintentionally to allow more.
    AC

  • How many apple tvs can i use on one network from one apple account ?

    how many apple tvs can i use on one network from one apple account ?
    if i have 16 in each of my rooms connected to a network switch and a good fiber internet line
    will this work ok from my one account ? or would i neeed a mac book mini with raid storage set up ?
    any help would be very gratfully recived !
    james

    Welcome to the Apple Community.
    Homesharing allows up to 5 computers to be authorised and a total of 10 computers and devices to be associated with a single Apple ID.

  • How many icloud account can we create with one ios device???

    how many icloud account can we create with one ios device???

    i need more then 1 account as i owe itunes some money and i cant access my app store so if i change my icloud account .....all my previous history wont be tracked

  • How many licensed users can you have under one serial number for Adobe Photoshop Elements 9?

    I would like to know how many computers I can install my Adobe Photoshop Elements 9 on under one serial number?  Thank you!

    If you purchased the boxed product you can even install one on a PC and one on a Mac.

  • How many maximum records can be stored in One IDoc

    Hi experts!!
                       Please let me know what is the maximum capacity of an IDoc. i.e.,
    How many maximum records can be stored in an IDoc?
    ex: abc,9807,bangalore
          xyz,8976,mysore....... here two records are thr...if u have one lack records like this can we store all the records in one IDoc,....
    Thanks in advance,
    Sunil K Shetty

    Hi Sunil,
    Idoc structure is
    1. Control record,
    2. Data rord,
    3. Status record.
    1.Control record: contain only who is sender,who is receaver, /which type of data,Idoc number.
       IT store the all control records in one table: EDIDC
    2.Data Record: it contains the data records.(multiple records)
      It stores the data records sre stored in one table: EDIDD
    3.Status records: It show the stutus of the record. (It is multiple)
       The status records are stored in one table: EDIDS
    Rewords some points.
    Rgds,
    P.Naganjana Reddy

  • How many physical standbys can be created in one data guard environment?

    Hi Experts,
    How many physical standbys can be created from primary in one data guard environment? Why LOG_ARCHIVE_CONFIG limits up to 9 unique database names? Thanks.

    Victor Jin-Oracle wrote:
    Hi Experts,
    How many physical standbys can be created from primary in one data guard environment? Why LOG_ARCHIVE_CONFIG limits up to 9 unique database names? Thanks.
    Post the source of your information abouit the limit of 9 names.
    Even the Oracle doc shows 1..30 names in the same provided although that doesn't necessarily indicate a limit.
    https://docs.oracle.com/database/121/REFRN/refrn10237.htm

  • How many command line can 7507 support

    hi
    i have a problem
    if i wnat to setup static lu point to ip address
    i will need two line to define
    but in my cx site have more than one thousand pc
    so i need to define
    client ip x.x.x.x lu 2
    client printer ip x.x.x.x 3
    plus 1000 pc
    it will exceed two thousand command line
    how many capacity does 7507 have
    tks

    Hi,
    i found this in the CCO:
    Handling Large Configurations
    The largest size nonvolatile random-access memory (NVRAM) planned for the Cisco 7500 series routers is 128 KB. The maximum number of nailing commands that can be stored in a 128 KB NVRAM is approximately 4000. However, large configurations may map as many as 10,000 IP addresses to LUs.
    To maintain a configuration file that exceeds 128 KB there are two alternatives. The configuration file can be stored compressed in NVRAM. Or, the configuration file can be stored in Flash memory that is either internal Flash or on a PCMCIA card.
    look at this Link:
    http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/bclunail.htm
    cu thomas

  • How many Apple TVs can you have on one iTunes account?

    Just wondering how many Apple Tvs I can put on my iTunes account.  Already have one in the living room and I was looking to put one more in the bedroom.

    That would be fine.

  • How many apple TVs can you have on one network 5, 10, 15, infinite?

    I have an application where there are many rooms and I would like to be able to use Airplay in each room, can I buy 10 or more Apple TV units and put them all over my house on my wireless network and be able to airplay to any one of them? What is the limit of Apple TVs that I can have in one area. Has anyone tried this? How many have you maxed out at? What is the limitation?

    There is no specified limitation but you will encounter a practical one. It will be a function of the numerous and generally unpredictable variables that affect any wireless network.
    Ten Apple TVs is certainly within the realm of possibility though. This post reports success with fifteen of them.

  • How many hard drives can i stream from one mac for apple tv

    Hi a newbie to all this ive got a 500gb external hd and running out of space but am looking to buy a 1tb but i want to set it up as im using both hard drives so i get 1.5tb as this is a cheaper option for me is this possible and how
    many thanks for your time

    You need to turn off the option to copy content to the iTunes folder in iTunes preferences, then when you add new content to iTunes you will need to place the content on one of the HDDs and then drag and drop it onto iTunes from a finder window.
    Or you can alternatively leave the "Copy" option on and simply press the Alt-key when dragging and dropping content to momentarily suspend the "Copy" of the dragged content to the library. (I.e., iTunes will gladly manage both copied and non-copied content as long as you do not move or delete the non-copied files at the Finder level after adding them to the iTunes database.)

