HT4623 how to enable my ipad?

My daughter was playing with my ipad and how it say" ipad is disabled" connect to Itunes. When I connect to Itunes nothing happens.

iOS: Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
Using iPhone/iPad Recovery Mode
http://ipod.about.com/od/iphonetroubleshooting/a/Iphone-Recovery-Mode.htm
 Cheers, Tom

Similar Messages

How to enable my ipad air coz of wrong password and Findmy ipad air is on

How to enable my ipad air because of wrong password and i cannot recover or restore my device coz Find my ipad setting in my device is on. Itunes said this must be off before anything, but i cannot turn it off in setting because device is disable. Help me

Try DFU mode:
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
   1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
       other end of the cable connected to your computer's USB port.
   2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
       until the red slider appears, then slide the slider. Wait for the device to turn off.
              * If you cannot turn off the device using the slider, press and hold the
                Sleep/Wake and Home buttons at the same time. When the device turns off,
                release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
       device. The device should turn on. Note: If you see the battery charge warning,
       let the device charge for at least ten minutes to ensure that the battery has some
       charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
       When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

How to enable my Ipad after it has been dissable by too many wrong attempts to enter passcode?

How to enable my Ipad after it has been dissable by too many wrong attempts to enter passcode?

You have to restore the iPad in order to unlock it using these instructions.
http://support.apple.com/kb/HT1212?viewlocale=en_US&locale=en_US

How to enable my ipad air..

how to enable ipad air...??can somebody help me..

iPad disabled?
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.

How to enable my IPad.

My Ipad mini is disabled due to too many failed attempts to log on with new pw....I wen to Itunes site as it instructed but it says that I have to enter my pw into the device, but it wont let me add the password because it is disbled. How can I enable my Ipad? Thank you.

FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.

How to enable back ipad if on disabled mode?

Anybody can help me on this , I forget my passcode. How to enable back my Ipad?

If you've never synced then you won't have a backup on your computer and you will therefore lose all your content from the iPad. You need to connect your iPad to your computer's iTunes - see this page for a locked iPad : http://support.apple.com/kb/HT1212 . You may need to put the iPad into recovery mode first : http://support.apple.com/kb/ht1808

HT4623 How do I update iPad version 4.0? To version 6 or whatever is higher?

How do I update iPad version 4 to the latest software.

If you have an iPad 1, the max iOS is 5.1.1. For newer iPads, the current iOS is 6.1.3. The Settings>General>Software Update only appears if you have iOS 5.0 or higher currently installed.
iOS 5: Updating your device to iOS 5 or Later
http://support.apple.com/kb/HT4972
How to install iOS 6
http://www.macworld.com/article/2010061/hands-on-with-ios-6-installation.html
iOS: How to update your iPhone, iPad, or iPod touch
http://support.apple.com/kb/HT4623
If you are currently running an iOS lower than 5.0, connect the iPad to the computer, open iTunes. Then select the iPad under the Devices heading on the left, click on the Summary tab and then click on Check for Update.
Tip - If connected to your computer, you may need to disable your firewall and anitvirus software temporarily. Then download and install the iOS update. Be sure and backup your iPad before the iOS update. After you update an iPad (except iPad 1) to iOS 6.x, the next update can be installed via wifi (i.e., not connected to your computer).
Tip 2 - If you're updating via wifi, place your iPad close to your router to preclude getting a corrupted download.
 Cheers, Tom

HT4061 how to enabled my ipad

Please help me to enabled my ipad as i can not do it with itunes.

What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Update and restore alert messages on iPhone, iPad, and iPod touch
http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
 Cheers, Tom

HT4623 How do I sync iPad 2 to my computer..devise is not recognized in iTunes but it does charge when I connect it?

How do I sync iPad 2 to my computer..devise is not recognized in iTunes but it does charge when I connect it?

Mac or PC - each has its own details. Also, follow the links in the right panel under More Like This. You'll find other threads that discuss this problem.

HT4623 How to register my iPad?

How to register my ipad?

Hey Me t,
Thanks for the question. You may find the following information helpful:
Do I need to register my Apple product?
http://support.apple.com/kb/HT5803
Registering Apple products is not required for service and support. Service and support for your Apple product are linked to its serial number, which can be located on the device. If you'd like to check the service and support coverage for your Apple mobile device or computer, visit our Check Your Service and Support Coverage page.
Note: If you have purchased an AppleCare Protection Plan, but the plan has not been enrolled yet, you should register it here.
Thanks,
Matt M.

HT4623 How to update my iPad to iso 6?

How to update my iPad to iso6 ?

