HT5470 I can't get the radio to work on my Ipod Nano 7.

I can't get the radio to work on Ipod nano 7. When I go to the radio screen the following happens 1) the radio screen appears in the backgound with a small rotating icon at its center for few seconds, 2) the screen go blank and small apple icon appears at the center of the blank screen for few seconds, and 3) the home screen reappears. Any suggestions?

Thanks for the reply. It turns out my ipod nano was defective. For some reason it rebooted every time the radio button was pressed. I tried a software restore and that failed. Since the unit was just a few days old I was able to exchange it at the retailer. The FM radio on the new unit works great.

Similar Messages

TS3474 How do I get the radio to work on my iPod nano 6th gen?

I have synched my Nano & have music...I have plugged in the earphones, but nothing happens with the radio. I've read the support article about the FM radio, but I don't have any of the radio controls shown in the article--all I have is the radio icon and the Now Playing icon, and when I tap the Now Playing icon, it shows what music is playing, not radio controls. Help!

As mentioned above, the reason is that the FM radio uses the headphone cable as an aerial, so the phone insists on it being connected. It's the same with other Nokias. Apparently there are complicated technical reasons why the FM radio can't use the same antenna as the phone signal.

I lost my iTunes library on my pc when the hard drive crashed. None of the data on the drive was recoverable and I did not have a backup. How can I get the music that resides on my ipod nano (4th generation back onto the new hard drive on my pc.

I lost my iTunes library on my pc when the hard drive crashed. None of the data on the drive was recoverable and I did not have a backup either locally or on the cloud. Much of the music is from old vinyl and podcasts which are no longer available.
How can I get the music that resides on my ipod nano (4th generation) back onto the new hard drive on my pc.
I have been reluctant to install iTunes on the new hard drive out of fear that I will lose all the contents on the ipod if I try to synch to the new hard drive.
Help!

No backup is a huge mistake.
You can redownload some itunes purchases in some countries:
Downloading past purchases from the App Store ... - Apple - Support

I can't get the volume to work on my ipod. works only with the headset in. Thanks

Hello I can't get the volume to work on my ipod touch. Only works witht the headset. Thanks

Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar

How can i get the SSO to work successfully?

How can i get the SSO to work successfully? I followed the note for configuring infoview with ad sso using kerveros & .net.
Adding the AD group into the win ad authentication configuration page creates the user group but the members of the group aren't being pulled in when I go to the group and select / query the users tab

Bart,
By default the setting for update options on the Windows AD tab of authentication does not actually create the aliases until the user attempts to login the first time. We set it this way to prevent a huge group of alias's being created when the administrator sets up Windows AD and also so that only user aliases for users actually using the system get created. You can change this behaviour though if you like. Simply change the radio button option to 'New Aliases will be added and new users will be created' this will create the accounts for you when you hit the update button. If you have a large group your adding I would wait until and afterhours time when you have less activity as this will impact CMS performance while it creates all the accounts.

I can't get the volume to work when I watch a you tube video, there's no volume slide under the play button, and my volume control on my I pad won't do anything either, but the volume of all my alarms and sounds works perfect, what can I do??

I can't get the volume to work when I watch a you tube video, there's no volume slide under the play button and my volume control on my I pad don't do anything to help, but yet my volume works perfect on everything else, what can I do???

do u have your ipad doing airplay because that could happen

Can't get the software to work with Audigy 2

Hi, I have had my Audigy 2 ZS going on a year now and haven't had any problems. I recently made a clean install of Windows XP and upgraded to SP2 and all that. Now, I can get sound out of the card but can't get the software to work at all; cannot get the volume slider bar to appear when I click the icon (it appears in the task bar though and I get a small gray square where the slider should appear), the surround mixer does not show when I double click the volume icon, EAX conxole is a no go, get an empty error box when I try to start the Equaliser.
I have tried everything from simple re-install to clean sweep to praying to the pagan gods. I have alsoo tried updating the drivers of course.
I run XP on an Intel MoBo (on-boeard sound deactivated), 52RAM, ATI 9700 ALL-IN-WONDER.
DOES THE CREATIVE SOFTWARE DEPEND ON ANY WEIRD LITTLE WINDOWS SERVICE OR SETTING THAT I MIGHT HAVE CHANGED DURING SETUP?
This is quite infuriating as any idea I come up with takes up a lot of time in installation, uninstallation and clean up. It worked before, why not now?
Thanks in advance. dentore

