Most of the time Thunderbird only opens incoming mail with a double click in a new window which I find infuriating so is there a workaround or a fix for this?

When Thunderbird starts, it opens incoming mail into the lower panel with a single click. But after an hour or two this no longer works and i have to double click to open the message which goes into a new window.

''abowie [[#question-1040591|said]]''
<blockquote>
When Thunderbird starts, it opens incoming mail into the lower panel with a single click. But after an hour or two this no longer works and i have to double click to open the message which goes into a new window.
</blockquote>
''Matt [[#answer-675789|said]]''
<blockquote>
sounds like a bad add-on to me. Restart holding the shift key and see if the issue arises again.
</blockquote>
Thanks for your response, Matt. I have now run for a fortnight without having to double click to see a new message. All add-ons are disabled and the trick will be to eliminate them one by one till I find the culprit.
Cheers, Alan

Similar Messages

I bought me and my wife a iPhone 4 32G and it turns out that she gets better signal then me mine keeps going in and out of service most of the time i only get one bar how can i fix this?

I bought me and my wife a iPhone 4 32G and it turns out that she gets better signal then me mine keeps going in and out of service most of the time i only get get one bar how can i fix this?

Restore as new in itunes and try again.

Disk utility Failure/Unable to open Hard drive with a double click

After trying to use Disk Warrior for maintanance last week my entire hard drive crashed.
I've spent the last week rebuilding only to encounter a new problem..i can not open the hard drive with a double click.
I attempted to run Disk utility to diagnose the problem and was told that the "program had lost connection and was unable to verify/repair disk permissions...and was told to shut down disk utility, which i ran from the install disk...
Any suggestions aside from erasing and rebuilding the hard drive?
Any assistance would be greatly appreciated.
Thanks,
Victoria

Hi Ana,
Try this link Disc Utility lost connection ......
Hope that this will help you to solve the problem.
When this was help full ore solved your problem Why award ponits?
Dimaxum

The top button on my iphone 5 stopped working recently.. Well it works but barely at all if every. Most of the time it only locks the screen if I click on the left side of the button. Also my Camera causes a blue pixelated spot on pictures I take.

The top button on my phone recently stopped working. Well sometimes. Majority of the time if I click it hard enough on the left side of the button it will lock the screen... Otherwise it doesnt work at all anymore. Also the camera appears to be placing a blue pixel on pictures I take. Its annoying. What should I do?

It's completely situational. Without being able to directly compare the "scratch" on the original poster's iPhone with your iPhone, what gaamcc had happen could not be extrapolated to guess what Apple may do in your situation. It will depend entirely on what the Apple technician diagnoses after examining your iPhone. He/she may decide that any damage is strictly cosmetic and didn't have any connection with the problem you're taking your iPhone in for, or he/she may diagnose the problem as stemming from user damage. You'll just have to see when you go to the Apple Store.
Regards.

Quick Time Player doesn't open WMV files with a double click.

After I download a WAV file and double click on the file; a message appears install "Quick Time Player must be installed to run this application;" however when I open Quick Time Player and select the file it plays with no issues. My question is why would I be getting this message after upgrading to Snow Leopard?

you do have QT player installed. you just need to associate wmv files with it. select a .wmv file in finder and enter command+i. in the popup go to the "open with" section set it to open with QT player and click "change all".

TS3276 why can't i open SOME attachments from email and most of the time i can open them?

why can't i open some attachments from some emails and not on others?

Read this link from Apple for more info:
http://support.apple.com/kb/PH11778?viewlocale=en_US&locale=en_US
The Apple Communities is a free information resource, but posting the eventual answer helps future users to learn solutions.

With firefox open, it will not automatically open again. I have to click on file/new window

Hello, on first opening of firefox it automatically opens the home page but then every time I need to open again I have to go to file and either click on new tab/window/location or go to bookmarks and open a page from bookmarks. On my other laptop and PC it's automatically open when clicking on the firefox symbol. Please can you advise the error. I have been onto preferences and can find no solution. Thank you

Given there are so many problems and removed features in Pages 5, why not just continue using Pages '09?
http://www.freeforum101.com/iworktipsntrick/viewforum.php?f=22&mforum=iworktipsn trick
http://www.freeforum101.com/iworktipsntrick/viewtopic.php?t=432&mforum=iworktips ntrick
Peter

When I open a link in a new tab, most of the time it opens to the bottom of the page, and I have to scroll back up to the top or hit the Home key.

