I am unable to open my itunes after maverick update. Any suggestions?

Hi there sharonlarks26,
You may want to try reinstalling the latest version of iTunes. Take a look at the article below for more information.
Troubleshooting iTunes installation on Mac OS X
http://support.apple.com/kb/ht2311
-Griff W.

Similar Messages

Unable to open app store after Maverick update

Icon just bounces up and down and doesn't open

If the above does not resolve your problem:
-You can reinstall the Yosemite
-You can wait and see if the next 10.10.1 update sorts your dilemma and run your updates manually via Applications/Utilities/Terminal.app
software update via terminal:
To list the available software updates, use the following command.
sudo softwareupdate -l
All available software updates can be installed with the following command:
sudo softwareupdate -i -a
Install specific updates from those listed with the following:
sudo softwareupdate -i PackageName

Unable to export to iTunes after Garageband update

HI everyone. I updated to 2.0.2 after updating to iOS8 and have noticed that I don't have the option to save to iTunes or open in iMovie, two features I used a lot. Is this a mistake?
When I try to email the song I get a warning saying the size is too big to email and try saving to iTunes instead, so I'm thinking this has been accidentally omitted from the update??
ARgh!!!

HI everyone. I updated to 2.0.2 after updating to iOS8 and have noticed that I don't have the option to save to iTunes or open in iMovie, two features I used a lot. Is this a mistake?
It is working for me.
Have you updated all apps after installing the new iOS 8? i.e., updated iMovie?
Have you checked, if you have enough free memory after the update?
Have you tried to reset GarageBand? Settings > applications > GarageBand > enable reset.
If all fails, backup your device and reinstall iOS y restoring: Perhaps the download did not install properly.
See: Use iTunes to restore your iOS device to factory settings http://support.apple.com/kb/HT1414

Unable to open App Store after Yosemite update

I can't open my App Store after the update, the icon either bounces for a really long time or it manages to open, but nothing is loaded or interactive.
Help!!

If the above does not resolve your problem:
-You can reinstall the Yosemite
-You can wait and see if the next 10.10.1 update sorts your dilemma and run your updates manually via Applications/Utilities/Terminal.app
software update via terminal:
To list the available software updates, use the following command.
sudo softwareupdate -l
All available software updates can be installed with the following command:
sudo softwareupdate -i -a
Install specific updates from those listed with the following:
sudo softwareupdate -i PackageName

Hello :) I cannot open my itunes after un update. There is no particular error.

I had read similar questions and i followed all the advices that i found .. but.. nothing happened
I tried to:
- reinstall my program;
- update my quicktame;
- to find itunes.exe in my task manage->processes and delete it (there is only ituneshelper there) (i've read this somewhere here)
- to delete this files - theSC Info.sidbfile and theSC Info.sidd ..... but in this folder location (C:\ProgramData\Apple Computer\iTunes\SC Info.) there is only .txt file "sc info".
Is there any other solution tо fix this problem?
Thank you in advance

Hello alittlebitofyou,
It sounds like your iTunes doesn't launch when you click it even after you reintsalled the iTunes application, updated Quicktime, etc. I would use the troubleshooting for this sort of issue from the following article, named:
iTunes for Windows Vista, Windows 7, or Windows 8: Fix unexpected quits or launch issues
It is possible that you may need to reinstall iTunes, but there is a specific order to uninstall not just iTunes but its associated apps as well. Just follow the article step by step as far as you need to.
Thank you for using Apple Support Communities.
All the very best,
Sterling

Unable to connect to Internet after Secruity Upgrade - Any Suggestions?

Like several of the previous posts I am unable to connect to the internet. The affected computer is a G3 iMac. It is connected to a Linksys wireless access point. The Linksys wireless router is connected to my cable modem. I get a message that the Built-in Ethernet is active but: Built-in Ethernet has a self assigned IP address and you may not be able to connect to the internet. No combination of changes to the settings has had any effect. I also have tried all of the fixes in the previous posts. None of them have worked. I am not experiencing any connectivity problems with my other computers (2 PCs and 1 Macbook). Everything worked fine until that danged "security upgrade"!
Mac and PC Mac OS X (10.3.9) Win XP Pro

Visit http://www.macfixit.com/ where the have been
running articles on how to solve problems arising
from the security update.
Thank you for the link to MacFixIt. I found what I needed to correct the problem, although all of the fixes referenced computers with the AirPort card and software. I found that removing the extensions AppleAirPort2.kext and AppleAirPortFW.kext solved the problem. Everything seems to be working properly after a restart last night and an overnight shutdown.

No audio on iphoto after mavericks update, any help?

I've upgraded my macbook pro 15" late 2011 to mavericks and after that I have no audio on slide shows and can'y reproduce albums with music. Any help?

Are you using iTunes music in your slideshows?
Try going to iTunes and doing File > Library > Organize Library...
When that's done, try playing the slideshow again to see if you have audio.

Superdrive inop. after Mavericks install, any suggestions?

