IPod touch recognizes it is plugged in and has low battery but will not charge no matter what it is connected to! Suggestions????
After a year of owning my iPod touch 4g it suddenly stopped charging on my computer and outlet addapter. It still shows the two pronged plug icon that recognizes the iPod is connected to something but even as the battery level goes below twenty percent it will not charge. Still functions well and even connects to iTunes.
If it is still under warrenty which you can find out from here or if you know it's under one year old bring it to the Apple Store.
https://selfsolve.apple.com/agreementWarrantyDynamic.do
Similar Messages
-
My ipod touch 4g will not charge no matter what i plug it in to
and every thing i try will charge every other ipod i have and the troubleshooting doesn't have a fix for it, any suggestions?
Take a moment to reset your iPod....hold down the sleep and home key, past the power down slider and until you see the silver apple. Let it reboot and try the trouble shooting again.
If you've replicated the issue with multiple chargers, cords and outlets (enough to rule out any single one of those devices being the source) then I'd make an appointment at your local apple store because it's possible that the charging port on your iPod has gone bad or maybe your battery. Both issues are not user servicible. -
I pre ordered a album and it says purchased but will not download
I pre ordered a album and it says purchased and has been released but will not download
Hey Sspafford!
I have an article here that can help you with this issue:
How to report an issue with your iTunes Store, App Store, Mac App Store, or iBooks Store purchase
http://support.apple.com/kb/HT1933
Thanks for being a part of the Apple Support Communities!
Regards,
Braden -
my sound has stopped working i have speakers plugged in but computer doesnt register or recognize them. the volume is on mute and grayed out ...will not let me change,what can i do to fix this problem....i have tried unplugging and plugging back in and reset and headphones...nothing works..how do i get my sound back?
OS X Mountain Lion: If you can’t hear sound from your speakers
Read the "If you’re trying to listen through external speakers" section. -
There's a logo that pops up on my ipod touch screen with the logo Itunes and the USB cord but is unable to connecct with iTunes...what should i do?
Resolve communication issues
Check the hosts file or TCP/IP filtering, which might cause communication issues between iTunes, ports, and servers.
Common errors: 1004, 1013, 1638, 3014, 3194, or 3000-3999. These alerts refer to gs.apple.com, say "There was a problem downloading the software", or say the "device isn't eligible for the requested build". -
how can I unlock my ipod touch? The screen is locked and has various languages on the sliding bar. the screen is grey and the normal screen saver is gone.
As a first attempt, try a reboot by holding both the power and home buttons untl the apple logo appears and it restarts, ignoring the red slider if that appears.
-
My ipod touch will not hare no matter what and I've tried many different cables and different ways to charge it. What should I do? If I complain to the Apple store co. will they replace my ipod for free?
- See:
iPod touch: Hardware troubleshooting
- Try another cable
- Try another charging source
- Look at the dock connector on the iPod. Look for abnormalities like bent or corroded contacts, cracked or broken plastic.
- Make an appointment at the Genus Bar of an Apple store.
Apple Retail Store - Genius Bar -
My ipod touch 4th generation's home button and lockscreen work perfectly but the screen is unresponsive and wont work whats the problem?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My 160GB ipod classic stopped whilst playing music and will not turn back on despite having almost a full battery. I have tried connecting to itunes and a docking station but will not turn on at all - HELP?!
I've had this from new for 2 years, the battery life is excellent and lasts for days so I know it's not a power issue as it was fully charged that morning. No signs of connection in itunes, it's not showing as a connected device.
Can anyone please help?Hi gscoops,
Welcome to Apple Support Communities.
You may find the steps in our iPod Troubleshooting Assistant helpful:
http://www.apple.com/support/ipod/five_rs/classic/
Best,
Jeremy -
This an IPOD I bought used. Everything else works fine. It syncs to my computer and plays my music but will not connect to the USB interface in my car. My wife's IPOD, which seems to be identical, works fine. I should say it connects but then immediately disconnects. Any ideas?
Then my last suggestion is to Reset it, while connected to the BMW Audio.
Toggle the Hold switch, make sure you dont see the red mark when you do the next step
Reset the iPod -> Press Menu and Center button simultaneously for about 10 secs or till the Apple Logo comes ON
Then release the buttons
Select your preferred language.
