PSA request is in yellow status

Question

Hi
We got the problem when loading the 2LIS_03_BF data into cube. We have around 4 cubes and 2 ods.
The data got loaded into all the cubes and ods except on Cube. There was a problem of table space and now it is solved.
Now the request is in yellow status in PSA. It cube it shows no of records added and transferred but the status is in red color.
How can i upload the delta data into the cube from PSA when PSA request is in yellow color.
I feel strange that when the request is in yellow color how come the data is loaded into all other cubes.
REgards
Annie

Answer 1

You should be able to load request from PSA to data target using the option available in PSA. When you manage on Datasource, you see all requests. You can select that PSA request and use Scheduler option in that screen to update that particular request.  It will run infopackage as usual. It will execute all the routines if there are any in update rules.
When you say you have some programs running in process chain, they must be after this failed load right?
If that is the case, all you need to do is push process chain further. Below are steps to push process chain further if you any step is stuck in yellow or if mually carry out any red step in process chain. In you case, load that failed step manually using scheduler form PSA manage tab and then push PC further using these steps. That will continue PC further and run any programs that run after load.
Execute in SE38 -> RSPC_PROCESS_FINISH
Fill the following parameters on screen and rest all can be left blank.
1. LOGID - you will find this when you do monitor of your process chain. Every time you run process chain, unique LOGID is created.
2. TYPE - If step is ODS activation then TYPE wud be ODSACTIVAT and if it is infopak loading TYPE wud be LOADING and if it is DTP Load TYPE wud be LOAD. In your case it will be LOADING.
3. VARIANT - In the process chain monitor mode, right click on step which you executed manually -> Display Messages. Go to chain tab and there you will find VARIANT
4. INSTANCE - In the process chain monitor mode, right click on step which you executed manually -> Display Messages. Go to chain tab and there you will find INSTANCE
5. STATE - Value wud be G
After entering above parameters, click execute. It will be done in fraction of second and wont give any popup. Now when you will check process chain monitor, you will see that step 4 is green and next step has started executing.
Abhijit