IPod nano 6th generation not charging, not showing in iTunes, won't reset
iPod 6th generation, completely out of battery. Won't charge off iMac, plug socket or Macbook. Won't show up in iTunes in any either. Won't reset using the method i found on here (volume down button and sleep/awake button for 8-20 seconds).
Any suggestions?
Thanks!
hold down the enter button for 5 secs then plug into wall while still holding it down.
Similar Messages
-
ipod nano(6th generation) it is not recognised in itunes.. it says it cannot recognise this device completely..try unistalling and re-install itunes.. i did but it still doesnt.. even my ipad is not recognised in itunes,.. wat shall i do ..pls help me ...
Did you uninstall iTunes and all other Apple related software using the instructions in this Apple support document?
Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7
B-rock -
TA44551 Apple ipod nano 6th generation wont charge on pC, mains or car.
My ipod nano 6th generation wont charge, either through mains, car or computer USB charger. Had it one month, bought it from Amazon. Just dead, wont wake up. When it had charge tried master reset etc. still not able to charge or recognised/charge on PC
It'll need to charge for a while before it will turn on. Leave it to charge for a couple of hours, then try again.
-
When I connect my ipod nano to my laptop it shows the icons on it and in the upper right hand corner it has a charging symbol on the battery symbol but my ipod still doesn't appear in my computer or itunes ... is there anything i can do to fix it ... everything on my laptop is up to date
Hello delilahca,
Thanks for using Apple Support Communities.
For more information on this, take a look at:
iPod not recognized in My Computer and in iTunes for Windows
http://support.apple.com/kb/ts1369
Best of luck,
Mario -
Ipod nano 6th generation wont connect to computer or itunes, but still charges
I have an Ipod nano 6 that will not connect to my computer. It still charges however. I tried a new cord. I uninstalled and reinstalled itunes. I reset my computer and the ipod. I looked to see if it was a problem with my usb drivers and the ipod did not show up. I have basically tried everything but restoring it. Any help is greatly appreciated
Hey JHost13!
I have an article for you that will help you troubleshoot this issue with your iPod nano:
iPod not recognized in My Computer and in iTunes for Windows
http://support.apple.com/kb/ts1369
Thanks for coming to the Apple Support Communities!
Cheers,
Braden -
iPod nano 6th generation, syncing with audiobooks does not work now, had been working. Sync test says: No iPod touch, iPhone, or iPad found. Connectivity test OK, no physical problems, iTunes shows the iPod. Any clues what to do?
Hmm.. Thank you for the response.
Have you tried using the iPod with another user account or computer, to help narrow down whether the problem lies with the computer, account, or the iPod itself?
Maybe try reformatting it, using the tools provided by Windows. Instructions on how to reformat your iPod can be found in this article.
http://www.methodshop.com/gadgets/ipodsupport/erase/index.shtml
B-rock -
IPod Nano 6th Generation Not Charging/Holding Charge
Hi.
My iPod Nano 6th generation will not charge or hold a charge. I plug it in and it will turn on for about 30 seconds or less and then die. It will then continue to turn on and die unless I unplug it in which case it will die and not turn on. Any advice/suggestions and/or help finding what is wrong would be greatly appreciated. Thank you in advance.hold down the enter button for 5 secs then plug into wall while still holding it down.
-
My iPod Nano 6th generation fell one time and it kept working with a small crack in the screen.But after a while it just gave out and does not turn on.I try to charge it and all it does is blink the apple icon on and off.When disconnected nothing happens.
I am having the identical trouble as described above with my month old Macbook Air. I tried everything with the ditto results. Please help anyone!
Mine is a Macbook Air 13', 128GB, 1.86GHz with 4 GB RAM. -
i have an ipod nano 6th generation .version 1.2 yesterday i restored it on i tunes using my system window 7. for the last few days it does not start when the sleep/pause button is pressed.or even by pressing the both button sleep/pause and sound minus..It starts while connected to power. and then continues working. I can not put off it and it automatically goes off after some time its performance is ok after starting by connecting to power and then disconnecting the cord.
what would be the reason and what to do?>Call Apple Care as you are still under warranty.
-
My ipod nano 6th generation will not turn on.
My iPod nano (6th generation) will not turn on. I have charged it (attached to my computer) for 30 minutes. I have tried to reset it (held down Wake and Volume Down for 8 seconds)- no response. I have factory restored it (through iTunes)- no response. It shows up as connected to my computer and will sync in iTunes, but the display on the iPod will not turn on. Any ideas?
