My nano blinks the apple logo when plugged into a charger and will not respond to any reset commands, anyone have experiance with this problem?
My nano blinks the apple logo when plugged into a charger and will not respond to any reset commands, anyone have experiance with this problem?
By a reset, I assume you meaning pressing and holding both the Select (Center) and Menu buttons (or Volume Down and Sleep/Wake buttons on the 6G Nano) long enough for the Apple logo to appear?
What happens if you try to manually place the iPod into Disk Mode? If you can do that, I would recommend connecting the iPod to iTunes and restoring it.
Putting iPod into Disk Mode
B-rock
Similar Messages
-
MY iPhone 5C suddenly stopped working. It wont connect to my Mac and repeatedly reboots from the apple Logo when plugged into the wall.
There is no water damage or anything. I got that checked at the Apple store. I also have Apple Care + but didnt let them give me a new one yet because I have photos on this that I have no yet backed up that are very important. They are the last photos I have with my grandfather. Can anyone help me. Please!If the phone shows the "connect to iTunes" screen, the data on the phone is most likely lost.
Connecting in recovery mode is your only chance to use the phone again, besides getting it serviced by Apple.
iOS: Unable to update or restore -
I turned off my iPod then turned it back on. The normal apple logo appeared on the screen but then it went black and it won't connect to my iTunes. What should I do and what are my opptions.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Ipod cut off after plugging it into wall charger and will not turn back on
ipod cut off after plugging it into wall charger and will not turn back on
You are gonig to have to take it to an apple store or a specialist as it might be a harware problem.
-
Can someone please help with my issue listed - My ipod 4G wont go past the apple logo when I turn it on - it will stay on the apple logo for few min, then blanks out and back to the apple logo. Tried reset option/troubleshoot several times. Also wont show up on computer at all when I plug in to USB.
Any tips are very much appreciated.Place the iPod Touch into DFU mode. This will be similar to what the factory would do to install the iOS onto new iOS devices.
Placing it into DFU mode will allow you to "format" and install the current iOS for that device.
To place your iOS device into DFU mode.
First connect you iOS device to you computer.
Open iTunes if not already open
Now turn off your iOS device using the power swipe.
Press the home and sleep button on your iOS device for 10 seconds.
Release the sleep button but carry on holding down the home button. For another 10 seconds.
Your iOS device should now be on DFU. Click on restore and iTunes will download the latest iOS for your device.
Hopefully that sorts it if not, you will have to go to a service centre or call Apple Care up and get them to collect it and repair it. (replace it) Or go into an Apple Store. -
i have recently recieved an ipod nano 6th gen after the 1st gen recall, and out of nowhere it just started flashing the apple logo when connected to computer. Help please!
Universal Serial Bus controllers
Intel(R) ICH9 Family USB Universal Host Controller - 2934
Intel(R) ICH9 Family USB Universal Host Controller - 2935
Intel(R) ICH9 Family USB Universal Host Controller - 2936
Intel(R) ICH9 Family USB Universal Host Controller - 2937
Intel(R) ICH9 Family USB Universal Host Controller - 2938
Intel(R) ICH9 Family USB Universal Host Controller - 2939
Intel(R) ICH9 Family USB Universal Host Controller - 293A
Intel(R) ICH9 Family USB Universal Host Controller - 293C
USB Composite Device
USB Root Hub
USB Root Hub
USB Root Hub
USB Root Hub
USB Root Hub
USB Root Hub
USB Root Hub
USB Root Hub
I'm not sure if it charged when I hooked it up to my roommate's computer, but it definately didn't register either. If I put it on the dock it plays so the port is fine, but that still doesn't help me sync it to my computer. -
Hi, I'm using a white iPhone 4s with 16gb memory and having some problems. Whenever I use earphones the sound will be heated when the volume is at the highest if I turn it down any lower all I hear is static. Can anyone help me with this problem as I would appreciate it much.
Reset the device:
Press and hold the Sleep/Wake button and the Home button together for at least ten seconds, until the Apple logo appears.
If that doesn't help, tap Settings > General > Reset > Reset All Settings
No data is lost due to a reset. -
The ipad 4 is taking forever to charge and will not charge with some chargers?
My sons I pad 4 is taking forever (hours) to charge and will not charge with some of the plugs?
Are you using the iPad charger or a different charger, like an iPhone charger?
Cheers, Tom -
Dropped my iPhone in snow and now it will only show the apple logo when plugged in
I dropped my iPhone4s in the snow the other day, consequently it got wet. I could see the condensation in the camea and flash and the screen turned black however the phone still worked as when my friend called me it vibrated but I couldn't answer it because of the screen. The flash also was constantly on so it seemed like everything was working inside the phone but just not the screen.
As soon as I got home I left the phone in rice for 2 days.
I got the phone out and plugged it in to charge. The apple logo showed up and the phone vibrated but en the apple logo disappeared and the screen turned black again. I unplugged the phone and plugged it in again and the same thing happened with the logo again but no vibration.
If I take the phone out of the plug it will just stay as a black screen.
