I am unable to open encrypted emails using webmail and a CAC reader. It says "content can't be displayed because the S/MIME control isn't available." I'm using a Macbook Pro with 10.10 OS and have tried both Safari and Chrome.
I am using a Macbook Pro with OS X Yosemite 10.10.2. I am unable to open encrypted emails using webmail. I have verified my certificates are loaded in the keychain for my military common access card while using a CAC reader. When I try to view the message it gives me the error saying "content can't be displayed because the S/MIME control isn't available."
I am using a Macbook Pro with OS X Yosemite 10.10.2. I am unable to open encrypted emails using webmail. I have verified my certificates are loaded in the keychain for my military common access card while using a CAC reader. When I try to view the message it gives me the error saying "content can't be displayed because the S/MIME control isn't available."
Similar Messages
-
My Macbook Pro will not charge. I have tried other charges and nothing. Can the MagSafe port go bad? Is that expensive to repair?
The port can fail. Internal boards can fail. Batteries can fail. All with the result that no charging occurs.
You can try Resetting the System Management Controller and you can try Troubleshooting MagSafe adapters.
But usually you will have to take the mac in to a service place for testing. It can get expensive, although occasionally it is not.
charlie -
my 3 year-old macbook pro is very slow. I have run disk utility and virus scan with no improvement. The "beach ball" will spin for minutes at a time when opening, closing or changing windows. Apple Store looked at it a few months ago with no help. What can I do?
Under CPU: 3.5% user; 5% system; 91% idle; 441 threads; 90 processes.
Under System: out of 2GB - 54.7MB free; 530MB wired; 603MB active; 862MB inactive; 1.95GB used.
Is too much of the system memory tied up? If so, what can I do to free some up? -
Should I upgrade to Snow Leopard/ Lion using a MacBook Pro with 2.26 GHz Inetl Core 2 Duo Processor and 2GB Memory? Can my old macbook take it?
thanksYes. You should be fine with Snow Leopard, but Lion requires a minimum of 2 GBs of RAM. If you upgrade to Lion I would first upgrade your RAM to at least 4 GBs if your model supports it. Also, see:
How to Install OS X Updates Successfully
A. Repair the Hard Drive and Permissions:
Boot from your current OS X Installer disc. After the installer loads select your language and click on the Continue button. Then select Disk Utility from the Utilities menu. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the installer. Now restart normally.
If DU reports errors it cannot fix, then you will need Disk Warrior (4.0 for Tiger) and/or TechTool Pro (4.5.2 for Tiger) to repair the drive. If you don't have either of them or if neither of them can fix the drive, then you will need to reformat the drive and reinstall OS X.
B. Make a Bootable Backup Using Restore Option of Disk Utility:
Open Disk Utility from the Utilities folder.
Select the destination volume from the left side list.
Click on the Restore tab in the DU main window.
Check the box labeled Erase destination.
Select the destination volume from the left side list and drag it to the Destination entry field.
Select the source volume from the left side list and drag it to the Source entry field.
Double-check you got it right, then click on the Restore button.
Destination means the external backup drive. Source means the internal startup drive.
C. Important: Please read before installing:
If you have a FireWire hard drive connected, disconnect it before installing the update unless you will boot from this drive and install the update on it. Reconnect it and turn it back on after installation is complete and you've restarted.
You may experience unexpected results if you have installed third-party system software modifications, or if you have modified the operating system through other means. (This does not apply to normal application software installation.)
The installation process should not be interrupted. If a power outage or other interruption occurs during installation, use the standalone installer (see below) from Apple Downloads to update. While the installation is in progress do not use the computer.
D. To upgrade:
Purchase the Snow Leopard Retail DVD.
Boot From The OS X Installer Disc:
Insert OS X Installer Disc into the optical drive.
Restart the computer.
Immediately after the chime press and hold down the "C" key.
Release the key when the spinning gear below the dark gray Apple logo appears.
Wait for installer to finish loading.