I installed Mavericks on my 2011 iMac via App Store about 3 or 4 weeks ago and all seemed fine at first, noticed a few programs loaded slower and wake time was a little longer, but nothing major until I noticed about a week ago when I put in a cd to add to iTunes that I had to push it in almost all the way before the drive would accept it. You could hear the drive try to read the disc and then it just ejected. I have tried several discs this week and same result, blank cd, dvd, factory cd, all spit out after a few seconds. I have browsed through the support threads and found that this was apparently an issue with the Mountain Lion upgrade as well, and a few people seem to also have this issue with Mavericks. I have seen the posts where people say that the upgrade "pushed an already dying device over the edge" but I find it extremely hard to believe that the drive would function but not recognize media inserted into it without there being a firmware issue of some kind and as little as I use the drive, I seriously doubt that it was "on the edge" either.
So far, I have tried a re-install of Mavericks and "spamming" the terminal with drutil commands, resetting the SMC and resetting the NVRAM/PRAM, none of which have been successful. Since the re-install, the drive now tries to eject the disc as soon as you start to put it in about 3 times and then will let you insert the disc and spits it back out within a few seconds. I am not sure if this is part of the issue, but now when I look in disk utility, the superdrive is there but the letters are greyed out, and when I tried to display it on the desktop, the hard drive would show up, but not the superdrive, even when a disc was in it. It seems as if the OS no longer recognizes the drive.
Any thoughts or suggestions other than "buy a new drive" would be appreciated.

Time to visit an Apple repair station.

Unable to open my iTunes, getting an error "New iTunes Library"

Hi,
I was trying to update my itunes to 11 and after installing i m unable to open my itunes,its giving me an error "New iTunes Library" with just an "OK" option. PLease helpme to get this fix.

When you reinstalled, did you first uninstall, and remove all 5 iTunes related components and any remnant files in either Program Files directory?
Certainly hope this assists you:
≈≈≈≈≈≈≈≈
https://discussions.apple.com/docs/DOC-6562
≈≈≈≈≈≈≈≈
Please do respond with results/questions.

Where can i download quicktime 7.5.5? A compatibility version gets downloaded but its not what I need. Im unable to open my ITUNES without the quicktime 7.5.5 upgrade or higher. Anything higher isnt supported by my mac ( OS X 10.5)

where can i download quicktime 7.5.5? A compatibility version gets downloaded but its not what I need. Im unable to open my ITUNES without the quicktime 7.5.5 upgrade or higher. Anything higher isnt supported by my mac ( OS X 10.5)

I had the same problem when re-installing my old iBook recently. You can find it here:
http://support.apple.com/kb/DL27

Unable to open b2b console after SOA 11.1.1.6 installation

Hi Gurus,
I had installed oracle SOA 11.1.1.6.0 successfully but i am unable to open b2b console after the installation.
Now
1)With Oracle installation can i able to open b2b console?
2)If not,Should i install oracle b2b soft also?
if yes,I can see the soft in 3 CDs (CD 1 of 1 ,CD 1 of 2 and CD 1 of 3)is it sufficient to install CD 1 of 1 so that others will also get install)
after the installation can i able to open b2b console?
please clarify?
Regards
Ramesh

Hi Anju,
Thanks for the help.
Can you send me some blog to guide me step by step to build Oracle b2b SOA application.
Please clarify:Do i need to install B2B document editor soft(CD 1of 1,CD 1 of 2,CD 1 of 3) or Installation of CD 1 of 1 is sufficient for b2b document editor.
Is B2B server is different from SOA server?If at all i need to deploy some doc in server,Can i deploy in SOA server using document editor?
Can i have some clarity on 1.How to install b2b doc in server?
Can i have a step by step sample to run a simple b2b application?
Regards
Ramesh

Could not open itunes after latest update

Could not open Itunes after latest update. Any sloutions??

iPad not appearing in iTunes
http://www.apple.com/support/ipad/assistant/itunes/
iOS: Device not recognized in iTunes for Mac OS X
http://support.apple.com/kb/TS1591
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
iTunes for Windows: iTunes can't contact the iPhone, iPad, or iPod software update server
http://support.apple.com/kb/ts1814
iTunes for Windows: Device Sync Tests
http://support.apple.com/kb/HT4235
IOS: Syncing with iTunes
http://support.apple.com/kb/HT1386
Apple - Support - iPad - Syncing
http://www.apple.com/support/ipad/syncing/
iTunes 10.5 and later: Troubleshooting iTunes Wi-Fi Syncing
http://support.apple.com/kb/ts4062
iOS: "Not enough free space" alert when trying to sync
http://support.apple.com/kb/ts1503
 Cheers, Tom

I have just updated my mac but now I am unable to open my itunes can someone help me please

I have just updated my mac but now I am unable to open my itunes can someone help me please

This worked for me:
1 Go to the finder menu bar at the top of the screen
2Click go
3 click applications
4 go down to iTunes and right click on Show Package Contents
5 open contents folder then go to mac os folder
6 open the terminal marked iTunes in that folder
This should force it to open and function enough, it will not allow importing of music from a desk top

HT1751 Hi I am unable to open my iTunes at all. A box stating "Runtime Error appears with Program C:/Program Files (x86) iTunes/iTunes R6034 shows up, please help

I am unable to open my iTunes. A box appears "Run time Error" Program C:/Program Files (x86) iTunes/iTunes
Please help me

See Troubleshooting issues with iTunes for Windows updates.
tt2

Unable to open my itunes

I am unable to open my itunes on my PC. The error message showing is: "This application has failed to start because MSVCR80.dll was not found. Re-installing the application may fix this problem". I've tried to reinstall itunes, with no success - it seems to jam. Any suggestions or solutions?

See if this post from turingtest2 helps (it's been a fairly common problem with the new version) : https://discussions.apple.com/message/24620553#24620553
He also has this user-tip for troubleshooting problem with updating iTunes (written as a result of the current update) : https://discussions.apple.com/docs/DOC-6562

I am unable to open my itunes after maverick update. Any suggestions?

Similar Messages

Maybe you are looking for