ISE 1.2 - Multiple NICs/Load Balancing for DHCP Probe

Question

Hello guys
Just prepping an ISE 1.2 patch 8 setup in our organization. I am going for the virtual appliances with multiple NICs. It will be a distributed deployment with 4 x PSNs behind a load balancer and there is no requirement for wireless or guest user at the moment. I've got 2 points I will like to get some guidance on:
Our DC has a dedicated mgmt network and I plan to IP the gig0 interface of the PANs, MNTs and PSNs from this subnet. All device admin, clustering, config replication, etc will be over this interface. However, RADIUS/probe/other user traffic to the ISE PSNs will be over the gig1 interface which will be addressed from another L3 network. Is this a supported configuration in ISE?
I intend to use the DHCP probe as part of device profiling and will ideally like to have just an additional ip helper to add to our switch SVI config. Also, it will appear that WLCs can only be configured for 2 DHCP servers for a given network so another consideration for when we bringing our WLAN in scope. We however use ACE load balancers within our DC and from what I have read, they do not support DHCP load balancing. Are there any workarounds to using the DHCP probe with multiple PSNs without having to add each node as an ip helper/DHCP server on the NADs?
Thanks in advance
Sayre

Answer 1

Hello Sayre-
For Question #1:
Management is restricted to GigabitEthernet 0 and that cannot be changed so you should be good there
You can configure Radius and Profiling to be enabled on other interfaces
Even though you are not using guest services yet, you can dedicate an interface just for that. As a result, you can separate guest traffic completely from your production network
Take a look at this link for more info:
http://www.cisco.com/c/en/us/td/docs/security/ise/1-2/installation_guide/ise_ig/ise_app_c-ports.html
For Question #2
If you are using a Cisco WLC and running code 7.4 and newer you don't need to mess with the IP helper configurations. 
The controller can be configured to act as a collector for client profiling and interact with the DHCP thread along with the RADIUS accounting task that is running on the controller. The controller receives a copy of the DHCP request packet sent from the DHCP thread and parses the DHCP packet for two options:
–Option 12—HostName of the client
–Option 60—The Vendor Class Identifier
After this information is gathered from the DHCP_REQUEST packet, a message is formed by the controller with these option fields and is sent to the RADIUS accounting thread, which is in turn transmitted to the ISE in the form of an interim accounting message.
Both DHCP and HTTP profiling settings are located under the "Advanced" configuration tab in the WLC
On the other hand, you can also use Anycast for profiling. You can check out some of Cisco Live's sessions for more info on that. Here is one that is from a couple of years (There are more recent ones that are available as well):
http://www.alcatron.net/Cisco%20Live%202013%20Melbourne/Cisco%20Live%20Content/Security/BRKSEC-3040%20%20Advanced%20ISE%20and%20Secure%20Access%20Deployment.pdf
I hope this helps!
Thank you for rating helpful posts!