E. If updating:
Download and install update(s)
Use Software Update, or
Download standalone updater(s). -
I am using my old iPhone for playlist for my Dad's funeral as that meets the crematorium requirements. Some tracks - uploaded from personal CDs to MacBook Pro and successfully transferred to new iPhone (with small doc) won't transfer on syncing. Most do, but why won't some, of my own music sync when others off the same album and in the same playlist do? I have now checked the storage, freed up 766MB, how can i not sync (and get everything i've just deleted back) but upload the required tunes? All help appreciated, many thanks x x x
OrcaMDDDS wrote:
Is this possible?
maybe this post by Zevoneer helps.
I don’t want to hear any of that “iTunes will let you re-download anything you’ve lost” nonsense.
it won't anyways. except or apps, you are entitled to one download only. there4 it is important to back up.
JGG -
Do the 2011 Macbook Pros with an Apple installed SSD have cooling fans?
Do the 2011 Macbook Pros with an Apple installed SSD have cooling fans? In other words, I pre ordered the 256 SSD option with my purchase from Apple. I have searched and searched the internet for a clear answer. I have called Apple and have gotten contradictory answers. Can anyone definitively answer this question?
It's unbelievable that anyone purporting to represent Apple could have misinformed you in such a ridiculous way. Apple has never produced a MBP that didn't have one or more cooling fans in it. The percentage of total heat generated by a MBP that comes from its hard drive (or SSD) is tiny — I would guess it's considerably less than 5%. The notion that the machine could dispense with cooling fans as a result of switching from a conventional drive to a SSD is laughable.
I can only assume that you posed the question in such a way that it was not clearly understood by the people responding.
Message was edited by: eww -
I interrupted a software update and my macbook pro will not boot. I have tried to reboot using the startup disc, I have tried to verify the disc, and repair the disc. It tells me I need to erase and reformat the hard drive then reinstall the operating system. I do not have a back up of all my applications, my garageband music and other things. I also do not have time capsule set up on this machine, but I do have a 2 TB time capsule.
Is there anyway to back up this corrupted drive so I can restore my applications later?There's an old saying. If you don't have a backup disc, then there must be nothing important to backup. That's just lesson #1. Lesson #2 is to never interrupt a software update. Not a good thing.
OK, I'm sure you know this. It just upsets me to read your story, knowing you have a lot of important stuff on your hard drive, and didn't use time machine.
You're pretty much in a bad place. My only hope for you is to boot to your Installation Disc, then using disk utility see if you can save the internal hard drive (by fixing what can be fixed). You might be able to see your user folder and some of your apps. I wouldn't even consider copying the library, because who knows what's been corrupted in there.
Good luck. -
After iPad update I can't access my notes! Crashes opening with blank page. I have tried turning on and off. I have tried the reset to original. I have tried downloading again. Now what? I have important information that I need to get....
If you have set this phone up, then there would not necessarily be a solution here until you have been verify with the provider that everything is provisioned correctly on their end. Since the 3G comes from your cellular provider, if the settings are correct on the phone, then you should work with the carrier next.
-
My old computer crashed and I am trying to download Adobe X Pro on my computer. I have tried to download and the only download I can find is the Adobe XI Pro. Any help would be appreciated. I have the product key but it's not deactivated on my old computer.
if you need to deactivate, contact adobe support
https://helpx.adobe.com/contact.html
Downloads available:
Suites and Programs: CC 2014 | CC | CS6 | CS5.5 | CS5 | CS4 | CS3
Acrobat: XI, X | 9,8 | 9 standard
Premiere Elements: 13 |12 | 11, 10 | 9, 8, 7
Photoshop Elements: 13 |12 | 11, 10 | 9,8,7
Lightroom: 5.6| 5 | 4 | 3
Captivate: 8 | 7 | 6 | 5
Contribute: CS5 | CS4, CS3
Download and installation help for Adobe links
Download and installation help for Prodesigntools links are listed on most linked pages. They are critical; especially steps 1, 2 and 3. If you click a link that does not have those steps listed, open a second window using the Lightroom 3 link to see those 'Important Instructions'.
window using the Lightroom 3 link to see those 'Important Instructions'. -
Has anyone encountered this message on their time capsule/machine? Time Machine couldn't complete the backup because the backup disk image"/Volumes/Patti's Time Capsule/Patti's MacBook Pro.sparsebundle" is already in use"?
