IPod Touch Stopped Working With Car Stereo

Hello Everyone,
I have an iPod Touch 4th generation that was working perfectly with the after market car stereo in my truck  The Stereo is an Alpine CDE-102 and I am using the iPod interface and correct cable.  After upgrading to IOS6 the car stereo fails to reconize the device and "SEARCHING" for a few minutes then gives the response "error - 1".  Has anyone else seen this or know of a solution?  Thanks!

I apologize for posting a bit early.  Found an Alpine manual online and i needed to set the AUX port to off.  They also recommended a reset of the Touch.  After doing these two things it is now working.  Maybe this will help someone else.

Similar Messages

  • Why did my 4th generation iPod touch stop working with my docking station?

    I have an Altec docking station and my iPod suddenly stopped working on it.  The station comes on and makes a beeping noise like it is connected when I insert the iPod.  However, the music will only come out of the iPod.  The docking station will charge the battery on the iPod, so I assume it isn't broken. 

    - While charging try resetting the iPod:
    Reset iPod touch:  Press and hold the On/Off Sleep/Wake button and the Home
    button at the same time for at least ten seconds, until the Apple logo appears.
    - Next try restoring the iPod via iTunes.  First from backup and if still problem restore to factory defaults/new iPod.
    - However, I really think that the iPod has a hardware problem and an appointment at the Genius Bar of an Apple store is in order.  If defective Apple should give you a refurbished iPod.

  • IPod Touch 3G w/ stopped working with car stereo/docking speakers

    After I upgraded to OS 4, my iPod Touch 3g stopped working through the USB port of my car stereo (just says "reading" and never progresses from there). It also stopped working through the docking station (basically a large clock radio) that I bought for my living room -- it will recharge and play music through the speakers but the docking station and its remote can no longer control the music (can't advance to the next song or anything else), so I have to physically change things on the ipod itself.
    I was told by Crutchfield (where I'd purchased the car stereo) that this was a known problem with Apple -- that with OS4, many of the devices that previous worked with iPods no longer worked, and that this would be resolved in a later version of the OS that would provide some backward compatibility. However, I can't find anything at all about this.
    If anyone knows more information about this, or has a link to where I might be able to read more, I'd appreciate the info. I selected and installed both the (almost new!!) car stereo and docking station specifically because they allowed me to connect and control my iPod, and now I've lost that functionality and the $$ I put into those devices (over $300 total)!

    I apologize for posting a bit early.  Found an Alpine manual online and i needed to set the AUX port to off.  They also recommended a reset of the Touch.  After doing these two things it is now working.  Maybe this will help someone else.

  • IPod no longer works with car stereo since upgraded MBA & iTunes

    My iPod classic has worked just fine connected to my car stereo since i bought it last june. I just bought a new Macbook Air (OS 10.7.3) & installed ITUNES 10.6.1. After I synched my ipod for the first time its recognised by the car but i get a "can't read data" message. I re-formatted my ipod but its exactly the same. Do you think its the upgrade- or the cable? Has anyone else found a bug with this version of Itunes or the OS? I have my doubts a cable would make the difference, and my old ipod nano that i haven't synched for a while works fine.

    If standalone works fine, then, most likely the 30 pin connect may have some dirt or lint, prevent data transfer.
    You can try to blow it clean, if you have a can of compressed air or gas.
    Alternatively you can connect it to the car stereo and do the RESET, while connnected.as follows
    Toggle the Hold switch, make sure you dont see the red mark when you do the  next step
    Reset the iPod -> Press Menu and Center button simultaneously for about 10 secs or till the Apple Logo comes ON
    Then release the buttons
    Select your preferred language.
    Here is the Apple support Article on the 5Rs
    http://www.apple.com/support/ipod/five_rs/classic/
    The Reset sequence may send a signal to the Car stereo to do the right thing

  • IPod Touch stopped working with iTunes with OS upgrade

    I have a problem with my iPod Touch connecting to iTunes. It is a new
    It has worked fine in the past, but stopped working once I upgraded from OS 10.4.x to OS 10.5.. I can still see/ sync my old 3rd generation iPod just fine.
    I am currently using iTunes 8.0.1. The iPod is charging fine with the cord provided. The iPod works fine, but I would like to load the Apps I purchased and update the podcasts I listen to.
    Any suggestions will be appreciated.

    I apologize for posting a bit early.  Found an Alpine manual online and i needed to set the AUX port to off.  They also recommended a reset of the Touch.  After doing these two things it is now working.  Maybe this will help someone else.

  • IPod Touch not working with Sony Stereo, and its not the stereo

    I just bought a Sony Stereo with an iPod Dock, it originally played my iPod Touch the first day I had it, but now it doesn't. The stereo works with other iPods in the house so I know it isn't the stereo. Could there be something wrong with my iPod?

    You didn't mention which Sony with built-in iPod dock, so if I am to assume it's the same as mine, the CMT-BX20i, it still works fine for playing and charging. Does the IPT charge/sync with the USB cable still?
    Welcome to Apple Discussions!

