Mini 1010nr USB not working

I have a HP Mini 1010nr running ubuntu 10.10 and none of my USB ports are working. I have checked if it is an OS problem and its not. the USBs are not even showing up in the bios. I know there are bios updates available but I cant flash my bios because my usb ports aren't working. Any help is appreciated.

A BIOS update would not be likely to fix bad usb ports. The trouble is that there is no support for Linux from HP. I have also put the Ubuntu netbook edition on a couple netbooks and had no problems. All netbooks have essentially the same hardware with an intel Atom processor and an intel 945 chipset, which is mainstream and supported by any 2.6 Linux kernel. If the BIOS does not give you the option to boot from an attached usb stick or a usb floppy drive I hate to say it but I think you have a motherboard issue. The only way to be sure is to roll back to Windows but that will be tough with no usb ports.

Similar Messages

The device mini iPad is not working after the update of the system

Hello,
I need help that my mini iPad is not working at all. I started an updating process from the system but then it shuts down and it never opens again! even though the charge is full.
please replay me .
Best,
Mawaddah

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar

Mini player does not work, can only switch playlists by closing and restarting iTunes

For the last few versions of iTunes, my mini player does not work, only choices are large window and larger window. Also, if I am listening to a playlist and hit the pause button, then switch to another playlist, the old playlist keeps playing when I hit play. The only way I can figure out to switch playlists is to quit and relaunch iTunes.

try rebooting the ipad
you know holding down the on button and the home button until the slider comes
and turn it off and start it up again

Auto-Brightness on iPad mini Retina is not working properly.

Hello! Noticed that the Auto-Brightness on iPad mini Retina is not working properly.
It works correctly only when such a dark place, then unlock the iPad brightness will be at a minimum. Likewise, if unlock iPad in a room with light, the brightness will adjust to the surrounding space.
If I turn light into a dark room, the brightness slider does not move, and stands on the site. Checked on the iPhone 5S, there problems are not present. Auto Brightness is working correctly.
P.S. Sorry for my bad english!

Godly19 wrote:
iPad audio output does not work, except for on Siri. The mute button is not on, and the volume buttons have no effect/ don't work (unless Siri is open). I have reset the iPad, tried iOS7 and iOS8 resets, which didn't help.
iOS 8 isn't even out yet. If you are running iOS 8, I assume you are a developer and if you are, you are in the wrong forum to try to get help. If you are not a developer and you're running iOS 8, maybe that's why you are having problems on the iPad.
The audio output mostly works when headphones are out in, but has a tendency to cut out from time to time. Without headphones, Audio might start working again briefly from time to time, but most the time it doesn't. Any ideas on what is wrong with it and how to fix it?
The type that I made bold doesn't make sense. Is this a typo and you mean that " headphones are not in"?
I did take it to an Apple Store, but the inncorrectly insisted that my speaker was bust and it would cost £250 to replace the whole iPad!
And you know they are incorrect because you get sound here and there from time to time? That fact doesn't prove that something isn't working correctly inside. You could very well have a bad connection inside the device causing this, but somehow you seem to know that's not the case.

Dual Monitors on Mac Mini Late 2014 not working on Dell S2340Lc

Hey guys,
Got a mac mini and using it mainly for work. Working for an ISP and no one has used macs and I've opted to be the poor sucker that gets to deal with old people that don't know how to mac very goodly.
I have two Dell S2340Lc monitors. I have one connected up via HDMI and that works perfectly fine. I turned off the mac, I plugged in Monitor 2 with a MiniDP/Thunderbolt to HDMI adapter, powered on the mac and whilst it was booting, it had the Apple logo and the loading bar on the Dell display plugged in to the thunderbolt to hdmi adapter and then once it loaded up the log in screen, it went to the HDMI display. I logged in and in the displays section, the monitor plugged in to the thunderbolt to hdmi adapter isn't being detected, however I can plug it in to a Samsung 55 Inch Smart TV and it works just fine. I can set up dual monitors between the TV and the monitor in HDMI, but the Dell S2340Lc will only work with a HDMI cable into the HDMI port on the mac mini and will not work through the thunderbolt to hdmi adapter. On the display it just says that there is no signal coming from the computer.
Just wondering if any of you apple gurus had any ideas as to why this isn't working?
Thanks!