Hey s.mccarter2010,
Thanks for the question. After reviewing your post, it sounds like you have tried a lot of things and the iPod still will not turn on. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
iPod won't turn on
If you have tried the solutions above and iPod still won't turn on, check the following:
Make sure iPod is the only device in your FireWire or USB chain. Disconnect everything but the mouse, keyboard, and your iPod, then see if it will turn on.
Make sure you are using the FireWire or USB cable that came with your iPod, and that the cable is in good condition.
Try connecting iPod to the built-in port of a different computer to see if that works. Note: If using a portable computer, make sure it is plugged in to a power source and that the lid or display is open. If the lid is closed the computer may go into either standby, sleep, or hibernation mode and iPod will not charge properly.
If you still can't turn iPod on after performing these steps, it may need to be repaired. You can arrange for repair at the iPod Service Website.
Thanks for using Apple Support Communities.
Have a nice day,
Mario -
hi my ipod nano 6th generation will not turn on what should i do ...no batery left and never pluged it into itunes
Hi meganisawsome,
If your iPod will not turn on and you are getting indicators that there is no battery left, the first step would be to make sure that the iPod has been charged correctly. You may find the following article useful:
Apple Support: Charging your iPod battery
http://support.apple.com/kb/HT1384
If you are still having issues after charging, you may want to look at this article:
iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/TS3474
Regards,
- Brenden -
My ipod nano 6th generation is not working anymore :( HELP
I have an ipod nano 6th generation. Was working perfectly. One day I wake up and is showing me a screen I have never seen before..It reads:N20 Snowfox 4A0432
When I plug it, itunes doesnt recognize it. It recognized it once but it says problem 1621 and I follow the instructions but still my ipod is frozen and not even my computer can read it.
I really miss my music for my morning run!Have a look at comment # 4 and 5 on this page iPod nano 6G diagnostic mode to get it out of this mode again.
Pressing the volume minus button and power button should help. -
when i plug in my ipod nano (6th generation) a message on itunes saying the ipod is 'detected but not identified'- i've spent all day trying to fix it and nothing seems to work so i can't sync any songs..
Hello beafraser,
Here's an article to help troubleshoot when your iPod is detected but not identified.
iPod nano: Error message saying that iPod 'could not be identified properly'
http://support.apple.com/kb/ts3218
Hope that helps.
Thank you for visiting Apple Support Communities.
Nubz -
Hello, my ipod nano 6th generation is with the black screen, now restored, already pressed for 8 seconds and decrease volume botação start and not resolved, can someone help?
I am currently having this same problem. This nano lasted me less than 2 years.
-
IPod Nano 6th generation is decteded but could not be identified - help!
I have a iPod nano 6th generation and until this morning it worked fine with iTunes
Today when I plugged it in I get the following message... iPod is detected but could not be identified properly...
I have already
1. reinstalled iTunes
2. Tried other USB wires
3. Restarted the computer
HELP!!!!1. reinstalled iTunes
Doublechecking. Have you tried a complete uninstall of both iTunes and all the other related software components and then a reinstall? If not, try the instructions from the following document:
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8 -
My iPod's OFF/ON switch is not working and I have checked over internet that this problem is very common with iPod Nano 6th generation, my iPod is now out of warranty period. What shall i do now?? Please Suggest!!
You can do an out-of-warranty replacement at an Apple Store for a fee, get a 3rd party site to repair it, sell it for parts, or get a new one.
Maybe you are looking for
-
rather annoying problem. I downloaded some tracks from the Nokia music store onto my 5800. Each time i did a software update i lost the licences for the tracks. even though i had backed up the phone beforehand. No Problem, i just re downloaded the li
-
Hi Can any one tell me How does payment medium workbench differ from Classic payment medium programs? Why should i use Payment Medium Workbench? Will it help in creating Idocs. Regards Aravind
-
Help Convert decimal to fraction
Need covert decimal de piont float to fraction thats no easy for me. you like help me with my probleam I thank you very much sorry for me English i don't stand English My e-mail is [email protected]
-
Hi, I am facing a problem in printing from Reports 6i. We are using shared Laser Printer HP 4100 N. If i print report using this printer then 6i given General Page Fault (GPF) and comes out of program. Can anybody help me in resolving the issue. This
-
Iphoto, photo stream, macbook ???
do i need to download iphoto for photo stream to work, to send photos to my macbook?