I am trying to update the software but keep getting a 9006 error message. Any suggestions?

I am trying to update to iOS5 but keep getting a 9006 error message. Any suggestions?

iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/TS3694
Try this - Disable your firewall and anitvirus software temporarily. Then download and install the iOS update.
 Cheers, Tom

Similar Messages

HT3606 i keep trying to update the software and it gets stuck on configuration, so i can i sped up the process?

i keep trying to update the software and it gets stuck on configuration, so i can i sped up the process?

Some general advice on updating:
It is worth noting that it is an extreme rarity for updates to cause upsets to your system, as they have all been extensively beta-tested, but they may well reveal pre-existing ones, particularly those of which you may have been unaware. If you are actually aware of any glitches, make sure they are fixed before proceeding further.
So before you do anything else:
If you can, make a full backup first to an external hard disk. Ideally you should always have a bootable clone of your system that enables you to revert to the previous pre-update state.
Turn off sleep mode for both screen and hard disk.
Disconnect all peripherals except your keyboard and mouse.
1. Repair Permissions (in Disk Utility)
2. Verify the state of your hard disk using Disk Utility. If any faults are reported, restart from your install disk (holding down the C key), go to Disk Utility, and repair your startup disk. Restart again to get back to your startup disk.
At least you can now be reasonably certain that your system does not contain any obvious faults that might cause an update/upgrade to fail.
3. Download the correct version of the COMBO update from the Apple download site.
The Combo updater of Leopard 10.5.8 can be found here:
http://support.apple.com/downloads/Mac_OS_X_10_5_8_Combo_Update
If you prefer to download updates via Software Update in the Apple menu (which would ensure that the correct version for your Mac was being downloaded), it is not recommended to allow SU to install major (or even minor) updates automatically. Set Software Update to just download the updater without immediately installing it. There is always the possibility that the combined download and install (which can be a lengthy process) might be interrupted by a power outage or your cat walking across the keyboard, and an interrupted install will almost certainly cause havoc. Once it is downloaded, you can install at a time that suits you. You should make a backup copy of the updater on a CD in case you ever need a reinstall.
Full details about the 10.5.8 update here: http://support.apple.com/kb/HT3606
More information on using Software Updater here:
http://support.apple.com/kb/TA24901?viewlocale=en_US
Using the Combo updater ensures that all system files changed since the original 10.5.0 are included, and any that may have been missed out or subsequently damaged will be repaired. The Delta updater, although a temptingly smaller download, only takes you from the previous version to the new one, i.e. for example from 10.5.7 to 10.5.8. Software Update will generally download the Delta updater only. The preferable Combo updater needs to be downloaded from Apple's download site.
Now proceed as follows:
4. Close all applications and turn off energy saving and screensaver.
5. Unplug all peripherals except your keyboard and mouse.
6. Install the update/upgrade. Do not under any circumstances interrupt this procedure. Do not do anything else on your computer while it is installing. Be patient.
7. When it ask for a restart to complete the installation, click restart. This can take longer than normal, there are probably thousands of files to overwrite and place in the correct location. Do nothing while this is going on.
8. Once your Mac is awake, repair permissions again, and you should be good to go!
If your Mac seems slightly sluggish or ‘different’, perform a second restart. It can’t hurt and is sometimes efficacious! In fact a second restart can be recommended.
9. Open a few of your most used applications and check that all is OK. In this connection please remember that not all manufacturers of third party applications and plug-ins, add-ons, haxies etc, will have had time to do any necessary rewrites to their software to make them compliant with the latest version of your operating system. Give them a week or two while you regularly check their websites for updates.
N.B. Do not attempt to install two different updates at the same time as each may have different routines and requirements. Follow the above recommendations for each update in turn.
Lastly, Apple's own article on the subject of Software Update may also be useful reading:
http://docs.info.apple.com/article.html?artnum=106695
[b]If you are updating Safari (or just have):[/b]
Input Managers from third parties can do as much harm as good. They use a security loophole to reach right into your applications' code and change that code as the application starts up. If you have installed an OS update and Safari is crashing, the very [i]first[/i] thing to do is clear out your InputManagers folders (both in your own Library and in the top-level /Library), log out and log back in, and try again.
So, disable all third party add-ons before updating Safari, as they may not have been updated yet for the new version. Add them back one by one. If something goes awry, remove it again and check on the software manufacturer's website for news of an update to match your version of Safari.
Most errors reported here after an update are due to an unrepaired or undetected inherent fault in the system, and/or a third party add-on.
Additional tips on software installation here:
http://docs.info.apple.com/article.html?artnum=106692
To reiterate, Input Managers reach right into an application and alter its code. This puts the behavior of the affected application outside the control and responsibility of its developers: a recipe for problems. That's not to say that issues absolutely will ensue as a result of Input Managers, but you, as a user, must decide. If the functionality of a specific Input Manager or set thereof is really important to you, you may well choose to assume the associated risk.
Again, the advice is to remove all Input Managers from the following directories:
/Library/InputManagers
~/Library/InputManagers
especially prior to system updates (they can always be added back one-by-one later).
Solutions for troubleshooting installation, startup, and login issues in Mac OS X v10.5
http://support.apple.com/kb/TS1541?viewlocale=en_US