What if you switch monitors?
What happens if yo only have the Thunderbolt>HDMI>Dell monitor connected?
Try resetting the SMC and PRAM
Intel-based Macs: Resetting the System Management Controller (SMC)
About NVRAM and PRAM
Call Apple. You get 90 days or free telephone support
Complimentary Support (USA)

Bluetooth AND USB not working

Hi friends i'm facing 2 problems1. my bluetooth is not working properly, initially it wont show any blutooth icon when i start up, but after i restart it shows and start working, every time i need to repeat this to use bluetooth. kindly suggest me the solution.2. the usb ports (3.0 and2.0) both doesnt work properly, they only detect devices wen i go to device manager and scan for hardware devices.

I was also worried that bluetooth is not working. But eventually came to know that this model 15R203TX has bluetooth version 4.0 which is backward compatible to other bluetooth devices of version 2.0 to 2.1 EDR. Means if your hand set or any bluetooth device is having version 2.0 or 2.1 EDR it won't able to send any data or see this laptop model while transferring data. Moreover if you try to send data from laptop to other bluetooth device irrespective of version it is able to send data. Now it is Same with WiFi this model is backward compatible to IEEE 802.11 a/b/g. means you can't receive signals from this devices unless the router is having IEEE 802.11 b/g/n/ac. For USB not working may be its a BIOS issue. While boot up try to press F2 key. And enter the diagonistic blue page. There you can check the version of BIOS or try to reinstall the updated BIOS by downloading it from HP support. If USB still not woking then try to go to nearest authorised HP service centre.

HP mini that has not worked in a year at least.

We have an HP mini that has not worked in a year at least. I am trying to get it working again and am getting a screen that said: enter administrator password or start on password. Then system disabled 83656543. can you please help?
This question was solved.
View Solution.

Hi,
Shut down the notebook. Tap away at the esc key as you start the notebook to enter the Start-up Menu. Select the Bios option ( f10 ) and under the Advanced or Diagnostic tab you should find the facility to run tests on both the Hard Drive and Memory.
Post back with the details of any error messages.
Note: If the option to run these tests is not available in the Bios Menu, use the f2 diagnostic menu instead.
Regards,
DP-K
****Click the White thumb to say thanks****
****Please mark Accept As Solution if it solves your problem****
****I don't work for HP****
Microsoft MVP - Windows Experience

I bought Hp 15 g207ax, 2 out of 3 usb not working, and all drivers missing, no ethernet or no wifi

i bought a new Hp 15 G207AX.
issue 1 - 2 out of 3 usb not working, 1 usb 3.0 and 1 usb2.0 not working. 1 usb 2.0 is working properly
question 1- is it because of faulty laptop or driver issue? also, if it is driver issue, then why 1 usb 2.0 is working?
issue 2 - All Drivers are missing.
question 2 - where can i find all the drivers?
issue 3 - no ethernet and no wifi connecting
question 3 - is there a driver for ethernet too? can you tell me what drivers i need to install for ethernet or wifi. because without those, i cant do anything?
looking for your immediate reply. as if in 1st question, if usb ports are defective and laptop is faulty, i will ask for a replacement or refund.

Likely all of these issues would be fixed with the chipset driver.
Did you look at the solutions listed in that other forum post I linked to above?
...an HP employee just trying to help where I can, but not speaking on behalf of HP.

My iPhone5s dropped in pool, for 15 min it is not working at all please advise what to do even it is new since two months only ???

My iPhone5s dropped in pool, for 15 min it is not working at all please advise what to do even it is new since two months only ???

Get US $269, then make an appointment at any Apple store, do an out of warranty exchange.
iPhones seldom, if ever, fully recover from water exposure like that.

ADC Studio Display 17" USB not working

Hi,
I hope someone can help.
I have a 17" Apple Studio Display that connects via ADC left over from my old Powermac G4. I recently bought the new Mac Mini (Unibody) and an Apple DVI to ADC Display Adapter to use with the HDMI to DVI Adapter to connect with the Apple Display.
This works perfectly however I have noticed the USB ports on the back of the display does not work. Could this be because the Apple DVI to ADC Display Adapter can not supply enough power via the connected HDMI to DVI Adapter to support the display and its USB ports? Is there a way too get them working again?
Thanks.
Chris

Hi. Thanks for that. As you say there must be something wrong with my display's USB circuitry then.
Just one more question, is the USB cable from the DVI to ADC adapter only for supplying power to the USBs on the display? Since the display's USBs are not working, will the adapter still work and power my display without using the USB connecter from this adapter? If so this will free up one of my USB2 ports on the mini.
Thanks again.