  • How many external monitors can I support with 13" rMBP (late 2012)?

    Device has two DisplayPorts and each is powering an external display properly. It also has an HDMI port. Can I connect a third monitor here?

    I got my new 13" Retina in the other day (late 2013 model ME865LL/A)
    I was all excited to see if the two Thunderbolt 2 outputs and the HDMI output would work together, but plugging in the HDMI output knocked out one of the Thunderbolt outputs, so what I read was right, the 13" model will only power two external monitors.  Before I got this I kept reading over and over how it wasn't possible, but that was dealing with the Late '12 or the Early '13 models, I was hoping that the upgraded video card on the newest Haswell versions may be different, but alas, not to be.... 
    But I did implement a work around as I have a Matrox Triple Head 2 Go DP Edition for my old Macbook and what that does is make my two Lenovo 22" widescreens look like one big 3840x1200 monitor to it's host (tricking the MB to thinking "hey, this is one monitor"), so this allows me to use one Thunderbolt output to power these two monitors and then I am using an HDMI --> DVI cable to power an HP 23" widescreen monitor I also have running at full resolution, all this in addition to the Laptop display as well:
    Here is a quick 20 second video of all monitors playing video....   the one on the left in the middle row was staggering but that is more a problem with AMC's website more than anything, I never get good stream speeds from their site
    https://www.youtube.com/watch?v=OfIsupl3psc
    I just installed iStat 4 an hour ago and am showing CPU temps around 150 degrees, not really sure what "normal" is or what is acceptable......  I'm going to keep tabs on what the temps are as I finish up my workday here (another 6 hours to go)
    I still want to re-arrangle things so i only have two levels of screens to deal with, but still formulating that setup with my desk

  • How many concurrent requests can WAS support?

    Hi all,
      I want to know what is the maximum number of concurrent users/requests that can WAS6.4(latest pack) support? We are looking at around 40,000 concurrent users.. Is this feasible? If yes what is the max possible?
    Regards,
    Harsh
    PS: Would appreciate a prompt response:)

    Hi Harsh,
    I was just reading those notes that Alexander found as well and I would have to agree with him the that webdispatcher could handle the 10,000. However you have to remember that if you are running a BSP or other application located on a WAS server you have the constraints there as well.
    Now I've just done some load testing with some stress tools.
    500 concurrent connections on a Linux server dual processor 4 GB RAM and I started to see some major performance problems. Any higher and the system or at least the apps would have started to hang I think.
    So with 40,000 connections even with loadbalancing and application instances you are going to need some major hadware to handle the connections.
    Now back to your other questions.
    The WAS and the R/3 are built on the BC level, which means  the basic connections are made at that level and effected by these parameters. With a 640 Java Stack only then you have the J2EE engine only in which case the BC level is basically not there at least not like the ABAP level.
    Now if you have a single JSP page deployed on your J2EE and not making any RFC calls to your backend then you only have to worry about the dispatcher connections. However, from my understanding if you make those RFC calls then you have the connections of the backend to worry about as well.
    Now if you can gives a bit more detail of what the connections (all these 40,000 are doing) then perhaps we can come up with some alternatives that will help out.
    As for being intimidated, don't be, I'm learning this from searching as we go along as well

Maybe you are looking for

  • Playing recorded internet streams

    I found out that I can't stream live streaming content through my Mac to the Apple TV, so I have recorded some things I like using Irecordmusic into iTunes. They show up in my library and synch to an iPod easily, but they do NOT show up on AppleTV's

  • Warning upon transfer of quotation from external catalog to SRM

    Hello, We have implemented a punch-out catalog integration between our catalog and the client's SRM solution. However, we are facing an issue at the last stage of the integration - Upon transfer of the items from our catalog, SAP throws a warning mes

  • No instances can be created from abstract classes

    Dear SAPGurus, I have developed a oData Service in my backend system & able to register the service in the gateway hub system. When i try to execute the metadata of the service from gateway system i am able to see the metadata with list of entity typ

  • Web Module

    Would it be possible to include in the background options the ability to attach a user gernerated backgorund not just the current color options? I am using LR 3 to generate photo albums but in order for me to include my site's background on the LR3 g

  • Help needed to link up buttons on HUD Window to Applescript

    Hi I have very limited experience of XCode, though I did build a very simple application some time ago that appended text to the Comments field of the currently playing track in iTunes using Applescript. The design of this app was basically just a se