I have 2 apple ID one for Egypt and other for USA , now I try to update the software but I get a message said that this software download with other ID, then I logout and sign with second ID but i got the same message again ... Now I can not sign in more

I have 2 apple ID one for Egypt and other for USA , now I try to update the software but I get a message said that this software download with other ID, then I logout and sign with second ID but i got the same message again ... Now I can not sign in more
Any solution ?
I'm using iOS 6.1.2 IPad 3
Regards

I have also noticed the same "problem". I do not fully understand the impact of using the same ID on multiple computers and devices if I want to keep them all in sync.

TS3694 I tried updating my iPhone with the latest update. It downloads the update to my computer fine, but when it tries to update the phone, I keep getting a fault code of 3014. I've tried it four times.

I tried updating my iPhone with the latest update. It downloads the update to my computer fine, but when it tries to update the phone, I keep getting a fault code of 3014. I've tried it four times.

Try taking it to the nearest Apple Store. They should have computers there that they can use to get your iPhone out of recovery mode. Make an appointment first.

I'm attempting to download a plug in or patch to rectify the inability to open RW2 files in Photoshop CC 2014. I'm trying AdobePatchinstaller but keep getting an install error. Any advise?

I'm attempting to download a plug in or patch to rectify the inability to open RW2 files in Photoshop CC 2014. I'm trying AdobePatchinstaller but keep getting an install error. Any advise?

Thank you but the issue has been rectified. Adobe tech support led me through the process of updating all of my apps.
a r o 2 0 1 4

Trying to update idad software. Keep getting message that network connection timed out. Don't have a network.

Trying to update idad software. Keep getting message that network connection timed out. Don't have a network.

guyfromplantation wrote:Don't have a network.
That would be problem number 1. The device MUST be connected to the Internet to download software updates.
I am guessing you are trying to download an iOS update, common causes for the error you mentions are Anti-Virus or Firewall software on the computer preventing files from downloading.
If this doesn't address your issue, try rewording your issue so that we can better understand the problem you are having.

I TRIED TO update the software but it didnt work and previous OS also deleted

I TRIED TO update the software to iOS 5 but it didnt work now couldnt restore to the previous also

Instantly worked, found this on other thread!!
1. System Preferences > Flash Player > Advanced > Delete All
Press the "Delete All" button
2. Safari > Preferences > Privacy
Press the button “ Remove All Website Data”.

I'm trying to update the software but on the app store the software is showing with a random app id. How can I change this?

Hi,
I'm trying to export a movie from Final Cut Pro X. But this option is not opening when I click it to export. So I read some foruns and people having the same problem as I'm having now. They solved this problem buy updating the software, so I went to do the same thing, but on the app store app, when I click to update, it gives me a random apple ID and I can not change it to my one.
Has any one experience this problem before?