Why does my usb not work

Hello i'm Oskar
and i have an usb charged spy pen, but it won't work with lion when i'm trying to move my video files from the same usb pen.
it's using the same usb for both charge and files transfer but when i connet it to my mac it's just start charging and it will not appear as a disk:)
Oskar

Hey guys,I have a 2014 Kia Optima. After calling Kia,after going to Kia Dealership,after going to Best Buy Geek Squad I would still get the message iPod connection error. It's a very easy fix. If your iPod does not have the latest Version it may not work. Look in your settings to see if you have 1.3 version (as if 7-30-14) if not go to iTunes download new version and mine WORKED!!!! It now reads and shows all into from iPod.Hope this works for you guys

USB not working with lion upgrade

I am having the same issues with my Mac mini and MacBook. The USB is not working! Help!

Have you upgraded to 10.7.3? Have you reset SMC and PRAM?
SMC:http://support.apple.com/kb/HT3964
PRAM:
Shut down the computer.
Locate the following keys on the keyboard: Command, Option, P, and R. You will need to hold these keys down simultaneously in step 4.
Turn on the computer.
Press and hold the Command-Option-P-R keys. You must press this key combination before the gray screen appears.
Hold the keys down until the computer restarts and you hear the startup sound for the second time.
Release the keys.

Micro USB not working on 9300

I got yesterday the two Duracell cell USB chargers ( Instant and PowerHouse) and it is very funny but I can not charge my blackberry. I used obviously the micro USB, try different cables, lenghts, etc...and there is no way to charge it. Even a friend of mine has a Torch and it did charge either.... It charges my kindle, Droid;( all of them micro USB) but no the curve 9300 Any experience with the Duracell or other usb micro chargers othe than BB?

Might not be the answer you are looking for but I have used my BB USB cable on other phones like Nokia 2700, E63 with no problem, USB cables usually come as a standard so they should work on multiple devices. I dont think the USB chargers you have are made differently. One thing I know for sure is that if the battery is drained to 0% then USB charging will not work. I will look around and try another cable type and see if it does not work.

K7T Turbo limited - USB not working

I have a K7T turbo limited edition motherboard. The rear usb ports work fine. There are two USB ports on the front which do not work. appreciate any ideas on how to clear up this problem.

https://forum-en.msi.com/index.php?threadid=52338&sid=
one to many wire is usual problem

Mini DVI-Adapter Not Working

Today I went to the Apple Store and got myself one of those fancy new Mini-DVI to DVI adapters, hoping it would work with my screen at home, which I had previously running on the Mini Displayport to VGA Adapter on my original MacBook.
Strangely, when I plugged the cable into the adapter, and into my computer, nothing happened. I did not get video on the screen, nor did my MacBook detect it. I have tried re-plugging the Mini-DVI adapter and clicking Detect Displays in the Displays Preferences multiple times, but no luck.
I have seen the screen work with DVI about a year ago, but that was on one of the original MacBook Pros. Am I better off returning this DVI adapter and instead buying a Mini-DVI to VGA Adapter?
Thanks for any help in resolving this problem.

I have a 22 inch ViewSonic that I got from a friend about a year ago. I did indeed plug the monitor directly into the adapter.
I brought my computer, adapter and cable all into the Apple Store, and they said it was all OK, but did replace my DVI adapter thinking it was probably defective. I got home, tested it on my monitor, but still not working. I tested it on a newer HP monitor that's on the family computer, and oddly it worked there.
A bit of research revealed that the adapter did not send Analog signals on DVI anymore, which confuses me, since the MacBook actually does have Analog signals on that port. I brought my DVI adapter in original packaging in to the Apple store again, and they replaced it with a VGA adapter for free, and sure enough, that solved the problem for me.
Lesson Learned - don't use DVI with older monitors, stay with VGA.
Message was edited by: theocas

Mini 1010nr USB not working

Similar Messages

Maybe you are looking for