Iphone does not turn on after update to ios 7

My iphone dies not turn on after update to ios 7
it keeps showing the message : (connect to itunes)

What type of computer do you have?
Were you updated to the latest version of iTunes?
You may need to follow these steps:
http://support.apple.com/kb/TS3281?viewlocale=en_US
Good luck!

Similar Messages

  • HT4623 my iphone does not turn on after update to ios 7

    Kindly help me to solve this problem
    I updated my iphone to the new ios 7
    but the iphone does not turn on
    when i turn on it gives Hello slide to set up
    then after that it shows the message connect to itunes
    i connected and restored the backup
    synczed already
    but the iphone does not turn on
    only showing the message 'connect to itunes"

    Something has become corrupted hold down the Home and Power Button whilst plugged into Computer and with iTunes open it should then find a iPhone in recovery mode reinstall the software and the back up it sounds like the back up had something wrong and has put this on to the new install.

  • Nokia 206 does not turn on after update

    Hi
    Just got a Nokia 206
    Updated the software. Itupdated and restarted fine
    Then I checked for updates again, and it updated a second time
    Everything went fine, and the phone restarted. It said "Update Successful" or something like that
    I remember that the SW version was from May 2013 (first update was MArch 2013 I believe)
    I tried to update a 3rd time and it said that there were not more update availabale
    I was happy !
    I checked that internet worked, sent an email, everything worked fine
    Then I turned off the mobile to try another SIM card, but when tunring it on, the screen goes black, then "NOKIA" is displayed on the screen for few sec, then the phone turns off
    I tried to :
    _ different SIM cards
    _ using 1, 2 or 0 SIM cards
    _ holding power button up to 10 - 15 sec (hopping it will do some reset)
    _ tried to find a hard reset button, but did not find...
    So basically, the phone is not turning on. Only "NOKIA" is written for few sec, then phone turns off again
    The phone is un-usable as such
    Please Nokia, what should I do to fix that ?
    Regards
    Bastien

    when I plug the power supply, the charging icone shows up
    When I try to start the phone then, the screen gets all white for less than a second, then black for 1 to 2 seconds, then all white for less than a sec again, then turns off
    When I press again, it goes back to the charging icon (the white and orange battery charging)
    Also, I forgot to mention that sometimes, it does not do the short vibration it used to do when trying to turn on

  • My nokia 5800 does not turn on after update??

    i updated my nokia 5800 yesterday, and it a 100% bt then my phone restarted by it self (as it normally should) then the usb connection came up after it turned on i clicked pc suite bt then there was an error and it said to take out the usb and the battery, so i followed this and now my phone will not turn on, any help?

    He means shut the phone down, take out the memory card and start it up again. Then shut it down, replace the memory card and turn it on again. I don't know if that will fix your problem, but that was the instruction...........
    If I have helped you with your problem in some way, please take a little time and hit the kudos button in my post. Without your feedback, I don't know if I am being helpful or should just be put out to pasture.

  • My iphone will not turn on after update

    Hi all.
    I was wondering if you could help me.
    I tried to update my phone last night. I had a number of error codes and was then met with the task of having to restore my phone.
    I restored it and it failed.
    All that happens is the apple logo comes on and the 'egg timer'. I can not turn it on. I have tried to press the sleep and home buttons..but no joy.
    I tried this morning and my PC would not recongnise my  iphone and neither would iTunes.
    Any help would be appreciated.

    Please help me

  • My iPhone 5 keep rebooting itself after update to iOS 8? My friends iphone 5 is doing it too...already reset the phone and the problem till happen.

    My iPhone 5 keep rebooting itself after update to iOS 8? My friends iphone 5 is doing it too...already reset the phone and the problem till happen.
    What at can I do to fix the problem???

    Hello there, Fernandox26.
    The following Knowledge Base article offers up some great steps for troubleshooting isues with unexpected power issues with your iOS device:
    iPhone: Hardware troubleshooting
    http://support.apple.com/kb/ts2802
    Will not turn on, will not turn on unless connected to power, or unexpected power off
    Verify that the Sleep/Wake button functions. If it does not function, inspect it for signs of damage. If the button is damaged or is not functioning when pressed, seek service.
    Check if a Liquid Contact Indicator (LCI) is activated or there are signs of corrosion. Learn about LCIsand corrosion.
    Connect the iPhone to the iPhone's USB power adapter and let it charge for at least ten minutes.
    After at least 30 minutes, if:
    The home screen appears: The iPhone should be working. Update to the latest version of iOS if necessary. Continue charging it until it is completely charged and you see this battery icon in the upper-right corner of the screen . Then unplug the phone from power. If it immediately turns off, seek service.
    The low-battery image appears, even after the phone has charged for at least 20 minutes: See "iPhone displays the low-battery image and is unresponsive" symptom in this article.
    Something other than the Home screen or Low Battery image appears, continue with this article for further troubleshooting steps.
    If the iPhone did not turn on, reset it while connected to the iPhone USB power adapter.
    If the display turns on, go to step 4.
    If the display remains black, go to next step.
    Connect the iPhone to a computer and open iTunes. If iTunes recognizes the iPhone and indicates that it is in recovery mode, attempt to restore the iPhone. If the iPhone doesn't appear in iTunes or if you have difficulties in restoring the iPhone, see this article for further assistance.
    If restoring the iPhone resolved the issue, go to step 4. If restoring the iPhone did not solve the issue, seek service.
    My issue is still not resolved. What do I do next?
    Contact Apple Support.
    Thanks for reaching out to Apple Support Communities.
    Cheers,
    Pedro.