I see! That's the thing, I'm just afraid to lose the edit that I have at the moment.
As Final Cut Pro X does not give me the option to save it, it saves automatically. I don't really know how to back up. Do you have any particular method?

Trying to remove an old version of I Tunes and keep getting the message "The folder path I Tunes contains an invalid character' . It won't let me go any further, have tried deleting/repairing the program but keep getting the same message?

trying to remove an old version of I tunes, but keep getting the message 'The folder path I Tunes contains an invalid character'
It won't let me go any further, have tried deleting/repairing but get the same message and am blocked from continuing?

Hi Barbara,
I had a similar problem recently and using the "more like this" feature I discovered an answer. To a problem posed by Holo7, who like myself was a newbie on this platform, b noir proposed a solution to Holo7's problem that also worked with my problem. It involves downloading a version of MS Windows Instal Cleanup and using it to completely remove all traces of the old version.
If you look at my problem (follow OldGit66) and the link to Holo7's problem then you will find b noir's answer which I think may help you. I am new around here so you might want to wait for one of the higher status correspondents.
Regards
John

Trying to update to itunes 11.1 getting invalid signature error message

getting invalid signature error message when trying to upgrade itunes 11.1...help me please?

iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/TS3694
Try this - Disable your firewall and anitvirus software temporarily. Then download and install the iOS update.
 Cheers, Tom

Trying to update my iPhone but keep getting error

I have been trying to update my iPhone with the new update and at first I was told the server was flooded, then I was told it was due to using a wireless Internet stick. I tried updating with a wired connection and still no luck. The same thing happens every time I will get through 90% of the update and then it will come up with an error that it can not connect with the server. I have been trying at verious times, days etc and the same thing keeps happening gerr. What do I need to do to be able to get the update ? Please help .

Disable your anti-virus, install the update, turn you anti-virus back on

I have a Os X Lion 10.7.4 software. i tried to update the software but it says,"None of the selected items could be installed,an unexpected error occurs."

it keeps telling me this whenever i try to click the "sofware update". it downloads,and thereafter turns into the grey screen but gives me ,"non of the selected updates could be installed."

Two things you can try.
- Sign out of the App Store (in the Store menu)
- Quit the App Store
- In Finder - Go>Go to folder... (or Apple-shift-G)
- Paste in the following "~/Library/Caches/ "
- It will take you to a folder. Delete com.apple.appstore
- Launch the App Store and test
Try resetting the App Store.
Reset Learned from Old Toad

I am trying to update some apps but keep getting messages that I need to switch to the canada store - how? Thx

How do I switch from the us store to the canadian store to enable updates on apps - please and thx

Follow this procedure:
1. Go to Settings > iTunes & App Stores > Apple ID.
2. Tap your Apple ID.
3. Tap View Apple ID.
4. Enter your password.
5. Go to Country/Region in the popup window to change to the desired store.
See also: http://support.apple.com/kb/HT1311

HT1222 Have been trying to update my software but keep having an error message

Wonderful spring

What at error message and number?
See here for some troubleshooting advice: http://support.apple.com/kb/ts3694

How to switch to a different app store? I am trying to update my apps but am getting a popup that says your account is not valid for use in the uS store. you must switch to the Canadian Store before purchasing. How do I do this? I can't find the place

I am trying to update my apps but keep getting a popup that says "Your Account is not valid for use in the US store. you must switch to the Canadian Store before purchasing." I can not find where to do this! Please help! Thank you!

[Apologies to pdesteele for this slight OT bit, but it's all relevant to your question, I think ]
We do have a place in the UK which we could use as an address, but for various reasons it gets a bit complex even though we still have a UK bank account. We moved to France when there were no iDevices and apps around, just bought the occasional music, so it wasn't a problem. Funny thing is I can't even download the free UK bank app because it's not available in the French store .
I'll live with the problem for now as we plan to move back to the UK in a year or so - we miss the weather .

I am trying to update the software but keep getting a 9006 error message. Any suggestions?

Similar Messages

Maybe you are looking for