My problem started when i connected my iphone5 into mac book and i started restoring data, by that i lost my recent photo's ,i tryed a program but it was recovering the previous photo's not the recent once ... need ur help what to do plz....thank u

my problem started when i connected my iphone5 into mac book and i started restoring data, by that i lost my recent photo's ,i tryed a program but it was recovering the previous photo's not the recent once ... need ur help what to do plz....thank u

Not much you can do.  You overwrote your current data with older data when you restored the phone from that backup.  Your data's gone.

Similar Messages

  • After migrating a new Mac Book Pro from Time Capsule, I noticed that I lost a group of Favorites on the older iMac. The puzzling thing is that the Favorites are on my iPhone--not the old iMac or the new Mac Book Pro. How do I get the Favorites back?

    After migrating a new Mac Book Pro from Time Capsule, I noticed that I lost a group of Favorites on the older iMac. The puzzling thing is that the Favorites are on my iPhone--not the old iMac or the new Mac Book Pro. How do I get the Favorites back?

    If you are syncing using iCloud, try going to System Preferences/iCloud (computers) and checking Safari. If it is checked, try deselecting it, wait 10-15 seconds, and then check it again.

  • I have just started to get pop up on my mac book and it is saying i have won a prize how do i stop it

    i have just started to get pop ups on my mac book pro how do i stop the cause it is causing safari to freeze  and not respond

    Your device is in recovery mode.  Follow the steps in this article: Recovery mode - Support - Apple

  • Sharing display and internet connection between a 13inch Mac Book and G4

    Does anyone know whether it is possible to connect a Mac Book and a G4 Powermac with an ethernet cable and then hook them both up to the same display and ethernet internet connection?

    Usually you use a router to share an internet connection and to make a local network between the computers over Ethernet or WiFi. I think it is possible to directly connect the computers without a router, but you might have to use a cross-over cable, I'm not sure how to set up a direct connection. Using a wireless router with wired ports would allow you the flexibility of using the MacBook wirelessly and the PowerMac with a wired connection. I have an Apple Airport Extreme Base Station, and it was pretty easy to set up, it plugs into my cable modem to share the internet connection.
    They make hardware devices that allow you to share a docking station between more than one computer, called a KVM switch, so you can have one keyboard, video display, and mouse and switch between two active computers.
    Alternately, using the network connection, you can use Chicken of the VNC, which is a virtual network computer, this opens a window, or full-screen mode, of a computer so you can operate it from another computer.
    http://sourceforge.net/projects/cotvnc/
    You can also control a PC from the Mac using Microsoft Remote Desktop Connection.
    http://www.microsoft.com/mac/otherproducts/otherproducts.aspx?pid=remotedesktopc lient
    Some monitors have multiple inputs, so you wouldn't need to use a KVM switch, if for example your monitor has both DVI and VGA inputs, the front panel can select the source, so you could use a DVI adapter for the MacBook and a VGA for the PowerMac. You could still use the KM portion of a KVM switch if you wanted to use a single full-size keyboard and mouse with both computers.
    http://iogear.com/main.php?loc=product&Item=GCS632U

  • When I try to sign into my Apple ID account, I get a message that says "An unknown error has occurred"  I reset my password but that didn't help.  What do you suggest?

    When I try to sign into my Apple ID account, I get a message that says "An unknown error has occurred".  I reset my password but that has not helped.  I am trying to update iPhoto.  I just installed Maverick X.  Thank you

    Restart your Mac then try again.

  • I am having all kinds of trouble with itunes and updating my ipad. when I open up itunes, it seems to just sit there, never going to itunes store. when I connect my ipad, I check update and it starts, but then I get this message:backup can't be saved on

    I am having all kinds of trouble with itunes and updating my ipad. I open itunes up but it doesn't do anything except open to a blank screen. I try to access the itunes store but it won't go there. When I connect my ipad, and try to update it, it starts and then I get a message that says backup cannot be saved on this computer. I have tried everything suggested to no avail. This is the 2nd or 3rd time I have had problems with itunes. Sometimes I even get a message that I am not connected to the internet.
    I have uninstalled and re-installed. Any help?

    You might not have enough space left on your hardrive.