Ok I got it to work. This is the reply I got from Creative but I didn't remove the program from the add/remove option on the PC b/c that didn't work at first. I inserted the installation CD and remove it from that wizard. Rebooted and the PC found new hardware. I then installed the driver and software from the CD and now it works.
For Mediasource. It appears something was corrupted in Mediasource or there is a conflict within the system.Please uninstall all software and drivers for the soundcard, from add/remove programs. Once this is done, shut down the system and changePCI slots for the soundcard, then turn the system back on, cancel the found new hardware wizard, disable all background applications (especially virus scanner, firewall, and any other background applications running in the bottom right hand corner of the system), andthen perform a full reinstallation of the drivers and software from the soundcard installation cd.
CAT I hope you fix your sound card. Good luck.

I have just got a iPhone 4s and I can't get the iCloud to work, everytime I turn ato downloads it defaults back to off, can anyone help?

I have just got a iPhone 4s and I can't get the iCloud to work, everytime I turn on auto downloads it defaults back to off, can anyone help?

Welcome to the Apple Community.
Check you are logged into your store account properly (settings > store). Also check there are no restrictions set that might be causing this (settings > general > restrictions)

How do you get the radio to work ?? - says no radio signal but headphones are plugged in ??

How do you get the radio to work? Is another app or download required? Its a new Ipod nano - 8G, box doesn't say anything about "generation" ?? Appreciate any help
cr8tivsolutions

ok, I see now the plug has to be pushed in really tight until the white is flush with the nano

How can i get the music i have on my ipod over to the new computer?

how can i get the music i have on my ipod over to the new computer?
The old computer has crashed and i can't get it out from that one.
So the problem is that i want my old music on my new computer.
Someone please help.

Sven,
The article linked below details how to go about transferring your purchased content from your iPod to your new computer.
Re-download or transfer your iTunes Store purchases from an iPhone, iPad or iPod to a computer
https://support.apple.com/en-us/HT201267
All my best,
Allen

I have just won an iphone 3gs in a raffle but when i put in my sim it tells me that it is not supported how can i get the iphone to work

I have just won an iphone 3gs in a raffle but when i put in my sim it tells me that it is not supported how can i get the iphone to work?

In that case the procedure assuming it is a PAYG phone is to get an o2 PAYG sim, put £20 on it and then make a few calls making sure you leave £15 on the sim to pay for the unlock. Then there is an online unlock request form on the o2 site just fill this in. It takes between 1-14 days and you get a message from o2 telling you how to complete the official unlock through iTunes.
I got my o2 unlock in nov 09 so this is not just opinion.

How can i get the speakers to work properly? they have a lot of static and scratchiness from them

how can i get the speakers to work properly, they have a lot of static and scratchiness coming from them?

I found my answer in this thread:
https://discussions.apple.com/message/16646999#16646999

After update to OS4.2.1 I can not get the ringer to work for incoming calls

after update to OS4.2.1 I can not get the ringer to work for incoming calls. If I set Vibrate on, that's the only notification I get. Tried everything including blowing away ALL my apps and restoring phone to new. Lost all my apps but the ringer still won't ring

God Bless u! LOL I have an otterbox case on my phone and had no clue that the mute button was there....Thank you so much!! The volume on my movies & everything else worked...even when I would go into "settings" and adjust the volume of the ringtone. I knew it was something simple...Thanks again..

Satellite A210-11P - can't get the Camera to work

Hey
i have the Satellite A210-11P and i just can't get the Camera to work on it,
it will yurn on for two seconds and then shut itself off and 'No Preview' Appears.
Any help on this would be greatly appreciated.
Kris

Hi,
Have you tried you to reinstall/update it? Download camera assistant from [Toshiba driver page|http://eu.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp] Remove the previous one and restart the laptop. Then, install downloaded one

HT4623 iPad 3 how can l gets the SIM card works With iPad 3

As all we know its christmas time l just received the gift for iPad 3 & l notice that it need SIM card for me to use as the phone & data,how can l gets the SIM card works With iPad 3

Remember am in South Africa & we got few carrier nets am in MTN provide & I c my sim looks so big to fit on my iPad

HT5470 I can't get the radio to work on my Ipod Nano 7.

Similar Messages

Maybe you are looking for