My new iPod nano 6th generation won't sync

I always get this problem
I have:
reinstalled iTunes
reinstalled the driver of the iPod
restored the iPod on a different computer
switched usb drives and wires
restarted the computer
still the same
any advice?

OK, here's someting to try: iTunes Error 13019 during sync and also look at this discussion https://discussions.apple.com/thread/2046768?tstart=0
Message was edited by: Ingo2711

Similar Messages

  • My ipod (nano, 6th generation) won't sync to a new computer with different stuff on it. It *appears* to sync but when it's done it still has the stuff from the other computer on it. What to do?

    My ipod (nano, 6th generation) won't sync to a new computer with different stuff on it. Itunes on the new computer doesn't give the usual warning that you are about to lose all your existing stuff and the ipod *appears* to sync but when it's done it still has the stuff from the other computer on it. What to do?

    Hey eamonn27
    Thank you for using the Apple Support Community. Due to the nature of your issue, you may find more information by using another one of Apple's support resources.
    Express Lane
    https://expresslane.apple.com/GetproductgroupList.action
    Thanks for using Apple Support Communities.
    Regards,
    -Norm G.

  • New iPod nano 6th generation won't charge.

    I just bought a new ipod nano 6th generation multi-touch. I opened it and it had no charge and a black screen, no surprise I assumed it just has no juice in it. I plugged it into my macbook pro via the USB cord included and after leaving it attached for over 3 hours it still has yet to charge or offer me more than a black screen. Is there any way to remedy this? Am I doing something wrong? Is it just simply dead and I need to return it for another? I have a half marathon to run in a week and I'd like to know soon so I can have it for the race x.x

    If it does not get enough juice from the USB port, it will not charge.
    You should NOT connect it to a USB hub. Connect it directly to the computer. If you use a desktop computer, use one of the ports on the back, not one on the front, which tend to be lower power.
    You say you are using a macbook, which tend to be better about power. Make sure you don't have any settings that turn off power to the usb ports when the computer goes to sleep. Check your power settings in the settings screen.
    i

  • IPod Nano 6th generation won't sync with iTunes.

    I replaced the battery in my iPod Nano 6th generation and now it won't sync with iTunes. It shows in the list as iPod recognises that it is in recovery mode, so advises to restore. Press the restore button and after a time a message says can't find the iPod

    do you ever unplug your iPod without ejecting it first?

  • Ipod nano 6th generation won't sync at all !

    hello everyone and thx for the helpers .
    i got macbook pro (late 2011) and ipod nano.
    when i'm trying to sync it with my music on my itunes , nothing happens , nothing !
    i'm getting crazy from this .
    basically, when i plug the ipod to my mac the itunes pops up automatically and recognize my ipod but when i'm pressing on the sync button the process starts and ends less then a milisecond an nothing happens !
    the ipod's version is up to date and i restored it 10 times already and still same problem.
    any idea's ? because i start to give up ...
    thank you everyone ...

    could not unmark this question so i'm replying here.
    i don't know what happed but everything got back to normal !

  • Since I updated to itunes 11, my ipod nano 6th generation won't update?

    Since I updated to itunes 11, my ipod nano 6th generation won't update?
    I wanted to add in my Christmas playlists and most recent purchases, when it wouldn't get past syncing the second song a couple of times, I tried restore and lost everything because it still wouldn't sync. Then I tried to sync to my old computer which isn't itunes 11, and doesn't have my latest songs on it. My ipod did sync then though, so it seems to be a conflict between my version of ipod nano and the latest version of iTunes??????
    Has anyone had the same problem? is there a solution??

    Hey eamonn27
    Thank you for using the Apple Support Community. Due to the nature of your issue, you may find more information by using another one of Apple's support resources.
    Express Lane
    https://expresslane.apple.com/GetproductgroupList.action
    Thanks for using Apple Support Communities.
    Regards,
    -Norm G.

  • IPod Nano 6th Generation Won't Eject

    iTunes recognizes my new iPod Nano (6th Generation) and I can add music, playlists, etc.  When I go to eject (both through iTunes or through Finder/desktop), the eject process seems to freeze and the iPod is not completely ejected.  Furthermore, I have tried to restore the iPod through iTunes and the disk will just spin after decompressing the iPod software package.  I have also tried reinstalling iTunes and still have the same issue.  I'm looking for any suggestions on how to address.
    Thanks.

