HT6114 I installed Mavericks and now safari wont work.  Help!

I gleefully installed Mavericks thinking I was doing the right thing.  After an hour of figuring out that I had internet connectivity but Safari wasnt working I spent several more hours trying to figure out what to do .  I did not back up the system before I upgraded (brillinat decision on my part) but now I am stuck.  Do I just use Firefox or chrome which dont seeem to have problems and wait until Apple comes out with a fix or???? I thought getting an Apple was supposed to avoid this kind of issue.

Please read this whole message before doing anything.
This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, by a peripheral device, by a font conflict, or by corruption of the file system or of certain system caches.
Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards, if applicable. Start up in safe mode and log in to the account with the problem. You must hold down the shift key twice: once when you turn on the computer, and again when you log in.
Note: If FileVault is enabled, or if a firmware password is set, or if the startup volume is a Fusion Drive or a software RAID, you can’t do this. Ask for further instructions.
Safe mode is much slower to start up and run than normal, with limited graphics performance, and some things won’t work at all, including sound output and Wi-Fi on certain models. The next normal startup may also be somewhat slow.
The login screen appears even if you usually login automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin.
Test while in safe mode. Same problem?
After testing, restart as usual (not in safe mode) and verify that you still have the problem. Post the results of the test.

Similar Messages

  • Installed Maverick and now iPhoto wont open, help

    I've just installed Maverick from using Snow Leopard and now iPhoto won't open and the message"You can’t open the application “iPhoto” because it is not supported on this type of Mac." appears. Since I have hundreds of photos in iPhoto and iPhoto was supported on this mac previously how can I access them?

    Since my last post I found some instructions courtesy of Old Toad.   They might work for you.
    Launch iPhoto with the Command+Option keys held down and rebuild the library if the photos are missing.
    Run Option #4, Rebuild Database, followed by Option #1 if needed.

  • I connected my ipod before installing softwear and now it wont work

    i connected my ipod before installing softwear and now it wont work...like abosolutely nothing...its frozen

    First of all, try resetting the iPod. It may take several attempts and is best done connected power.
    Then download the iPod Updater, install this to your computer, restart the computer, run the Updater, then connect your iPod when prompted (not before), then follow the set up procedure.

  • The new itunes update will not install properly and now itunes wont work at all

    k, so I tried installing the new update for itunes and now it wont work at all. it says that the mobile device isnt installed. i have uninstalled and reinstalled itunes 4 times now.

    My issue is it wont even reinstall onto my computer
    Yes I'm aware of that. The procedures are also for trying in cases where iTunes can't be reinstalled due to a "Could not start Apple Mobile Device service" message.
    If you're getting a different error message relating to the Apple Mobile Device Service (or Apple Mobile Device Support) when you try to reinstall iTunes, post back to let us know what that error message says. (Precise text, please.)

  • Installed tiger and now safari wont open...

    Ithats pretty much it except I installed Tiger on my emac and everything is fine
    Any advice?
    thanks
    Reg

    Hi Gerard,
    Can you describe exactly what happens when you try to launch Safari? Please remember we only know as much as you tell us

  • Just updated to mavericks and now iphoto wont work. wont let me update as has previous owners appleid in command field and wont let me change

    can anyone help? bought my macbook pro second hand and when i try to update iphoto so that it works in Mavericks it has the previous owners appleid locked in the id field and wont let me change so i cant update. i have logged into my account but makes no difference....????