  • HT4623 IPhone does not accept slice after Iihaddat new 6.0.1 device type as the iphone 3gs

    Official solution in the iPhone does not accept SIM after Iihaddat together knowing that iTunes updated, the new release bearing ČÓ Miqubl chip device Brightening official

    I too have experienced the Logitech s715i error message stating something like, the accessory is not a supported device of the iPhone. The speakers will charge my phone but will not "connect" to play music. I have an iPhone 4S running version 6.1 (10B142). 
    I too have contacted Logitech for support and am awaiting a reply.
    Can we get some help over here?

  • HT1688 My iphone 5 does not ring anymore after upgrading to ios 7.0.2

    My iphone 5 does not ring anymore after upgrading to ios 7.0.2.  It did not happen right away, but maybe 2 weeks ago.  I tried turning the "do not disturb" on and add allow everyone to call as well as turning it off but it only vibrates when calls come in.  I also turned my phone off and it still only vibrates when calls and messages come in.

    I found another feed and said there is a silent button next to volume bar.  That was the problem.

  • HT201412 my ipod touch does not turn on after steps 1-4.  It only shows the apple logo and then turns off

    my ipod touch does not turn on after steps 1-4.  It only shows the apple logo and turns off

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer                 
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • My iphone will not turn on after I replaced the battery

    My iphone will not turn on after I replaced the battery, itunes logo comes up, but it will not connect and does not reset! does anyone know what I can do?

    Who replaced the battery, you, Apple or an Authorized Apple Service Provider? If you did it yourself, then you could have done anything to disable it. It also voids any warranty and post-warranty support from Apple and the forum. You are on your own. If Apple or an Authorized Apple Service Provider replaced it, then take it back and have them check it.
    The iPhone does not have a user replaceable battery, or user serviceable parts. It is meant to only be serviced by Apple, or authorized service providers.

  • IPhone 5 facetime app not shuting down after updating of  iOS 8.0/8.0.2 ?

    Hey there my iPhone 5 face time app not shuting down after updating of  iOS 8.0/8.0.2 ? after i upadted my iOS 8.0/8.0.2 software  my facetime app never get quit even i want to quit it. so then i have to shut my fone down to quit facetime . please help me . Thanks

    Hi, gurpreet from chatham.  
    Thank you for visiting Apple Support Communities.
    Here are some troubleshooting steps that I would recommend going through when experiencing this issue.  
    iOS: Not responding 
    http://support.apple.com/kb/TS3281
    Cheers,
    Jason H.

  • HT1430 my iPhone is not turning on after resting option and i can't even turn it off because of my my power button doesn't work

    my iPhone is not turning on after i did click on resting option and i can't even turn it off because my power button is compressed please help

    Amrit M wrote:
    my iPhone is not turning on... my power button is compressed
    Looks like a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is required...
    Be sure to make an appointment first...

  • Iphone is not detecting network after updating, i m not able to configure it

    my iphone is not detecting network after updating, i m not able to configure it

    To answer your question there, are you unable to connect to cellular internet (using a SIM or WiFi?

  • HT4623 my 3G iphone does not have a software update tab. how do i update my phone?

    My iphone does not have a software update tab. How do I update my phone without it?

    You don't have a software update on your phone because you need IOS 5.0 or higher to OTA.
    You will have to update using itunes.

  • HT4623 why my iphone does not have the software update option

    why my iphone does not have the software update option

    Are you sure you're connected to a network and that your iphone isn't on airplane mode?

Maybe you are looking for

  • K9n Platinum Won't Post!!! Memory Incompatible or Mobo failure???

    Like so many others, I am having trouble with my K9N PLatinum.  When I turn the system on, everything powers on, CPU fan, case fans, leds.  It begins to post, no video, but the D bracket just hangs on (1, 3, 4, red and 2, green).  I have tried all of

  • [SOLVED] So many problems with the RTL8723au wireless card:

    Hello,    I have been a long time linux user (Ubuntu & CentOS) and recently switched to Arch Linux. My laptop usually has strange issues with all sorts of stuff when it runs Linux like graphics cards, brightness control, and WiFi. So far I have been

  • Ipod 4g does not work with gps mount anymore, with iOS lower than 6.0.1 it worked

    After updating my iPod to iOS 6.0.1 and 6.1 my gps mount does not work anymore. It used to work perfectly. Have checked with a TomTom app if satelites are connected and it has good connection but navigation app does not work. All advices given in the

  • Plug Ins for Glass Shattering Effects

    Hi Everyone, Does anyone know where or how or even if it is possible to find a plug in or program that I can apply a glass shattering effect to footage and picture, you know the effects where it breaks the pictures in to different shapes of broke gla

  • Graph active palette tool event?

    Hello LabVIEW users, Simple question I hope. How can detect that the Active Paletter Tool of graph has changed? The only solution I have found is to use the timeout event and to poll the property node. If you use the mouse up and mouse down event for