I disconnected my iPad unconsciously while it was updating ios 7.0.4 and it just stuck on that screen showing apple logo and a loading bar that just won't move on what to do now ????
I disconnected my iPad unconsciously while it was updating ios 7.0.4 and it just stuck on that screen showing apple logo and a loading bar that just won't move on what to do now ????
It's not uncommon for it to not work the first time and sometimes, you have to try it a few times. Turn off your antivirus software and your firewall while you are trying to restore the iPad. Enable them again after you restore.
If that still won't work, post back with detailed information as to what exactly does happen as you go through the process.
Similar Messages
-
I have snow leopard installed as an OS. When trying to reboot a MacBook Pro I am getting stuck on grey screen with apple logo and rotating symbol. What can I do?
Maybe this might help.
http://support.apple.com/kb/TS2570 -
This morning I was just getting the white screen with logo and status bar with fan running. I thought it was an issue with the power adapter so I went out and replaced it. MBP will start now, but won't connect to internet. I have full wi-fi signal. Also, when I try to launch iTunes, it just quits right away. Please help?
-AReinstall OS X without erasing the drive
1. Repair the Hard Drive and Permissions
Boot from your Snow Leopard Installer disc. After the installer loads select your language and click on the Continue button. When the menu bar appears select Disk Utility from the Utilities menu. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the installer.
If DU reports errors it cannot fix, then you will need Disk Warrior and/or Tech Tool Pro to repair the drive. If you don't have either of them or if neither of them can fix the drive, then you will need to reformat the drive and reinstall OS X.
2. Reinstall Snow Leopard
If the drive is OK then quit DU and return to the installer. Proceed with reinstalling OS X. Note that the Snow Leopard installer will not erase your drive or disturb your files. After installing a fresh copy of OS X the installer will move your Home folder, third-party applications, support items, and network preferences into the newly installed system.
Download and install Mac OS X 10.6.8 Update Combo v1.1. -
My iPad crashed! I tried a soft boot but didn't work. Stuck on black screen with apple logo!!!
How can I fix an iPad crash??? I have tried to reboot but only get a black screen with the apple logo. I need help!!!
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. If you did not do step 4 properly, start all over again. -
My IPAD 3 FROZE while updating to IOS 6.1.3 Cannot turn IPAD off, cannot connect to ITUNES. Screen shows Apple Logo and vertical progress bar. Progress shows about 50%. Can anyone suggest a solution? Note IPAD 3 still has power and is still showing the LOGO ect. My WIFI is active as I have three other devices able to use WIFI. Thank you for your help
Message was edited by: inclinelarrylSee if this page helps : http://support.apple.com/kb/ht4097 - it mentions a frozen progress bar when updating, and describes putting the iPad into recovery mode and restoring the iPad via your computer's iTunes
-
i disconnected my iphone 4 while it was updating and now its frozen, the screen is showing a apple logo and a loading bar which has been for 9hrs now. please help
It's not uncommon for it to not work the first time and sometimes, you have to try it a few times. Turn off your antivirus software and your firewall while you are trying to restore the iPad. Enable them again after you restore.
If that still won't work, post back with detailed information as to what exactly does happen as you go through the process. -
I tried to reset my iPhone (3gs) with deleting all data. When it power off and automatically again on then it is showing Apple logo only. Not restore and startup my phone. iPhone alerming low charge and I tried to charge and not charging.
What I should do now?Something has gone wrong. Turn your phone off, then force it into recovery mode:
Leave the USB cable connected to your computer, but NOT your phone, iTunes running, press & hold the home button while connecting the USB cable to your dock connector, continue holding the home button until you see “Connect to iTunes” on the screen. You may now release the home button. iTunes should now display that it has detected your phone in recovery mode, if not quit and reopen iTunes. If you still don’t see the recovery message repeat these steps again. iTunes will give you the option to restore from a backup or set up as new. In your case, select "new". -
Macbook Pro (2011) froze while working, forced shut down, now won't turn on. Grey screen with apple logo and spinning wheel for hours. Help?
Unfortunately do not know the operating system since I never updated anything and I can't get in to it.
Thanks for your assistance.If you want to preserve the data on the boot drive, and it's not already backed up, you must try to back up now, before you do anything else. It may or may not be possible. If you don't care about the data, you can skip this step.
