SCCM 2012 SP1 CU5 PATCH Property

Question

I've recently updated my site from SCCM SP1 to SCCM SP1 CU5 (http://support.microsoft.com/kb/2978017) successfully.  I've verified through the registry that the Server is on CULevel 5 and
the consoles have been updated.  In addition I have verified the MSP applies successfully and the clients report 5.00.7804.1600 for a client push through SCCM or manually running the patch.  The problem is during OSD.
What I did was go to my original Client install folder under SMS_XXX folder.  I created a folder called "hotfixes" and then inside there a folder called "amd64" and "x86".  Inside their I copied "kb2978017.msp"
to the X86 and the AMD64 folder.  I then updated the distribution points for the original client package (so they receive the new hotfixes folder I added).  From there I went in the task sequence and on the "Setup Windows and Configuration Manager"
step I added the "Installation Properties" line as shown below:
SMSMP=XXX.xxx.com PATCH="C:\_SMSTaskSequence\OSD\XXX00003\hotfixes\%PROCESSOR_ARCHITECTURE%\kb2978017.msp"
When the computer finishes imaging it still reports "5.00.7804.1000" and not the .1600 version.  All the guides I've seen mentioned using the PATCH= property and pointing it to the correct package ID number (I verified this).  Not sure
what I'm doing wrong.  I did see an alternative of a step to manually copy the patch to the local drive with xcopy and then the Setup CM Client step to just call the local machine for the patch instead off this "C:\_SMSTaskSequence".  What
has other peoples experience been?  
Be kind and Mark as Answer if I helped.

Answer 1

Yes, I did copy the hotfixes to the client source folder (I checked the data source of the package in SCCM to ensure I was updating files/folders in correct directory) and then I right clicked the package in SCCM and selected Updated Distribution Points
and verified they did get updated successfully.  I checked the CCMSetup.log after a machine is imaged and it reports at the top of the log the command run to install SCCM Client and it just shows CCMSetup.exe without my SMSMP= property or the PATCH= property.
  Its like the client install doesn't even recognize the commands I've used in the task sequence.  Attached is a picture of the step in SCCM with the Server and Site name blanked out for obvious reasons:
CCMSETUP.log here : https://drive.google.com/file/d/0Bzodkg-HoMIhMHMwMnJZbkxpUHc/edit?usp=sharing
Be kind and Mark as Answer if I helped.