If you reboot the computer it should fix the problem. Also see the first link under More Like This to the right of this page:
I am received an error on my Time Capsule which states the backup disk image "Volumes/Data/MacBook Pro. sparse bundle? is already in use. so time machine couldn't complete the backup to time capsule - any suggestion -
I have tried to update an apps on my mini iPad but it says this update is for an app downloaded with a diffrent Apple ID. Sign in with that Apple ID and try again. I have tried both mine and my husbands ID and it still does not work.
We'll you can either do as Niel suggested, delete it and download it again with one of the two Apple ID's, or if you want to be sure that one of the two you actually bought the app, look in the purchased tab of the App Store when you are signed into your ID and see if the app shows up in there and if not, then sign into your husband's ID and see if the app shows up with his ID.
After you you figure out who actually bought the app, use that ID to update it. If it still doesn't work, try signing out of that ID, restart the iPad, sign in again and try to update again. -
I am unable to update an app, Chirps! USA. I have tried both wireless and when connected to the computer. I contacted the company and they said it was an iTunes problem. ANy suggestions?
Hi..
Delete the app then reinstall.
Hold the app icon down until all the apps jiggle then tap the x then tap Delete. Press the Home button once or twice to stop the jiggling.
Then go to the iTunes store and re download the app.
Downloading past purchases from the App Store, iBookstore, and iTunes Store
That should download the most recent version including whatever update was available.
You won't be charged again. -
I have an old ipod touch which won't go past the Apple logo, all it does is show me a loading symbol, but will go no further, i have tried restoring it and i have been successful. It connects and is recognised by my itunes and computer, but still after restoring it, it just won't get passed the logo..what can i do? what is the problem?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Have OS 10.7.5. Computer off three days and now message comes that Time Machine could not complete backup because the "/volumes/PH's timecapsulPro.sparsebundle" is already in use. Whats that about?
Two Solutions for "sparse bundle already in use" Error
Simple solution (from Bob Timmons):
1. Make sure that no other Macs are backing up the Time Capsule at the time
2. Pull the power cord from the back of the Time Capsule
3. Count to ten
4. Plug the power cord back into the back of the Time Capsule
If Simple doesn't work:
The Backup disk image ... sparsebundle ... is already in use. -
My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?
My iPad screen has gone gray/black. I have tried both reset and restore, to no avail. Suggestions?
Take it to an Apple Store for evaluation. It sounds like a hardware problem.
Maybe you are looking for
-
Songs no longer on iPod; how to safely sync?
I did an iTunes sync between my iPod Classic 160 Gb and my MacBook Pro as usual. Except that it didn't go as usual. The music is still there on my computer but the iPod has no songs on it. My iTunes is 11.0.4 which it says is the latest version. I'm
-
Clearing document mass reversal
i wanted to reverse 483 cleared document if there is any option is there for mass clearing document reversal.
-
Question - View with a join based on two unequal strings.
Hello - First my apologies for the likely novice question. I'm creating a view based on two tables as such: SELECT * FROM table1 LEFT OUTER JOIN table2 ON table1.string = table2.string AND table1.number = table2.number Problem: table1.string looks li
-
Writing to Multiple Data Files Only When selected?
I am building a system that is measuring the CO2 content of 12 vessels but only 1 CO2 gas analyzer. So, my system has a series of valves that only lets one valve open at time so that only one vessel is being measured at a time. What I would like to
-
Macbookpro noise issue on right side with heat
Hi, my 2014 macbook pro ratina display,13 inch, just finished a years warranty period, and suddenly from right side of the laptop, a noise starts (like a modem connecting or something burning kind a noise) with upper right corner more heated then the