If yours is an iPad 1... then iOS 5.1.1 is as far as it will go.
If a later Model of iPad... you can only update to the Current Version which is iOS 7.1
March 2014

HT4623 how to unlock my ipad forgot my password

how to unlock my ipad/forgot my password

Follow the instructions here > iOS: Forgotten passcode or device disabled after entering wrong passcode

HT204053 How to enable my Ipad

how to enable my Ipad

Does it say it is disabled?
Forgotten Passcode or device disabled after entering wrong passcode

HT4623 How do you update iPad iOS under Settings/General/Software if you don't have a software button option?

How do you update iPad iOS under Settings/General/Software if the Software button is non-existent?

You do not have iOS 5 on your iPad so you have to update by using a computer via the latest version of iTunes. You can connect the iPad to your computer and launch iTunes. Select the iPad on the left side under the devices heading. Click on the Summary Tab on the right. Click on Check for Update.
After you update to iOS 5 or later, you will have Software Update in you settings and can update via WiFi OTA. If you have the original iPad - you can only upgrade to iOS 5.1.1.
How to update to iOS 5 or later.
http://support.apple.com/kb/HT4972

HT4623 How do update my ipad 2 if my OS is prior to 5.0, it does not have the software update dropdown.

How do I update my ipad 2 if my OS is prior to 5.0, it does not have the software dropdown

If you have an iPad 1, the max iOS is 5.1.1. For newer iPads, the current iOS is 7.0.4. The Settings>General>Software Update only appears if you have iOS 5.0 or higher currently installed.
iOS 5: Updating your device to iOS 5 or Later
http://support.apple.com/kb/HT4972
How to install iOS 6
http://www.macworld.com/article/2010061/hands-on-with-ios-6-installation.html
iOS: How to update your iPhone, iPad, or iPod touch
http://support.apple.com/kb/HT4623
If you are currently running an iOS lower than 5.0, connect the iPad to the computer, open iTunes. Then select the iPad under the Devices heading on the left, click on the Summary tab and then click on Check for Update.
Tip - If connected to your computer, you may need to disable your firewall and anitvirus software temporarily. Then download and install the iOS update. Be sure and backup your iPad before the iOS update. After you update an iPad (except iPad 1) to iOS 6.x, the next update can be installed via wifi (i.e., not connected to your computer).
Tip 2 - If you're updating via wifi, place your iPad close to your router to preclude getting a corrupted download.
How to Upgrade to iOS 7
The iOS 7.0 update requires around 2.5 GB of storage space, so if your iPad is almost full, you may need to clear up some space. You can check your available space in Settings -> General -> Usage.
There are two ways to upgrade to iOS 7: You can use your Wi-Fi connection, or you can connect your iPad to your PC and update through iTunes. We'll go over each method.
To upgrade using Wi-Fi:
Note: If your iPad's battery is under 50%, you will want to plug it into your charger while performing the update.
    1.    Go into the iPad's Settings.
    2.    Locate and tap "General" from the menu on the left.
    3.    The second option from the top is "Software Update". Tap this to move into the update settings.
    4.    Tap "Download and Install". This will start the upgrade, which will take several minutes and will reboot your iPad during the process. If the Download and Install button is grayed out, trying clearing up some space. The space required by the update is mostly temporary, so you should gain most of it back after iOS 7 is installed.
    5.    Once the update is installed, you may have to run through the initial steps of setting up your iPad again. This is to account for new features and settings.
To upgrade using iTunes:
First, connect your iPad to your PC or Mac using the cable provided when you purchased your device. This will allow iTunes to communicate with your iPad.
You will also need the latest version of iTunes. Don't worry, you will be prompted to download the latest version when you launch iTunes. Once it installs, you may be asked to setup iCloud by logging into your iTunes account. If you have a Mac, you may be prompted on whether or not you want to enable the Find my Mac feature.
Now you are ready to begin the process:
    1.    If you upgraded iTunes earlier, go ahead and launch it. (For many, it will launch automatically when you plug in your iPad.)
    2.    Once iTunes is launched, it should automatically detect that a new version of the operating system exists and prompt you to upgrade to it. Choose Cancel. Before updating, you will want to manually sync your iPad to make sure everything is up to date.
    3.    After canceling the dialog box, iTunes should automatically sync with your iPad.
    4.    If iTunes doesn't automatically sync, you can manually do it by selecting your iPad within iTunes, clicking on the File menu and choosing Sync iPad from the list.
    5.    After your iPad has been synced to iTunes, select your iPad within iTunes. You can find it on the left side menu under Devices.
    6.    From the iPad screen, click on the Update button.
    7.    After verifying that you want to update your iPad, the process will begin. It takes a few minutes to update the operating system during which time your iPad may reboot a few times.
    8.    After updating, you may be asked a few questions when your device finally boots back up. This is to account for new settings and features.
 Cheers, Tom

HT4623 how to enable my ipad?

Similar Messages

Maybe you are looking for