  • My iphone is not recognise on my iTunes when its connected to my laptop mac book pro

    my iphone is not syncing to my itunes
    thanks

    In skype did you set the audio/video preferences for the camera?  Also might try doing a smc and pram reset if the camera is not selectable or enabled from skype.

  • When I reload a page(or window) is there a way to automatically go back to the previous "window section" (not the upper left corner)?

    I use the "reload every" add-on. It works great. The problem I am trying to solve is to keep from having to scroll down and slide right after every reload to get to the position I was in previously. In my case it is a chart of stocks on the move that I am reloading often, which is located in the middle of a page.
    Is there another add-on that will solve my problem?
    Thank you!

    If that section has an ID or NAME attribute then you can add that to the URL (#anchor) that you want to reload.
    See View > Page Source
    https://support.mozilla.com/en-US/questions/774792#answer-128100

  • I can't get a picture on my toshiba tv when I connect it to my Mac Book Pro using an HMDI cable

    In 2010, we bought a MacBook Pro 7.1.  We also bought an HDMI cable that connects directly to the MBP’s mini display port and to the HDMI port in the TV.  The TV is a Toshiba. We made the connections and selected the correct ports and got nothing on the TV, except a “no signal” message. The Display window on the MBP recognized the Toshiba TV. We tried the same hookup with a different TV (Phillips) and we got video (no sound) on the TV with the same mini display port to HDMI cable. We borrowed a mini display port to VGA adapter with a VGA cable. The adapter also had a separate audio cable that connected to the TV’s audio port. That worked.  We got both video and audio on the Toshiba (but the video was not HD). We connected my Kindle Fire HD to the Toshiba using an HDMI cable, and that worked.  We got both video and audio on the Toshiba. So, we proved: - the mini display port works  - I can get video from it to the Toshiba with a VGA adapter - the mini display port to HDMI cable works – I got video through it from the MBP to the Phillips - the HDMI port on the Toshiba works – I got video / sound from the Kindle and its HDMI cable What do I do to get video from the MBP to the Toshiba using the HDMI cable I have?

    Have you read for possible solutions over in the "More Like This" thread over here?-----------------------> 
    Read the tv user manual.  I have a Toshiba which has detailed instructions for tv to comp hookup.  If necessary call Toshiba.  Especially, if you are still under warranty w/them. 

  • HT1766 When I started my new iPad 2 I could not start from a previous backup because the os on the new iPad is not the latest 7.x used to backup the previous ipad2  to install the new os I had to start the iPad as new. But now I cannot backup from the pre

    When I started my new iPad 2 I could not start from a previous backup because the os on the new iPad is not the latest 7.x used to backup the previous ipad2  to install the new os I had to start the iPad as new. But now I cannot backup from the previously backup ipad

    Hi there,
    You may find the troubleshooting steps in the articles below helpful.
    iCloud: Troubleshooting restoring an iCloud backup
    http://support.apple.com/kb/ts4036
    iOS: If you can't back up or restore from a backup in iTunes
    http://support.apple.com/kb/ts2529
    -Griff W. 

  • MW64,  cs6 bridge when I move or copy files the  context menu does not retain  recent folder destinations after I close the program

    W64,  cs6 bridge when I move or copy files the  context menu does not retain  recent folder destinations after I close the program. The context options that show are the ones from original install. The workspace I set up is also gone. I have every explorer box and cleaner checked to save recent. Had to disable nivedia desktop software because of weird display conflict. Have Dell pro support and they cannot fix. Any ideas to help me with this would be appreciated.

    Self-solved!  I work in column view in Finder so get there in a Finder window with folders and files appearing.
    There really is no problem, just select an ITEM in the COLUMN before right-clicking!
    The "old" context menu will appear. If you click in the white space in that column (or anywhere in a Finder window) and then place the cursor over a folder or file WITHOUT selecting it and right-click you will bring up the secondary context menu - Open, Copy, Duplicate, View Options and a greyed out Labels option. No "Move to Trash".

