Multiple results recording for Delivery inspection lot

Question

Hi Gurus,
My requirement is to configure for quality results recording for sales delivery document. Where client wants to record Customer, supplier, Umpire, etc results record for inspection characteristics.
I got response from few Sapiens that I should use Inspection point concept for multiple results recording. Could anyone cna tell me how can I do this.
Your help will be highly appreciated.
Thanks,
Kumar

Answer 1

Hi Kumar,
Okay!
First of all letu2019s try to understand whether inspection points are really suitable for your requirement or not. Accordingly further errors can be eliminated. I just try to understand.
A- Using Inspection Points
1.     Inspection points are used when you inspect the same parameters again and again.
2.     When you click on results tab in QA32, system asks you put some identification number. Letu2019s say you put A1 and then press enter. Thereafter you record the actual results (LENGTH, WIDTH etc.) You save this without giving UD.
3.     For the next time when you again click on results for the same inspection lot, system again asks you to put identification number. This time suppose you put A2. Then again you record the results (LENGTH, WIDTH) for A2.
4.     Likewise you can retrieve the inspection results from system with respect to inspection point (identification point).
5.     Typically this can be used for chemical industries where you record the temperature of the same chemical after every ½ an hour. Here 10:00 am, 10:30 am can be used as identifications numbers. As a result of which you can get the information that at 10:00 am temperature was 40 Deg and at 10:30 am it was 75 degree Celsius.
If your requirement resembles this situation, then only the use of inspection points would be fruitful.
B- Without Inspection Points
But if you want to record the readings by various agencies like customer, umpire (refer following pattern)and want to compare them there are other ways.
1.     Reading by your inspector
a.     LENGTH u2013 100, 101, 102mm (average is 101mm)
b.     WIDTH     - 10.50, 10.50, 10.60mm (average is 31.6mm)
2.     Reading by customer
a.     LENGTH u2013 100, 101, 102mm (average is 101mm)
b.     WIDTH     - 10.50, 10.50, 10.60mm (average is 31.6mm)
3.     Reading by umpire
a.     LENGTH u2013 100, 101, 102mm (average is 101mm)
b.     WIDTH     - 10.50, 10.50, 10.60mm (average is 31.6mm)
You can achieve this without using inspection points also. For this in QP02 you need to create 3 operation; Inspector, Customer and umpire respectively. Feed the MICs in each of these operations. When you click on result tab system will throw pop up for these 3 operations. Double click on Umpire if you want to record results noted by umpire. Likewise for rest of the operations. You can do this even after UD also (after 1-2 months also). You need to use MIC with control indicator as long term characteristics for this in QS23.
Regarding averaging of results u2013 This can be achieved using single result recording MIC with or without inspection points. Use appropriate sampling procedure. When you feed results in QA32 system automaticaaly averages out the reading. This can be viewable against phi symbol.
Finally you did mention that u201Chere I am not getting the newly created inspection lotsu201D. Does that mean inspection lot (10 origin) has not created?
Regards,
Anand Rao