  • Ipod touch stopped working with my wifi

    I had iPod Touch (4th Gen) 32Gb, for Christmas and it worked fine on wi-fi network from first day. However got up Monday morning and found it just wont connect to home wi-fi. Tried friends wi-fi next door and same problem. Not knowingly changed any wi-fi settings. Have tried the following:
    Re-set IPod Touch wi-fi settings
    Re-Set Own Home Wi-Fi
    Upgraded firmware on Router
    Next door has re-set their wi-fi
    On both wi-fi networks non-apple laptops can still connect to both wi-fi networks.
    Both homes are on different ISPs - Virgin and Sky
    However can connect to work wi-fi network
    At home just sits with attempting to connect to wi-fi symbol spinning but never completes. Have even turned off Authentication (WPA Personal) on own wi-fi and still no connection

    When you said, you "Re-set IPod Touch wi-fi settings" in your first post does that mean that you used Settings > General > Reset > Reset network settings?
    What router make/model are you using? Have you tried restarting your router (not reset) by removing power to it for 30 seconds?
    If you have no success on either your network or your neighbor's then, unfortunately, your iPod might have developed a hardware problem. You could try using iTunes to restore it to factory setting to see if you can get it functioning again.
    If that doesn't work it's probably time to call Apple support.

  • Alright, so my ipod touch stopped working, but I can still connect it to itunes, but my friend gave me his old nano. I was wondering how I could get my more updated songs from my ipod touch onto the shuffle. My laptop crashed whish had all my new music

    Alright, so my ipod touch stopped working, but I can still connect it to itunes, but my friend gave me his old nano. I was wondering how I could get my more updated songs from my ipod touch onto th nano. My laptop crashed whitch had all my new music, and im afraid if I sync my Ipod touch to the desktop with all my old songs, ill lose all my newer ones which I dont want to happen because I want them on my nano. Im sorry for the confusing topic im just so lost.

    All you have to do is connect your new iPod to the computer that has the library for your old iPod.
    When iTunes comes up, click on your new iPod under Devices.
    At the top of the Summary Page click Music.
    Click Synch Music.
    Do the same thing for Photos, Apps, Movies and so on...
    Now just synch the iPod.

  • My ipod touch isnt working with itunes so i can put new music on it and it keep saying that my ipod is a camera device so what should i do?

    my ipod touch isnt working with itunes so i can put new music on it and it keep saying that my ipod is a camera device so what should i do?

    Hi heggedus,
    This article contains information on iTunes Store connection issues:
    Can't connect to the iTunes Store
    http://support.apple.com/kb/ts1368
    Take care,
    - Ari

  • HT1386 My ipod touch stopped working.

    My ipod touch stopped working. I get the message connect to itunes but I cant because my ipod is locked with password. What can I do

    Place the iPod in Recovery mode and connect to your computer and restore via iTunes.
    Next try DFU mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

  • IPod touch stopped working when charging now won't turn on at all

    iPod touch stopped working when charging now won't turn on at all

    Try in order:
    - After charging or half an hour, reset the iPod:
    Reset iPod touch:  Press and hold the On/Off Sleep/Wake button and the Home
    button at the same time for at least ten seconds, until the Apple logo appears.
    - Connect the iPod to the computer and if it shows in iTunes, restore the iPod via iTunes.
    - See if placing the iPod in recovory mode will allow iTunes to see the iPod so you can restore the iPod. For recovery mode see:
    iPhone and iPod touch: Unable to update or restore
    - Make an appointment at the Genius Bar of an Apple store since you likely have a hardware problem.

  • IPod Touch stopped working and is in recovery mode. What to do?

    My daughters iPod touch stopped working today. It has a picture of an USB cable pointing to the blue iTunes icon. IMac says it needs to be restored and I don't want to lose her content on the iPod. What to do?

    You have to restore the iPod. That is the only way. Your iPod is sick.

  • My sons iPod touch stopped working, it won't charge in a docking station and the computer/itunes won't recognize it when connected.  We have tried holding the power and home button at the same time for several seconds, and the screen still stays black

    My sons iPod touch stopped working, it won't charge in a docking station and the computer/itunes won't recognize it when connected.  We have tried holding the power and home button at the same time for several seconds, and the screen still stays black.  Thanks!

    Hello skdog I possibly think your ipod touch is black because it has not charged. If your dock is broken it might just mean the dock will be broken and so might be the USB port. You should see an Apple shop nearby and hand it over and see what they can do. I hope this information works!

  • My ipod touch stopped working out of no where and now it wont turn  on what should i do?

    my ipod touch stopped working out of no where how do i turn it on?

    Try a hard reset.
    Basic troubleshooting steps. 
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD  120G Vertex 3 SSD Boot HD  

  • Does the Ipod Touch 4G work with any Wireless G Router?

    I have a Netgear WGR614 Router(wireless-G). Will the Ipod Touch 4G work with it at all? Please respond. Thank You.

    lllaass wrote:
    It should work since the 4G supports a, b,g, and n bands. However, some users have reported problems with older routers. I have an older b/g LinkSys router and my 4G iPod and iPad works fine.
    Hi IIIaass. If you have problem with older routers, Apple recommends you update the router firmware.
    Regards
    Andy

Maybe you are looking for