My ipohn 4 died last night and wont turn on pls help me
my ipohn 4 died last night and wont turn on pls help me
Hi Punkermama,
If the screen on your iPhone is dark but the phone otherwise seems to be responding (sounds, etc), an Accessability feature known as Screen Curtain may have inadvertently been activated. You may find the following section of the iOS 7 for iPhone manual helpful (Apendix A - Accessability, in the Voiceover section on pg 126):
Turn the screen curtain on or off. Triple-tap with three fingers. When the screen curtain is on, the screen contents are active even though the display is turned off.
iPhone User Guide For iOS 7
http://manuals.info.apple.com/MANUALS/1000/MA1565/en_US/iphone_user_guide.pdf
Regards,
- Brenden
Similar Messages
-
My phone died last night and when I plugged it in it wouldn't turn on.I tried restarting it but it has yet to turn on since last night,It was just a black screen,i try the on/off and home buttons together but its not working,What should I do?
How long have you had your phone? Because if you've had it a long time, the battery in the phone might of died on you. Or have you dropped it in water, snow, from high up? All those things could of disconnected something internally in your phone, or permentaly damaged the internal hard drive its self, or the sims card.
-
My battery died last night and the phone switched itself...
My battery died last night and the phone switched itself off. It has now been charging for 5 hours and still will not switch on. Please help.
Remove and reinsert the battery from the device. Also clean the battery and device connectors with a cloth....then plug the device on the charger.
If that fails then you might have to consider changing the battery.
tanzim
If your query is resolved then please click on “Accept as Solution”
Click on the LIKE on the bottom right if the post deserves credit -
My Iphone died last night and efforts to recharge this moring have been unsuccessful, so what next?
Keep on Wall Charger and Reset, hold both Home and Power buttons until the iPhone begins to start. Can take about 20 seconds of holding both buttons while on charger.
-
My iphone turned off last night and wont come back on, is this a normal problem
My iphone4 shut down on me last night and it will not turn back on. It was in my coat pocket and was working fine then all of a sudden nothing. Any ideas what the problem could be and how to fix it
did you end up getting a fix for this
-
My ipod said to restore when I did it went black and wont turn on plz help?
I have an older ipod touch 32GB this morning it said to connect to itunes and restore and when I did it went black and wont turn on. What happened?
If not successful try the remaining items of:
iOS: Not responding or does not turn on -
Last night my laptop died and the time and date was reset. I cannot acess date and time preferences to change it and my laptop is acting really weird. My CD drive is broken so there are no options to put in a cd. Please someone help i need my laptop for school and cannot afford another.
Many system actions will misbehave, given an inaccurate date. Resetting the NVRAM and / or SMC will not fix it, and if the system has a preposterous date you may not be able to open System Preferences to correct it. This dilemma may or may not be addressed in a future OS X update.
If you cannot open System Preferences you can reset your system date and time using Terminal.
Please read everything that follows before proceeding. Write them down if necessary because the effects of setting a preposterous system date are unpredictable.
Quit System Preferences, force quit if necessary: OS X: How to quit an unresponsive application using Force Quit
Open Terminal - it is in your Utilities folder and looks like this
You can find Terminal by using the Finder's Go menu and choosing Utilities, then double-click the Terminal icon.
At the prompt, you will be typing a command resembling the following:
sudo date mmddhhnnyyyy
... but you must substitute the actual date and time in the command that corresponds to the date format used for your location. In other words if your custom is to use a date like 8 February 2014 then reverse the mm and dd values.
Substitute numerals in the above command according to the following:
mm = month
dd = date
hh = hour (24 hour format)
nn = minutes past the hour
yyyy = year
Each of those values must be two digits except for the year which can be two or four digits. As an example if the current date and time is February 8, 2014 at 9 PM your command will be the following:
sudo date 020821002014
or
sudo date 0208210014
Either one will work. If you enter nonsensical values the system will attempt to parse the entry correctly.
To recover from your inability to use System Preferences to set the date and time, the value entered does not have to be precise, it just has to be approximate.
Enter that command using the actual time and date for your location and in the appropriate format, then press the Return key. Terminal will ask for your Admin Password - the same one you use when you log in to your Mac. Type it and then press the Return key. What you type will not appear, not even with •••• characters.
