My iPhone 3GS on iOS 5.1 will randomly stop what I'm doing show a black screen then the spinning icon and then it shows my lockscreen. It takes about a minute to do this and it does it about 30 times a day. How do I fix this?
My iPhone 3GS on iOS 5.1 will randomly stop what I'm doing show a black screen then the spinning icon and then it shows my lockscreen. It takes about a minute to do this and it does it about 30 times a day. How do I fix this? It is EXTREMELY ANNOYING!
No, sounds like when you dropped it an cracked the screen it may have also damaged the logic board or the repair person damaged a cable.
Similar Messages
-
my iphone 4 is just showing a black screen with the apple icon. how do i get it to work?
First, try resetting the phone - press both the home and sleep/wake buttons until the Apple logo reappears.
-
My ipad had an icon on it after being on the charger all night that indicated it needed to be plugged into itunes. I did this, and then it said it was going to do a restore, I confirmed I was ok and then left it on the computer all day and now the best I can do is get the apple icon on a blank screen. It occassionally changes to show that it has no battery and then goes back to the apple icon. How can I restore it? Any other ideas?
(A) Charge your battery
(B)Try and force iPad into Recovery Mode:
1. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
2. Connect USB cable to computer, leave the other end alone
3. Press and hold the Home button down and connect the docking end of cable to iPad
4. Continue holding the Home button until you see the "Connect To iTune" screen
5. Release the Home button
6. Open iTune
7. You should see "iTunes has detected an iPad in recovery mode"
8. Use iTune to restore iPad
Note: You need to be patient and repeat the above many times to recover your iPad -
my new ipad 2 turnes to black screen with the apple icon in the middle while using it or if i just left it locked for a while, it just hanged and i have to restart it?! so why this is happening ?! is there is a productio error or something i can do to prevent doing this ?!
Appreciate responding as soon as possible.No, it's definitely not normal. Your User's Guide recommends a series of troubleshooting steps to go through when your iPad is misbehaving: As you're already in effect doing the first of the main steps, a Restart of your iPad, and that's not curing it, move on to the next .. a Reset.
To do this, press and hold both the Home and the Sleep/Wake buttons for about 10-12 seconds, until the display blanks and the red Power Off slider appears. Continue holding the buttons until the slider disappears, replaced by the black screen and white Apple logo.
This shows your iPad is starting to reboot. Release the buttons and allow the process to continue until the Lock screen appears again, then slide the slider to complete the process. -
My iphone will not turn on.... it froze earlier today and now it will not turn on all i get is a black screen with the apple symbol every once in awhile... also it will not connect to my computer so i can reset it to factory settings
Sammyhunter lets get you back in action! Has there been any physical/water damage to the device? Try pressing and holding the home and power button together. Once the Apple symbol appears release both buttons. Keep us posted!
AshleyS_VZW
Follow us on Twitter @VZWSupport -
Since updating my iPhone 3GS to iOS 4.3.3 I have been unable to sync my photos! Keep getting the error message unable to sync and 'the required file cannot be found.' Please help?
Try deleting the iPod Photo Cache on your computer.
http://support.apple.com/kb/ts1314 -
I upgraded my PC from Win7 to Win8 and installed itunes, when I plug my ipod in it wants to erase it as its sync'd to another PC. How do I fix this a I dont want to loose my playlists?
The iphone is not a storage/backup device. The sync is one way - computer to iphone. The exception is itunes purchases: File>Transfer Purchases
Copy everything from your other library/computer, or your backup copy, to your new library/computer -
Can't get my MacBook Pro to start up. Have shut it down several times and tried restarting but all I get is a grey screen with the spinning icon. Apple Support online suggested starting with power button followed immediately with the shift key. Same results. Also tried power button with shift key, command, and V. Black screen appeared instead with lots of data language but still no starting. This final page was suppose to result in an internal system check and restart but nothing happened and the black screen remains.Where do I go from here? Scheduled for the Genius Bar tomorrow but would like to resolve this beforehand.
You may be having a hardware problem that you cannot resolve on your own. Nevertheless...
...hold down the command and R keys whilst booting to try to get to your Recovery partition. If you can, use Disk Utility to try to Verify your boot drive (usually named "Macintosh HD" unless you've renamed it). If the verification fails, try to repair your hard drive. If everything appears to be OK, restart.
If you can't get into your Recovery partition, your problem is likely hardware related. If so, keep your appointment and see what the Apple techs have to say.