When reading a web page, I will right-click on a link and select 'open link in new tab' and most of the time it will open the new page right at the bottom. I then have to scroll up with the mouse or hit the 'home' button on my keyboard to get back to the top of the page. I've already looked at the tab settings in the options menu, and there's nothing there that seems to apply.

Start Firefox in <u>[[Safe Mode]]</u> to check if one of the extensions or if hardware acceleration is causing the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > Appearance/Themes).
*Don't make any changes on the Safe mode start window.
*https://support.mozilla.org/kb/Safe+Mode
You may have switched on caret browsing.
*http://kb.mozillazine.org/accessibility.browsewithcaret
You can press press F7 (on Mac: fn + F7) to toggle caret browsing on/off.
*Tools > Options > Advanced : General: Accessibility: [ ] "Always use the cursor keys to navigate within pages"
*http://kb.mozillazine.org/Scrolling_with_arrow_keys_no_longer_works
*http://kb.mozillazine.org/Accessibility_features_of_Firefox

E-mail won't send most of the time

Ever since my Touch upgraded to the v. 4 firmware I've had trouble with sending e-mail. I don't have as much problem receiving mail...sometimes I can only preview my messages and but most of the time I can open received messages. For a while I couldn't send mail (I use Yahoo and the Touch already had the server settings for it), then after a couple of days it suddeenly started sending again. Now it's not sending! So aggravating!!
The error message says "The connection to the outgoing server "apple.smtp.mail.yahoo.com" failed. Additional Outgoing Mail Servers can be configured in Settings>Mail,Contacts,Calendars." This seems silly because it works - just off and on! Does anyone else have this issue...any solutions? Thanks

majorv~
I am having the same problem. I have an ipod touch that worked fine up until the 4.0 firmware. The only thing I have noticed with mine that it was glitchy when it came to sending mail (which I use yahoo). Then most recently it stopped sending altogether. My isp is verizon & I have an airport extreme. I noticed today I can bounce off of a neighbors linksys wifi. Now I have no clue who their isp is. It's either verizon or comcast. Regardless I was able to send mail using their internet. Mine on the other hand is a no go.
I too am *extremely frustrated*. I have deleted my mail accts several times in hopes of it fixing the problem. I also updated to the latest firmware of 4.1 in hopes of it resolving the issue. I even tried using other smtp servers with no luck.
I hope someone out here has a solution to this problem. It is very frustrating.

IPAD 3 - 3rd Party apps stop working. Only fix is to re-install each app. Is there a fix for this?

I am an IPAD 3 owner. When I install apps such as facebook, twitter, linked-in every week to two weeks the apps stop opening and the only fix is to re-install the entire app. Is there a work-around or fix for this?

Richard, you haven't mentioned if you've tried anything other than a re-install....but if it were me, the first thing I would look at is memory( and other basic) issues...using the restart/reset/restore process...
http://support.apple.com/kb/HT1430
http://support.apple.com/kb/HT1414

ZTE Open hangs most of the times

I've been using ZTE Open for months now but i have a problem. It hangs most of the times. First of all i thought it was an early build(1.0) so i installed 1.1(stable), 1.2, 1.3 and running 1.4 now but the problem is same. It hangs! and when it does i have to lock the phone and wait for sometime to unlock it or just direct remove the battery(sometimes it doesn't solve the problem but sometimes it does). I can't now know for sure that will i be able to receive my incoming call or not?
It just freezes most of the times. Tried so many things like clearing cache installing different ROMs(1.2, 1.3) etc but same problem
Anyone having the same problem?
Any suggestions?