To determine if your change was effective just type the date command and press the Return key. Terminal will reply with the date and time. If it appears correct and in the correct format, you should be able to open System Preferences > Date & Time once again. Selecting the "Set time and date automatically" and choosing an appropriate time server will adjust your Mac's system clock to the precise time. -
Ipod cannot be recognized by pc and wont turn on! help
my ipod video is only a month and a half old and then just yesterday i was still using it around 12 noon then around 1 pm it wont turn on! i tried to reset it, made some simple troubleshooting but it wont respond waaaa when i connect it to my pc the pc cannot recognize the ipod that as if nothing is connected to the port! help please very freaked out ;(
Hi geaneshe!
Have you seen if these articles help with that issue of your iPod not turning on?:
iPod won't turn on
iPod stops responding or won't wake from sleep
-Kylene -
HT201263 need iphone 4s to be cleared and wont turn on! help!
so the other day i dropped my iphone 4s into the toilet.... i have to send my phone back to the store and it has to be restored or everything deleted... the phone will not turn on and wont show up on itunes... I need this done by tonight!!! help. thanks
If it won't turn on, there is nothing more you can do. Don't worry about it.
-
My ipod 5 has a broken power button And wont turn back on Help!
My ipod 5 has a broke poer button and was dead. I tried plugging it in to my computer and it charged normally now it wont turn back on and the computer says that its 100% charged how can i turn it bacl on without the power button? HElP!
Try:
- iOS: Not responding or does not turn on
When it says place the iPod in recovery mode
Place the iPod in recovery mode using one of these programs:
For PC
RecBoot: Easy Way to Put iPhone into Recovery Mode
or
http://joshuabailey1997.wordpress.com/2010/09/02/recboot-v1-3/
If necessary:
Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
and
RecBoot tip
RecBoot may have problems on 64X windows, then try:
Tenorshare ReiBoot – Enter & Exit iPhone, iPad, iPod Recovery Mode with a Single Click
For MAC or PC
The Firmware Umbrella - TinyUmbrella
Installs blootware on PC too
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I was going on to a game and my screen turned white and wont turn off Plz help
My ipod went white and wouldnt turn off.I was playing myhorse then that happer.What happen to my IPod?
Plz help- Try a reset:
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Connect the iPod to your computer and try to restore via iTunes.
- If screen still white, let the battery fully darain. After charging for an hour try the above again. -
it has been over 20 hours now
Well, if you can't reset it, you can try hooking it up to the computer your sync with and try restoring it:
IOS RECOVERY MODE RESTORE
If the device is not recognized by iTunes, you will have to make a trip to the Apple Store.
Best of luck,
GB -
please help i beg of you
The link that Ingo posted makes sense.
I once accidentally left my iPhone in the washing machine for a full 48 minute spin cycle.
It didnt work for a few days, but after about a week when it dried it started working again ----> That was 4 years ago! -
My iPhone died and wont turn back on. My home button doesn't work to reboot it.
It died last night and I put it on the charger and nothing happens not even the battery symbol comes up. I do have the iOS 7. I can't restart it because my home button doesn't work and i have to use assistive touch. It won't show up on itunes when i tried to plug it in. It's not the charger because it works on my other i-devices. I have an iphone 4.
If the screen and iPod does not show any life then letting the batter drain will not do anything.
If you tried another cable and tried ReBoot on another computer and still problem then your iPod has to be repaired/replaced
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
SOooo...my phone died last night
My phone died last night and when i was charging it i accidently put it on recovery mode and now when i put it on itunes it wont restore it ..theres always an error. help? x[
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
But... if the Device has been Modified... this will Not necessarily work.
Maybe you are looking for
-
Hard Drive Capacity not Changing after moving files
My internal hard drive capacity is shown at 249.58 GB and I only had about 1.97 GB available. I moved 122.89 GB of photos to an external hard drive partition plus many seldom used files and folders (not sure of the MB or GB size). Now my hard drive c
-
PNP and PNPCE databases in ESS
HI, As all you know standard ESS works on PNP logical database.but we have a situation in our project that we should use PNPCE database instead of PNP. So i would like to get your inputs on the usage of PNPCE in ESS .will there be any bad impact of u
-
Premier elements 3.o to Premier elements 10
Can premier elements 10.0 open a file from premier elements 3.0 If not, how can I magrate all the photos and mp3's to 10.0?
-
Adobe Photoshop Cloud for Photography Business
Hey everyone, Is anyone using cloud integration to store your images from your photography business? I am currently using a NAS drive to store my clients images and only using Adobe Cloud for fonts and such, are there any advantages to keeping my sou
-
Problem batch exporting odd sized mp4's in After Effects?
Just been given the great task of converting hours and hours of supplied image sequences into mp4/ h.264 files for playing through silverlight. I envisaged assembling these sequences with their supplied sound tracks in after effects and outputing to