    A very good post by Linc Davis.
    Linc Davis
    Re: I bought a used MacBook Pro (mid 2010).  How do I change settings so that I am the owner instead of "tourist"? 
    Feb 16, 2014 11:56 AM (in response to Dee SeaWarrior)
    The first thing to do with a second-hand computer is to erase the internal drive and install a clean copy of OS X. You — not the previous owner — must do that. How you do it depends on the model, and on whether you already own another Mac. If you're not sure of the model, enter theserial number on this page. Then find the model on this page to see what OS version was originally installed.
    1. You don't own another Mac.
    If the machine shipped with OS X 10.4 or 10.5, you need a boxed and shrink-wrapped retail Snow Leopard (OS X 10.6) installation disc from the Apple Store or a reputable reseller — not from eBay or anything of the kind. If the machine has less than 1 GB of memory, you'll need to add more in order to install 10.6. Preferably, install as much memory as it can take, according to thetechnical specifications.
    If the machine shipped with OS X 10.6, you need the installation media that came with it: gray installation discs, or a USB flash drive for some MacBook Air models. For early MBA models, you may need a USB optical drive or Remote Disc. You should have received the media from the previous owner, but if you didn't, order replacements from Apple. A retail disc, or the gray discs from another model, will not work.
    To boot from an optical disc or a flash drive, insert it, then reboot and hold down the C key at the startup chime. Release the key when you see the gray Apple logo on the screen.
    If the machine shipped with OS X 10.7 or later, you don't need media. It should boot into Internet Recovery mode when you hold down the key combination option-command-R at the startup chime. Release the keys when you see a spinning globe.
    2. You do own another Mac.
    If you already own another Mac that was upgraded in the App Store to the version of OS X that you want to install, and if the new Mac is compatible with it, then you can install it. Use Recovery Disk Assistant to create a bootable USB device and boot the new Mac from it by holding down the Ckey at the startup chime. Alternatively, if you have a Time Machine backup of OS X 10.7.3 or later on an external hard drive (not a Time Capsule or other network device), you can boot from that by holding down the option key and selecting it from the row of icons that appears. Note that if your other Mac was never upgraded in the App Store, you can't use this method.
    Once booted in Recovery, launch Disk Utility and select the icon of the internal drive — not any of the volume icons nested beneath it. In the Partition tab, select the default options: a GUID partition table with one data volume in Mac OS Extended (Journaled) format. This operation will permanently remove all existing data on the drive.
    After partitioning, quit Disk Utility and run the OS X Installer. You will need the Apple ID and password that you used to upgrade. When the installation is done, the system will automatically reboot into the Setup Assistant, which will prompt you to transfer the data from another Mac, its backups, or from a Windows computer. If you have any data to transfer, this is usually the best time to do it.
    Then run Software Update and install all available system updates from Apple. To upgrade to a major version of OS X newer than 10.6, get it from the Mac App Store. Note that you can't keep an upgraded version that was installed by the previous owner. He or she can't legally transfer it to you, and without the Apple ID you won't be able to update it in Software Update or reinstall, if that becomes necessary. The same goes for any App Store products that the previous owner installed — you have to repurchase them.
    If the previous owner "accepted" the bundled iLife applications (iPhoto, iMovie, and Garage Band) in the App Store so that he or she could update them, then they're linked to that Apple ID and you won't be able to download them without buying them. Reportedly, Mac App Store Customer Service has sometimes issued redemption codes for these apps to second owners who asked.
    If the previous owner didn't deauthorize the computer in the iTunes Store under his Apple ID, you wont be able to  authorize it immediately under your ID. In that case, you'll either have to wait up to 90 days or contact iTunes Support.

  • I've just installed Maverick and now can't open iPhoto. I have 9.2.1 currently installed. Am terrified I'm going to lose photos as they weren't all backed up. What do I do? Please help...

    I've just installed Maverick and now can't open iphoto. I have 9.2.1 currently installed. Please help - am terrified I've lost my photos as they weren't all backed up.

    Pogs78,
    first things first — buy an external drive to use as a Time Machine backup destination and make a back up. That way, you won’t lose anything which is currently on your MacBook Pro.

  • I recently installed Maverick and now my Mac is running very slow

    i recently installed Maverick and now i am running very slow.

    Please download, install and run Etrecheck.
    Etrecheck was developed as a simple Mac diagnostic tool by a regular Apple Support forum user and contributor named Etresoft.
    Etrecheck is a small, unobstrusive app that compiles a snapshot of your entire Mac hardware system and installed software.
    http://www.etresoft.com/etrecheck
    Copy/paste and post its report here in another reply thread so that we have a complete profile of your Mac's hardware and installed software so we can all help with your Mac performance issues.

  • Install Maverick and now When I turn off my mac air, takes 2 minutes. Why? As I can solve?

    Install Maverick and now When I turn off my mac air, takes 2 minutes. Why? As I can solve?

