Remote dialin access using isdn pri

Question

I configured dialin accesss using isdn pri interface. It works fine just for one user. When another user dials in (using same or different local username/password), the previous one loses the connectivity. Actually the statuses seem fine for the previous user: I can see him under "sh users" as well as host route in routing table. ppp session stays idle. There is no ip connectivity anymore.
aaa authentication ppp default local
isdn switch-type primary-net5
username test1 password 7 03105E18125E
username test2 password 7 06120A32581C
controller E1 1/0
pri-group timeslots 1-31
controller E1 1/1
pri-group timeslots 1-31
interface Serial1/0:15
no ip address
dialer pool-member 1
dialer idle-timeout 7200
isdn switch-type primary-net5
interface Serial1/1:15
no ip address
dialer pool-member 1
dialer idle-timeout 7200
isdn switch-type primary-net5
interface Dialer0
ip unnumbered FastEthernet0/0.1
encapsulation ppp
dialer pool 1
dialer caller "XYZ"
dialer-group 1
peer default ip address pool netm
fair-queue
ppp authentication chap pap
ip local pool netm 10.31.32.65 10.31.32.126

Answer 1

Hi Starman,
configure the following command under dialer inetrafce and check the issue.
int di0
dialer load-threshold 255 either
dialer ilde-timeout 120
if you want another to use the isdn line then create another dialer interface.
clarify me whether the users are accessing the pri from the same location or different locations using different isdn no's.
If users are present in two different locations then best solution is create seperate dialer interface for users.
Thanks,
Satish