Clinton -
My macbook crashed and I am trying to install my adobe programs again but I can't because he is used earlier by myself. How can I fix this without buying a whole new packet?
Hannahdb1 what specific Adobe applications are you attempting to reinstall? Do you receive any specific error messages? Finally what version of Mac OS are you using?
-
i redeemed my itunes gift card and i got $15 in credit, but when i try to make a purchase it tells me it could not be completed, how can i fix this ?
If you are also getting a message to contact iTunes Support then you can do so via this link and ask them why the message is appearing (we are fellow users, we won't know why) : http://www.apple.com/support/itunes/contact/ - click on Contact iTunes Store Support on the right-hand side of the page, then Purchases, Billing & Redemption
-
Was just watching an HD movie and tried to resize the window midway through. Now I get the error "This movie cannot be played in HD on this display" Yes it can I just was. How do I fix this?
I have the same problem on an original iPad.
-
There is a problem in updating iphoto and iMovie, read a response here from a certain Dahveed if I'm not wrong to try this, however I'm a first time mac user, how do you delete this ... /Mac HD/Library/Caches/com.apple.appstore/adoption.plist
It says 'To update this application, sign in to the account you used to purchase it.'
However I only have one account. I've tried to sign out and in several times. But it doesn't work. I do remember changing my password recently. Secondly I'd like to add that I got this macbook air 3 days ago. I'm a first time mac user. It had three updates initially. Mountain lion 10.8.2, iphoto and the imovie. I updated the mountain lion, thinking I'd get the iphoto and imovie done later. However now this problem has come up. Thanks for responding. Hoping to hear from you soon again regarding this. -
When I try to set up Time Machine, there are no back up disks displayed. Therefore, I cannot turn on Time Machine. How can I fix this?
Thanks - let it finish, but zero out data is unnecessary. That option is intended to thoroughly erase previously recorded data so that it cannot be recovered without sophisticated data recovery techniques.
Case sensitive is OK but I suggest you simply select Mac OS X Extended since "case sensitive" may complicate things for you in the future, should it be necessary to restore files to a case-ignorant volume.
Once it finishes, make sure it appears as a selectable option in Time Machine. If it does your problems are solved, but consider using Disk Utility and reformatting it. This time don't worry about zeroing unused space, and select Mac OS X Extended (Journaled). It will only take a few seconds this time.
For a more thorough description read Apple Support Communites contributor Pondini's FAQ: http://pondini.org/TM/5.html Read the pink box regarding the subject of case sensitivity.
Also: Mac Basics: Time Machine -
HT3275 I can't unlock my setting to allow Time Machine. How do I fix this?
I can't unlock my setting to allow Time Machine. How do I fix this?
What happens when you click the LOCK? You should get a prompt asking for account name and password that has Administrative Priveleges on the Mac. Sometimes this prompt window is hidden behind other open windows.
Perhaps you are logged into an account with even more severe restrictions set by another administrator suing Parental Controls.
Can you unlock any other preferences in System Preferences ? A good think to try would be unlocking security and privacy settings.
Hope this helps. -
I was trying to update my iPhone but now it is frozen on the black screen with the apple icon. It won't do anything. Any suggestions?
Is your iphone hacked/jailbroken?
Maybe you are looking for
-
New Effective CAL essay: How do I create an abstract data type in CAL?
<p><strong>How do I create an abstract data type in CAL?</strong></p> <p> </p> <p>An <em>abstract data type</em> is one whose internal representation can be changed without needing to modify the source code of client modules that make use of that
-
HT1212 my ipod touch is not working
my ipod is stuck on the apple symble
-
All-in-one cleaning cloth & carrying pouch for the iPhone
As I was looking for an all-in-one solution to protect my iPhone in my pocket that could also double as a cleaning cloth, I came up with a low-cost solution. I purchased a cleaning cloth pouch used for sunglasses from Sunglass Hut. While being able t
-
Display community pages under active community tab in left vert nav
Hi, I'm trying to display the community pages in an "active" Comunity under the given Community tab in left vertical nav. I simply need to find out how I can access the community id from the HTMLAnchor so I can compare this community id to commP.GetC
-
I have added new testdocuments in transaction SOLAR02, and I want them to be vissible in the already existing testplan. When I go into change testplan in transaction STWB_2, I receive the message: You wish to change a test plan that was created on th