    Both itunes and ipod flash "sync in progress", then it stops and says sync complete, but no music was transfered. I restored the ipod thinking that was the issue, but it continues. I unchecked manually managing the music and in devices i unchecked "stop ipod from automatically syncing". What is wrong?

  • IPod Nano 6th Gen Won't Sync After Getting iTunes Match

    I have a new iPod Nano 6th Generation, with the new clock faces, bought in december. I bought iTunes Match in early january.
    After syncing and using my ipod successfully, I was confident that iTunes Match would not effect my ipod syncing as I only use iTunes Match for my Mac and iPad. However, after adding some CD's to iTunes and downloading some tracks, my iPod began syncing but then was interuppted by an error - 13019. It then wouldn't sync. I restored the iPod and the error came up again and after a few failed attempts, the iPod went into a boot loop showing the apple logo, then the homescreen then it would flash white and show the apple again.
    I then thought to test it I would turn off iTunes match and sync the iPod and see if it would work. It didn't however, after restoring it with iTunes match turned off, it worked and synced, albeit with no playlists for some reason.
    I am very disappointed and would like to know if I could fix it so my ipod can sync with itunes while iTunes match is turned on (the best option) or to be able to get a refund on iTunes match if it will not work and is causing me to not be able to use my iPod.
    Thanks for any Replies
    Andrew

    I have a new iPod Nano 6th Generation, with the new clock faces, bought in december. I bought iTunes Match in early january.
    After syncing and using my ipod successfully, I was confident that iTunes Match would not effect my ipod syncing as I only use iTunes Match for my Mac and iPad. However, after adding some CD's to iTunes and downloading some tracks, my iPod began syncing but then was interuppted by an error - 13019. It then wouldn't sync. I restored the iPod and the error came up again and after a few failed attempts, the iPod went into a boot loop showing the apple logo, then the homescreen then it would flash white and show the apple again.
    I then thought to test it I would turn off iTunes match and sync the iPod and see if it would work. It didn't however, after restoring it with iTunes match turned off, it worked and synced, albeit with no playlists for some reason.
    I am very disappointed and would like to know if I could fix it so my ipod can sync with itunes while iTunes match is turned on (the best option) or to be able to get a refund on iTunes match if it will not work and is causing me to not be able to use my iPod.
    Thanks for any Replies
    Andrew

  • IPod Nano 6th gen won't sync with iTunes 12.1.1.4

    iPod Nano 6th gen won't sync with iTunes 12.1.1.4.
    This iPod was synced with another iTunes library. I had to transfer iTunes library from another laptop.
    Launch iTunes (12.1.1.4), plug in Nano, Nano display says connected, Nano appears in iTunes, but when I attempt to navigate to Nano nothing occurs, or if I am able to navigate to Nano then I can't go any further and select music to sync and the Nano comes out of connected state. I have had to close iTunes, sometimes reboot laptop, but nothing I do appears to make any difference. It won't allow me to continue music selection process and start the sync process. Is there a way to simply reset the Nano and reconnect to get it to sync? I don't care about content as it needs to be resynced with this iteration of iTunes because it is currently associated with the other iTunes library.
    Any suggestions would be appreciated.

    What solved my problem:
    I restored my iPod nano on my wife's PC, which had version 11 of iTunes. I was then able to sync it on my PC. Why didn't I restore it on my PC? See following details.
    Additional details:
    I first took the iPod to the local Apple Store, where the only course of action they could offer was to restore the iPod. So they did. When I got home, it wouldn't even connect to iTunes on my PC, which was a regression from the day before. Out of desperation I plugged it into my wife's PC, and her older version of iTunes immediately told me the iPod had been formatted on a Mac and it needed to be restored on a PC to be usable by a Windows machine. Why my newer version of iTunes couldn't tell me that is a mystery.

  • My ipod nano 5th generation won't sync. It says disc cannot be found.

    My iPod nano 5th generation won't sync for some reason. It is almost like my PC is reading it as a regular mp3 player. I have to manually open itunes when I connect it.

    The computer won't see them as the same iPod despite the name.
    You might want to reload Windows on your computer or reinstall the USB root driver.

