I recorded VCR tape onto DVD-R but will not play on my MacBook Pro. I have already recorded multiple DVDs. How can I get it to play on my Mac?

I recorded VCR tape onto DVD-R but will not play on my MacBook Pro. I have already recorded multiple DVDs. How can I get it to play on my Mac?

"I recorded VCR tape onto DVD-R"
How? Using what equipment/software?
"The DVD  plays on the device on which it was recorded."
Just a guess: You're using a VCR-DVD combo recorder. DVDs produced in this way will play on the device that made them, but won't play on anything else until they're "finalized." In fact, Macs will recognize unfinalized DVDs as blank discs until the discs are finalized. Check the manual that came with the recording device for instructions.

Similar Messages

Maybe you are looking for

  • Dynamic actions

    Hi Gurus, I have coded a perform in a report for a dynamic action to be performed for while updating IT0416. Could you please tell me that if I am making an entry in the table T588Z will this be accomplished ? Or if not what else I have to do. Please

  • How to suppress the Push button in a custom screen

    Hi,    Is there any procedure to suppress a Push button in a custom Screen based on a condition. For eg: If Material is not initial.             then display the Continue button.          else not.           endif.

  • New Blog entry screen not rendering properly in IE9 on Windows 7

    I have set up a Blog site in Sharepoint 2013 and all seemed to be working OK, I am running Windows 8 with IE10.  When the blog site was accessed from a Windows 7 pc using IE9, all initially looked OK, however when I clicked on the link to add a new b

  • ACE Sticky Connections, Show Conn Output and Show serverfarm

    Hi Community, I'm deploying a Cisco ACE module and I have some questions about sticky connections and about the output of the show conn command and show serverfarm command. I have the follwoing configuration: rserver host srv_1  ip address 10.4.11.14

  • How to display three months by prompt

    Hi, I have a requirement in dashboard, there is a prompt of month, if I select one month, there will show three months' data, example, if I select '201108', it will display 201107,201108,201109, If I use '+' or '-' in month calculation, it has a prob