Any suggestions as to what is ring with it or what I could do to fix this?You've most likely cooked it. Make an appointment at the genius bar. Take the phone and your credit card with you. An out of warranty replacement will cost you $199.
-
Apple logo when plugged into wall, nothing when connected to computer
I think my iPhone may have finally met its last days. This week while on my honeymoon in Puerto Rico, I jumped into a waterfall with my phone in my pocket. Crap! I pulled my phone out of my pocket, and it still worked fine. I started praising my Otterbox for saving it. 3 hours later I arrived back at my hotel room, and the phone wouldn't turn on. Weird because it was working for a couple of hours. 3 days later and anytime that I plug it into the wall all I get is an apple logo that comes in goes every few seconds. I tried a reset and no luck.
When plugged into the wall, I can hold the home and the lock buttons, and it shows me a picture that says to connect it to iTunes but it disappears after half a second. However, whenever I plug it into the computer I get NOTHING. No apple logo, nothing in the device center that shows I'm even connected.
Is there any hope for me? Any help is much appreciated. I have over 200 pictures from my wedding and honeymoon that I don't want to lose.Sorry, disregard the last response; I can't edit it. You should dry it BEFORE trying different cables. The safest way to go about this is dry your iPhone inside-out and to not turn it on until it's dry. Maybe there is a little moisture stuck inside preventing it from booting, but if you're lucky, it's not permanently damaged. The best way I've heard of to dry it is to leave it overnight in a tight bag with dry rice or, better yet, silica packets (those anti-moisture things found in packaged items). Maybe longer if you want to be extra safe. If it still doesn't charge without the Apple logo flashing, try using different Lightning to USB cables. Maybe it's just a bad cable, but you shouldn't test that until you've dried your phone.
-
The ICloud log in screen is dim, and will not respond to any data entry
My IMac wants me to sign in to ICloud, but the screen is slightly dim and will not accept any data
Please click iCloud - Learn how to set up iCloud for instructions on how to setup iCloud.
-
If I tried to plug my damp phone in to charge and it won't turn on, have I destroyed it. Is there a chance that it can work again?
I've seen basic phones go through the washer and dryer and work fine. I've seen phones that were used briefly in a light rain never work again. If liquid gets into the right places, even in very small amounts, the phone is fried.
-
Apple Mobile device will not uninstall. Other components uninstal ok. Cannot uninstal and reinstall iTubes. Any advice?
Hey AJKP,
Thanks for the question. I understand that you are experiencing issues uninstalling Apple Mobile Device Support. The following article provides a solution:
iTunes 11.1.4 for Windows: Unable to install or open
http://support.apple.com/kb/TS5376
Uninstall and reinstall iTunes
1. Uninstall iTunes and all of its related components.
2. Reboot your computer. If you can't uninstall a piece of Apple software, try using the Microsoft Program Install and Uninstall Utility.
3. Re-download and reinstall iTunes 11.1.4.
Thanks,
Matt M. -
i recently tried updating to ios 6, which actually left my ipod in a recovery loop. i got it to work again by getting to to the restore from backup part using my mom's computer. however, now that i want to update my music on it, everytime i plug it into my laptop it the computer makes a sound i have never heard before. and then nothing happens. itunes doesn't show it as connected, it doesn't show up in the my computer menu, an
Verify that you have the right boxes checked to sync?
iTunes: Syncing media content to iOS devices and iPod
Try syncing using the manual method
Managing content manually on iPhone, iPad, and iPod
Last, backup to iTunes and restore from backup, yes again -
I have downloaded the new iOS 7 and now the 7.0.2 update is trying to download and is stuck at 1 minute. I have powered off the device and soft reset and still cannot get the download to complete.
7.0.2 is only for the iPhone 5
Maybe you are looking for
-
Ctrl/Alt click to activate link closes current document
We just upgraded from Framemaker 7.2 to 12, and there's a behavior I can't figure out. I have a book file with cross-references between FM documents. Before, in FM 7.2, when I used Ctrl/Alt+click to activate a cross-reference link and follow the mark
-
How do I install profiles 6.6 DNG converter ?
I downloaded the 6.6 DNG converter and when I try to open it I get the following message."Error writing temporary file make sure your temporary files is valid. How do I check temp files and install DNG converter profiles?
-
Hi. The mouse freezes when using firefox. No other programs are causing this problem, which stops immediately once I use CTRL-ALT-DELETE to delete the firefox task. I have done a full uninstall of firefox after trying safe mode without resolution. I
-
Atheros ar5001x+ no wlan0 adapter
since the ath5k driver is already part of the kernel i just popped in the card in my dell d410 and used mod probe on the system to start ath5k. i removed the old ipw2200 drivers to prevent conflicts and followed the wiki and blacklisted all the modul
-
Deskjet 1050 won't print alignment page
I am mad as hell at HP tech support. After changing my black cartridge the printer would not print out the alignment page. After much consult with "Dylan, from India" I was told to buy another cartridge and try that. If that did not correct the pr