  • Ipod nano 6th generation won't shuffle entire library when connected to car

    Hello,
    I have been connecting my ipod nano 6th generation to my car (a Citroen DS3) using the usb cable. The problem I have is that the music defaults to playing alphabetically through the artists and will not allow me to shuffle my entire music library. I can see my library, arranged by artist, on my cars display and can select which artist I want to listen to, but the car itself will only allow me to shuffle songs for the artist that is currently playing and not the entire library. I cannot control the music that is playing via the ipod itself as it locks itself as it is being used as an accessory.
    Has anybody got any ideas?
    Many thanks,
    Abi

    Thanks, I have to call back 800 692-7752 - the hours are 6AM - 6PM Pacific Time. The recorded message reccommends the site https://expresslane.apple.com  - you need your device serial number for this.  It's a shame Apple placed this number under the tiny clip on the 6th Generation Nano.  (!!!)  
    Looks like I'll be waiting for the help line to open  :/

  • HT201413 my iPod Nano 6th generation won't appear on iTunes after i updated it

    when i connect my iPod Nano 6th Gen to my laptop (Windows 8) it doesn't appear on iTunes, and that happened after i updated my iTunes to the latest version, a message appears (after i connect my iPod) and says "An iPod has been detected but it could not be identified properlyi've tried all of Apple's troubleshooting tips but nothing seems to actually work ... what sems to be the probleme ? everything was ok before the iTunes update

    Hello delilahca,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPod not recognized in My Computer and in iTunes for Windows
    http://support.apple.com/kb/ts1369
    Best of luck,
    Mario

  • IPod nano 6th generation won't restore

    my iPod nano 6th gen, is locked in some kind of restore loop.  It says it's restarting after the restore, and after the iPod screen goes from do not disconnect to the Apple logo temporarily, the screen goes back to the restore screen, and iTunes says it needs to be restored.  What do I do now?

    We had to replace ours and it seems to have fixed the issue, so unfortunately, it does sound like a hardware issue.  The thing that ***** the most is that I had the first one engraved for my wife as a "birth" gift, and when you replace something, they don't give you the option to get the replacement engraved.

  • IPod Nano 6th Generation won't xync Podcasts

    Hi
    I am in iTunes and selected the Podcasts I wanted to sync on my new iPod Nano.
    After syncing, the Nano says there are no podcasts.
    Any advice? Thanks.

    When you connect your ipod, on itunes on the right side tool bar it says devices.click on your ipod and a summary should come up, click on the podcast tab and select the "sync" option then you could choose which ones to sync.
    If it can't help you,you also refer this [iPod Transfer Reviews|http://www.softwarebbs.com/wiki/IPodTransfer_SoftwareReviews],which lists some tools to work out iPod to computer.
    Cheers.

  • New ipod nano 6th generation used 3 times. Screen remains black despite a full reset. Something special to do ?

    Hi, I just bought a new ipod nano and used it 3 times. Today it did not work and I first believed that the battery was too low. I connected the device to the mac. Sync worked well and charge indicator as well. Nevertheless, the screen remained black. I therefore tried to reset the device and after the resetting, the screen remains as black as before. Any solution ? thanks and regards

    If it does not get enough juice from the USB port, it will not charge.
    You should NOT connect it to a USB hub. Connect it directly to the computer. If you use a desktop computer, use one of the ports on the back, not one on the front, which tend to be lower power.
    You say you are using a macbook, which tend to be better about power. Make sure you don't have any settings that turn off power to the usb ports when the computer goes to sleep. Check your power settings in the settings screen.
    i

Maybe you are looking for

  • A spotlight search question...(How to index a sever volume)

    Hi I am hopping someone can help me with this... When using the spotlight, content search to search a local volume, it can find almost anything. However, it doesn't work on a server volume. Is there a way to indexing the server volume?? Thanks.

  • Cant view video message after skype vanished

    hi there, im very confused. i sent a video message to a contact i send videomessages to all the time with no problems. but today when i logged on to my laptop, the skype rpogram had vanished from my computer. its wasnt anywhere even in my programs li

  • Sales document fields

    Dear Gurus,                   I need help on the following fields of sales document. How i get the following fields into sales document (From any Master data or System determined or Manual entry) 1.Document currency (VBAK-WAERK) 2.Exchange Rate (VBKD

  • STORE command in SQL*Plus

    Is there a way to avoid the message "Wrote file xxx" ?

  • Issue with Views

    Hi All, I have created a view as follows. create or replace view V1 as select * from empI have base table EMP. Every day this table would be updated with millions of data. so by the end of the day if I give select * from emp this table contains more