There are several ways to back up a Mac that is not fully functional. You need an external hard drive to hold the backup data.
1. Boot from the Recovery partition or from a local Time Machine backup volume (option key at startup.) Launch Disk Utility and follow the instructions in this support article, under “Instructions for backing up to an external hard disk via Disk Utility.”
2. If you have access to a working Mac, and both it and the non-working Mac have FireWire or Thunderbolt ports, boot the non-working Mac in target disk mode. Use the working Mac to copy the data to another drive. This technique won't work with USB, Ethernet, Wi-Fi, or Bluetooth.
3. If the internal drive of the non-working Mac is user-replaceable, remove it and mount it in an external enclosure or drive dock. Use another Mac to copy the data. -
Iphone 4s struck while i was updating ios 8
My iphone 4s struck while i was updating ios 8 . when i tried to connect it to itunes and recover it , it also did not work . when taken to the apple store in india they told it cannot be fixed since the phone was purchased in U.S . Please help me
HI ..
Hold off for a bit until Apple repairs some known issues > http://www.macrumors.com/2014/09/25/ios-8-0-2-in-the-works/ -
I was updating my ipod touch and the updation had an error and it froze at the apple logo with the loading bar underneath. How do I fix it? I tried the turn off button home screen button and even the volume buttons. I cant get anything to work. Please help me.
Connect to itunes and retore.
-
Ipad mini stuck on white screen with apple logo
I have a new iPad mini. only had it 2 weeks. used it this morning everything was fine. pluged in to charge, when I came back it is stuck on white screen with apple logo. I tried to reboot. that did not work. please help.
Have you tried resetting your iPad?
Reset: Press the Home and On/Off buttons at the same time and hold them until the Apple logo appears (about 10-15 seconds).
No data will be lost. -
My iTouch will not restore becuase for some reason it won't reconize it. I merely tried to update it with the newest software and every thing went to sh--. Now it is just stuck on the screen showing the apple sign. Can anyone help me.
There's a whole lot to read in your post, and frankly I have not read it all.
Having said that, this troubleshooting guide should help:
http://support.apple.com/kb/TS1538
In particular, pay attention to the mobile device support sections near the bottom, assuming you have already done the items above it. -
Hi my iMAc 27 inch starts up to the grey screen with apple logo and loading bar underneath it loads halfway then freezes up and shut down after a while please help
Try the tips listed here Mac OS X: Gray screen appears during startup - Apple Support
-
After the error occured, my phone was stuck on the apple logo with the loading bar below it. I cannot restart it because my power button is broken, and it will not be recognized on my iTunes. Any help how i can get my phone off or back to working again?! HELP PLEASE!!!
Looks like a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is required...
Be sure to make an appointment first... -
my iphone has a blank screen no apple logo and wont turn on. my computer wont pick it up either, what is going on?, my iphone has a blank screen no apple logo and wont turn on. my computer wont pick it up either, what is going on?
You repeat yourself frequently frequently. Perhaps your iPhone is not charged.
Too, you might look in the section "More Like This", right over here ----->
Maybe you are looking for
-
Can someone help me please to giving answers the following? Will be awarded full points. ABAP CERTIFICATION QUESTIONS 1. What is the fastest way to move one internal table to another internal table (assuming two tables of similar structure)? a) Appen
-
Can I install my old boot drive (Tiger) in another G4 running Leopard?
My trusty old dual 1GHz Quicksilver has finally died so I bought a used G4 Quicksilver MMD to replace it. Thing is, this other G4 has Leopard installed on it. To use Photoshop 7, I need to be running Tiger. If I install my old Tiger boot drive in thi
-
My iBook can't find my base station
It seems my iBook decided it no longer wants to connect to my base station, however, it is able to find other base stations in the area. What could be causing this? I have tried rebooting everything. Also, I have checked to make sure no settings or c
-
Hi, I have to write a query which should fetch data for the last 6 fiscal weeks from the data from which it is run. eg SELECT TO_CHAR(SYSDATE,'YYYYIW')-6 FROM DUAL The above query would give me the last 6th fiscal week from the current date, but this
-
Jsp newbie, please help about @include
I am new to JSP. I have two jsp files, say , jsp1 and jsp2. JSP2 is perfectly working. I want to display the result of jsp2 with the result of jsp1. But I additionally want to supply a value from jsp1 to a variable in jsp2 before calling jsp2. The re