  • When I connected my iPhone5 to update Operating system it is not recognizing and wants to restore default settings which will wipe out photos

    When I connect my iPhone5 to my PC it is not being recognized as in the past and wants to restore factory default settings.  I don't want to lose photo and video files stored in the phone but I cant transfer them to my PC either - help.

    plzzz reply to this question as soon as possible

  • HT201412 my iphone 4s does not start by power switch, it starts when i connect to pc. the proximity sensor is not working. please help

    my iphone 4s does not start by power switch, it starts when i connect to pc. the proximity sensor is not working. please help.

    Sounds like it may be a hardware issue.
    Please contact Apple Support in your country.
    Here is a list of numbers: http://support.apple.com/kb/HE57
    Regards
    J

  • I transferred itunes library from old PC to new PC. The content all shows when I launch iTunes on the new PC now. The previous content does not show in iTunes but folder still looks like it is on hard drive on new PC. Suggestions on how to properly merge?

    I transferred itunes library from old PC to new PC. The content all shows when I launch iTunes on the new PC now. The previous content does not show in iTunes but folder still looks like it is on hard drive on new PC. Suggestions on how to properly merge?

    Before you connect any device to a new library go to the Devices tab of the the preferences panel via Edit > Preferences (Windows) or iTunes > Preferences (Mac) and ensure the box next to Prevent iPods, iPhones, and iPads from syncing automatically is ticked. You can now safely connect the device to your computer without the danger of media being automatically deleted or overwritten.
    To get all your content off your connect your iPad to your new computer.
    Then use a 3rd party piece of software to transfer your content
    I have found Senuti useful but there are others listed in the article I linked to in a previous post.
    https://discussions.apple.com/docs/DOC-3991
    That will let you transfer your non purchased content
    For Purchased content log in to iTunes on the new computer
    In Itunes Store click on Purchased under the Quick Links section on the right.
    Download any music by clicking on the cloud button

  • I just did the IOS8 update on my Ipad retina which had 300  photos it asked me to do an iCloud back up which i did but it deleted all my previous photos and now i only have recent photos how do i get back all my old photos? It said befor that my iclo

    I just did the IOS8 update on my Ipad retina which had 300  photos it asked me to do an iCloud back up which i did but it deleted all my previous photos and now i only have recent photos how do i get back all my old photos? It said befor that my icloud was out of storage but i didnt know it didnt have my old photos, they arnt back up on itunes either is there any way I can get them back?

    atoo2 wrote:
    I just did the IOS8 update on my Ipad retina which had 300  photos it asked me to do an iCloud back up which i did but it deleted all my previous photos and now i only have recent photos how do i get back all my old photos? It said befor that my icloud was out of storage but i didnt know it didnt have my old photos, they arnt back up on itunes either is there any way I can get them back?
    Please see the bold.  If you're out of icloud storage, then you won't be able to backup to icloud unless you purchase more storage, but yet you said you backup to icloud.
    If you really did backup to icloud no data would be loss - sounds to me that it didn't backup since you had no more free icloud storage space.
    iCloud: iCloud storage and backup overview

Maybe you are looking for

  • Setting the command prompt...

    Can anyone tell me what I would use to set the command prompt? On HP-UX, I would reset the PS1 variable... i.e. PS1=" \$ID @ \$HOST | \$PWD --> " On Linux, I would reset it as follows: i.e. PS1=" \u @ \h | \W --> " Neither of these seems to work here

  • RSR_OLAP_BADI for virtual characteristics not getting triggered!!!

    I am facing a strange problem and am a little pressed for time to solve the same. Any help/guidance related to this will be highly appreciated. I am working on BI 7.0. I have two implementations of the BADI RSR_OLAP_BADI for virtual characteristics,

  • Message on an email from photoshop elements 12.

    I usually send my family photo's to friends vie Photoshop Elements 12 email. I cannot type in a message in the message block. Has anyone had this issue? Thanks Doug

  • IPOD will not even display anything

    Tried everything to get the iPOD to respond. It does look like there is condensation in the little circle at the top of the screen. I'm wondering if the humid weather we've been having has affected the iPOD in some way. What do I do?

  • I can't access my MobileMe gallery since the last update

    I can't access my MobileMe gallery since the last update, and I don't have a computer to fix it or retrieve any of my pix or vids. What do I do?