Here is the Apple support Article on the 5Rs
http://www.apple.com/support/ipod/five_rs/classic/
Good Luck! -
have an apple TV 1st generation - it froze downloading a trailer and had to be unplugged. Since then I cannot access the apple tv menu. When I run diagnostics it says it is operating properly but will not factory restore. What can I try?
Apologies, I was looking at the wrong schematic for the Apple TV 1. There isn't a button. So lets try this instead...
Remove the power cord and wait 20 seconds.
Plug it back in and let it boot (Give it 10 minutes, it's being tempremental)
Try and navigate to the the advanced menu and do a factory restore
If that doesn't work then if you are using the white remote hold down the menu button for six seconds and release this should bring up a hidden menu which will allow you to access the advanced configuration settings.
Again, if this fails there isn't much to do than tap it with a hammer to see if that fixes it (hard to believe how many times that actually works. (No responsibility taken if it breaks!, but at least you'd have a good reason to buy Apple TV 3) -
I have a macbook pro 10.8.5 and the Application Safari will not open no matter what i do, I try to open the menu of Safari but it won't let me either, the mouse will just be loading. Each time i open it, it says "Application Not Responding" and I try opening it in my Finder and it'll say "The Application 'Safari' cannot be opened." and below that it'll say "-1712" Please help? I would really like to open it again.
The application Safari can't be opened -1712
What to do about "The application 'Safari' can't be opened" -1712 ? -
Tried to upgrade to osx 10.9 from 10.7 and I didn't notice that it downloads in the launcher. I turned my mac off and ever since then it has glitched out and will not download no matter what I do. I have had it for 3 years which is out of warranty. It now has a blank bar under the launch pad and no matter how many times I try re-downloading it or restarting my computer it does not work. I use too play starcraft and other games on this computer although new patched/updates have made it that I can no longer do that now. Really frustrating having to deal with this especially after buying this computer upfront and now out of warranty.
Go to your Applications folder and find a file called "Install OS X Mavericks". Send it to the trash and delete it. Then try the download again.
-
just got an Ipad and am working on setting it up. the one issue I am having with it is my screen will not rotate no matter what I do to the settings, I can't figure out if I have a setting wrong or if there really is something wrong with my Ipad. any help would be greatly appreciated.
Double click the home button (square) and all the things you did are there.keep sliding the bar that will come up on the bottom to the left till it cant go anymore there should be a icon looking like this.press that and it should work
Good luck hope it works. -
I have a mid-2010 27" Quad Core i5 iMac running 10.8.3. Startup disk recognizes the primary hard drive as a startup volume but will not boot from it. Have tried zapping PRAM, ran disk utility. No errors reported Any thoughts?
My bad Eric. The startup preference recognizes the primary as a 10.8.3 startup volume but when u select it the system does not boot. I can only boot from my external backup drive
Maybe you are looking for
-
Balance Carried Forward problem
Hi Experts, when running the Ledger for one range of posting period, the customeru2019s line items and cumulative balances are separated into 2 different reconciliation accounts. While running for the next yearu2019s posting period , the Carry Forwar
-
Setting priority on Unit Tests - is it possible?
Is it possible to set a priority level (low, medium, high) to the units within a test package. Not on the test cases, but when the test plan is generated the option "with transaction" is selected. And we are testing the unit/transaction can you set a
-
I'm wondering if anyone else is having the problem of iTunes 11.1 not showing the number of plays of a song. With the previous version of iTunes - when I plugged my phone into my computer it would automatically launch the program and I could see wha
-
Ora-07445 When tried to select a view using where clause it got disconnectd
select * from v_my_view; plan group_name plan_id plan_one group_one 101 1 row selected. when I tried select * from v_my_view where plan_id='101'; It got disconnected and show to end of communication error Current verson of database I am working with
-
Synchronization of EBOM with MBOM- ehp 5 question
1. We are currently using custom programs to download multi-level Engineering BoMs to Plant BoMs. Will the ehp 5.0 functionality do this function as a part of EBOM - MBOM synchronization? 2. If MBOMs are modified specific to plants will these change