linuxholic,
I have a bit a learning curve with logs, but I am really happy that this issue was resolved for you.
I did find this in your second log
<blockquote>
D/memalloc( 114): /dev/pmem: Freeing buffer base:0x4ccb3000 size:16384 offset:1
409024 fd:159
E/AudioPolicyManager( 118): setOutputDevice() setting same device 0x0 or null d
evice for output 1
I/Adreno200-EGLSUB( 114): <CreateImage:991>: Android Image
I/Adreno200-EGLSUB( 114): <GetImageAttributes:1256>: RGBX_8888
D/memalloc( 114): /dev/pmem: Freeing buffer base:0x4ccef000 size:81920 offset:1
654784 fd:166
D/memalloc( 114): /dev/pmem: Freeing buffer base:0x4cd03000 size:81920 offset:1
736704 fd:199
I/Gecko ( 114): -*- QCContentHelper_QC_B2G: receiveMessage: 'RIL:RegisterMobi
leConnectionMsg' arrived from content process
I/Gecko ( 114): -*- QCContentHelper_QC_B2G: Already registered this target!
I/ONCRPC ( 117): rpc_handle_rpc_call: for Xid: 3d8, Prog: 31000000, Vers: fc37
ad5c, Proc: 00000012
I/ONCRPC ( 117): rpc_handle_rpc_call: Find Status: 0 Xid: 3d8
I/ONCRPC ( 117): oncrpc_proxy_handle_cmd_rpc_call: Dispatching xid: 3d8
D/SST_QC_B2G( 114): Signal Strength changed; sending info to content process
D/SIGNAL_STRENGTH_QC_B2G( 114): GetDbm = -57
D/SIGNAL_STRENGTH_QC_B2G( 114): GetRelSignalStrength = 90
D/SIGNAL_STRENGTH_QC_B2G( 114): GetDbm = -57
D/SIGNAL_STRENGTH_QC_B2G( 114): GetRelSignalStrength = 90
I/Gecko ( 114): -*- QCContentHelper_QC_B2G: sendMessage to content process: R
IL:VoiceInfoChanged{connected : true,emergencyCallsOnly : false,roaming : false,
type : 'unknown',signalStrength : -57,relSignalStrength : 90,network : {mcc : '4
10', mnc : '07', longName : 'WaridTel', shortName : 'Warid'},cell : {gsmLocation
AreaCode : 711, gsmCellId :44393},state : 'registered'}
I/Gecko ( 114): -*- QCContentHelper_QC_B2
</blockquote>
Something was incoming to freeze the buffer then a process went in to change the setting of the network connection strength. But I do not speak log. If the issue did continue though, what I meant by steps were the exact actions you took while you were capturing the logs. These steps help when filing a bug in bugzilla.

When i go to 'New Folder' the name box only opens for a second so I dont have time to name it correctly. Rename Folder does the same thing - any thoughts??

when i go to 'New Folder' in outlook the name box only opens for a second so I don't have time to name it correctly. Rename Folder does the same thing. Any thoughts? Many thanks.

Hi Clint,
Did you get a reply from anyone for this problem? I'm having the same problem and wondering what the resolution might be.
Thanks

With version 5 of Firefox, if I open more than 1 session, most of the time I cannot see anything in the navigation bar and my back and forward buttons do not work.

I open 1 session of Firefox 5.0.1 and everything seems to work fine. Then I open a second session of Firefox and most of the time the navigation bar does not show the page that I am on and the back and forward buttons do not work. When this happens, the first session always remains working. I am an internet marketer so I have at least 2 or 3 sessions going at any given time.

A possible cause is a problem with the file places.sqlite that stores the bookmarks and the history.
*http://kb.mozillazine.org/Bookmarks_history_and_toolbar_buttons_not_working_-_Firefox
Start Firefox in <u>[[Safe Mode]]</u> to check if one of the extensions is causing the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > Appearance/Themes).
*Don't make any changes on the Safe mode start window.
*https://support.mozilla.com/kb/Safe+Mode
*https://support.mozilla.com/kb/Troubleshooting+extensions+and+themes

Most of the time when i click my magic mouse on an item it gives me options like back, open new page, etc.

When I try to use my magic mouse, most of the time it won't open an item but instead will give me options like: back, open new page, open link in new window, and I am actually on top of for instance, the comment field in facebook...It takes several attempts of clicking off the entire page to get it to just open the link or respond appropriately...

the mouse performs a right click instead of a left click. Check your mouse preferences in the system settings.

Photoshop cs6 with OS X Yosemite, I open a new layer and i paint on it but if I use cmd Z it does not undo fluently the most of the time.

Photoshop cs6 with OS X Yosemite, I open a new layer and i paint on it but if I use cmd Z it does not undo fluently the most of the time.

Grab the plug-in posted here: http://helpx.adobe.com/photoshop/kb/photoshop-menus-turn-white-mac.html
That should get everything working as expected on Yosemite.

Most of the time Thunderbird only opens incoming mail with a double click in a new window which I find infuriating so is there a workaround or a fix for this?

Similar Messages

Maybe you are looking for