    Hi Linda,
    Unplugging it from AC power will drain the PRAM Battery in short order, thereby losing setting, like Monitor resolution.
    You can test the Pram Battery by disconnecting from the Internet so Date/Time doesn't update before you see it, shutdown, unplug AC for a bit, startup & check Time.
    In Sys Pefs>Displays, can you set the resolution?

  • G'day Matt Vass from AUS.  I just installed mavericks and now garage band won't start due to BFD folder invalid,

    Hi there, hoping for help pls. I just installed mavericks and now garageband old version won't start because the BFD folder is invalid.

    Click Software Update from your Apple menu  drop down menu.
    If there's nothing available from Software Update, you may need to purchaase the newest GB version 10.0.2 from the App Store.

  • I installed Mavericks and now I can't print to my brother HL-2040 through the network

    I installed Mavericks and now I can't print to my brother HL-2040 through the network, it does not see the printer

    Here's the link to that article:
    http://support.apple.com/kb/PH11143
    However it has not been updated to refelct if it works with Mavericks

  • I tried to install maverick and now my keyboard keys F10,F11, 7,8,9 on the number pad don't work on my iMac. How do I resolve this?

    I tried to install maverick and now my keyboard keys F10,F11, 7,8,9 on the number pad don't work on my iMac. How do I resolve this?

    It sounds like you may have multiple problems, but none of them are likely to be caused by malware.
    First, the internet-related issues may be related to adware or a network compromise. I tend to lean more towards the latter, based on your description of the problem. See:
    http://www.adwaremedic.com/kb/baddns.php
    http://www.adwaremedic.com/kb/hackedrouter.php
    If investigation shows that this is not a network-specific issue, then it's probably adware. See my Adware Removal Guide for help finding and removing it. Note that you mention AdBlock as if it should have prevented this, but it's important to understand that ad blockers do not protect you against adware in any way. Neither would any kind of anti-virus software, which often doesn't detect adware.
    As for the other issues, it sounds like you've got some serious corruption. I would be inclined to say it sounds like a failing drive, except it sounds like you just got it replaced. How did you get all your files back after the new drive was installed?
    (Fair disclosure: I may receive compensation from links to my sites, TheSafeMac.com and AdwareMedic.com, in the form of buttons allowing for donations. Donations are not required to use my site or software.)

  • I updated my iphone to the ios6 and now it wont work.

    i updated my iphone to the ios6... and now it wont work at all.
    it wont even turn on, it keeps going back and forth between the black screen and then the apple mark pops up for a few seconds, and then turns back to the black screen again... and that just keeps going on...
    someone please help...

    Seems like ios6 isn't any good for any of their devices. I have an iPhone 4 and recently updated to ios6 and have had all the wifi problems and apps getting hung up on load screens. Restore is your best bet and downgrade if you can back to ios 5.1. If restore doesn't help with a fresh install of ios6 then call every Apple support number you can find and be heard like the 1,000s of other people like us with ios6 problems demanding support. There doesn't seem to be any quick fixes for ios6 other than an update from Apple.
    <Edited By Host>

  • I accdently formated my shuffle and now it wont work what do i do?

    I accdently formated my shuffle and now it wont work what do i do?
    That and when I plug the shuffle in to the comp iTunes doesn't reconize that the shuffle is pluged in.
    it has updated a-few times. and when iTunes sees that the shuffle is in the comp it tells me that the songs are on the shuffle.............but when i unplug it and put my headphones in no music comes out of it!
    so what am i to do
    shuffle 512MB Windows XP

    I'm having the same problem! My good-for-nothing brother has formatted iPod shuffle through "My Computer" and now it won't work. Neither iTunes nor iPod software updater recognise the thing. To be honest, neither application even start when the shuffle is plugged in! And now I've just read that apple says you "SHOULD NOT FORMAT" shuffle. What am I to do? Have I lost my iPod for ever?

  • I just deleted 300 messages on my iphone 4 and now it wont work. What to do?

    I decided to delete about 300 messages from my iphone 4 and now it wont work. I can't sent any messages. I tried to turn off my phone... But nothing seems to work. Please help!

    Reset the device by pressing and holding the home and power buttons until the white Apple logo appears.

Maybe you are looking for