The light on my apple tv is blinking furiously. i've held down the menu button, plugged and unplugged it, and just tried restoring it via micro usb. but the restore downloads then says it can't finish because it can't write to the disc. lost lost
how do i get the light on my apple tv to stop blinking? have tried all the recommended methods, including holding down "menu" on remote, plugging and unplugging etc. when i try to restore via itunes it downloads then when it's done says it can't write to disc.
Hi lostinmedford,
Welcome to the Apple Support Communities!
I understand that the light is quickly flashing on your Apple TV and you are unable to restore it. According to the attached article, you are working through the correct steps by trying to reset and restore the Apple TV. In this situation, if the restore did not resolve the issue, it may be necessary to have the Apple TV evaluated for service by using the link in the attached article.
Apple TV: About the status light - Apple Support
Flashes quickly
Having issues. Try restarting or waking your Apple TV. If your Apple TV does not start up properly, you might need to reset the Apple TV or restore it to factory settings. See Apple TV (2nd and 3rd generation): Restoring your Apple TV. If this does not resolve the issue, refer to the Service FAQ for additional assistance.
Best regards,
Joe
Similar Messages
-
The light on my apple tv is blinking white constantly what is causing that?
My Apple TV light on the front of Apple TV is constatly blinking white. What is causing that? It just started doing that today (1/22/2013).
HELPIf your problem persists get yourself a micro USB cable (sold separately), you can restore your Apple TV from iTunes:
Remove ALL cables from Apple TV. (if you don't you will not see Apple TV in the iTunes Source list)
Connect the micro USB cable to the Apple TV and to your computer.
Reconnect the power cable (only for Apple TV 3)
Open iTunes.
Select your Apple TV in the Source list, and then click Restore.
If when you choose restore you get a message that the device cannot be found, download the file below
Apple TV Software Restore 5.1.1 (2nd generation)
Apple TV Software Restore 5.1.1 (3rd generation)
Then hold down the option key while choosing restore and select the downloaded file when prompted. -
I am trying to download IE Tab for IMac, I have already downloaded Firefox, and when I try to download IE Tab, it tells me it is not compatible with my current platform, can you please advise?
Thanks so much!Where are you seeing that IE Tab for IMac even exists?
The IE Tab extension for Windows versions of Firefox doesn't ''add'' IE to Firefox, it uses the version of IE that is already installed. IE isn't made for Mac any longer, so there's no way that a version of IE Tab can be made for Mac platforms. -
The light on my time capsule keeps blinking yellow. ! mark in toolbar time capsule and it says it was unable to finish backup because back up disk couldn't be found but it also says last back up was successful.
Hi jon88906,
If you are seeing a flashing amber light on your Time Capsule, you may find the following articles helpful:
AirPort base stations: About AirPort base station status lights (LED)
http://support.apple.com/kb/ht4600
Wi-Fi base station: Understanding and resolving a blinking amber status light
http://support.apple.com/kb/ts1589
If you are still seeing an alert message about Time Machine being unable to find your backup disk, then this article may be useful as well:
OS X Mavericks: If Time Machine can’t find your backup disk
http://support.apple.com/kb/PH14170
Regards,
- Brenden -
When I enter my photos app(only on my iPad Air), it says my iCloud storage can't update because it's full. In the settings it says I have 1,5 GB storage left. How do I solve this problem?
Welcome to the Apple community.
Could you please clarify what it is that is full, your iPad or your iCloud storage. -
I want to share Microsoft word from my desktop mac to my laptop but every timeIi try and do it, it says that it can't open because it is not supported by the software. I have tried several times and updated it on the mac but its still not working. Any ideas?
You need to install Office on the computer from the installer DVD or disc image you purchased.
-
I'm trying to place a phone call and when I do the 3G icon goes away and the phone just says connecting but never does. I have almost full service and only have had my new iPhone 5 for two days. Can anyone help because I can't call Sprint at the moment???
Settings > General > Reset > Reset Network Settings
-
I awoke this morning to find my iPhone 3g in recovery mode. I tried rebooting, charging, and when I connected to iTunes it gave me a message saying I had to finish recovery first. My screen shows the iTunes logo and the USB cable. Any ideas?
http://support.apple.com/kb/HT1808
-
i have imported my videos and edited it. now i am trying to export the file but it says it can be shared because it is refrencing material on the camera. i have tried importing it again and nothing works. help me please!!!!!
Go to your event folder and open the orginal media folder and post a screen shot of the open folder and its files.
Russ -
I have a new computer and want to sync my iPhone's apps. when I tell it to do so it says that all apps in my phone will be replaced by the ones in iTunes, but it's empty because it's new. If I do so will all my apps be deleted?
Transfer purchases over from your phone to your computer before you sync your apps. See Transferring Purchases for more details.
-
I have a 16GM Mini IPad. The screen won't swipe. I tried resetting it but that didn't work. I attempted to connect to ITunes to try a restore but I can't do that. This is because the IPad is locked with a pass code which I can't enter because I can't swipe. Does anyone have any suggestions on how to fix this?
If Ralph's suggestion doesn't work, try a Restore. Note that it's nowhere near as quick as a Reset. It could take well over an hour! Connect via cable to the computer that you use for sync. From iTunes, select the iPad/iPod and then select the Summary tab. Follow the on-screen directions for Restore and be sure to say "yes" to the backup. You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod. Again, say "yes."
At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod. As before, say "yes." Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time. If that happens, only the apps that are part of the IOS will appear on your device. Corrective action is simple - choose manual "Sync" from the bottom right of iTunes.
If you're unable to do the Restore (or it doesn't help), go into Recovery Mode per the instructions here. You WILL lose all of your data (game scores, etc,) but, for the most part, you can redownload apps and music without being charged again. Also, if you have IOS-7, read this. -
I get the message 'itunes has encountered a problem and needs to close' when trying to open itunes 11.1.1.11. I had to uninstall itunes so that I could load this version as the update to version 11 kept failing. The PC says 11.1.1.11 is correctly loaded, but I now cannot open itunes. Any advice on how to get itunes working again?
Hello there, ytnoj.
Uninstalling and reinstalling iTunes can be a tricky endeavor and must be done in a very specific way. The following Knowledge Base article provides the step-by-step of the process:
Removing and Reinstalling iTunes and other software components for Windows XP
https://support.apple.com/kb/HT1925
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro. -
I need to re-install Acrobat 9 Standard. In adobe "My Account" I see my order but when I download it says: "You have no downloads"What can I do?
Hi ChrisTruc,
Please try downloading Acrobat 9 Std. from: https://files.acrobat.com/a/preview/8d640488-4a92-4f7d-b50b-d8eb7f96bff8
and use the purchased serial number to activate the software.
Regards,
Rave -
Whenever i try to update my macbook pro, it downloads then says I need to restart my computer. I restart the computer, and everything just freezes. When my computer eventually turns back on, its not updated. other apps i try to download dont download also
First, do the following:
Repair the Hard Drive and Permissions
Boot from your Snow Leopard Installer disc. After the installer loads select your language and click on the Continue button. When the menu bar appears select Disk Utility from the Utilities menu. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the installer.
If DU reports errors it cannot fix, then you will need Disk Warrior and/or Tech Tool Pro to repair the drive. If you don't have either of them or if neither of them can fix the drive, then you will need to reformat the drive and reinstall OS X.
When you complete the above re-download your OS X upgrade (not sure which one that is, but I assume Mavericks.) After the download is completed re-install it. Hopefully, this time it will do what you expect. -
hi - my Mu was "buggy" and would not update - so i threw the APP in the trash - but now CC will not allow me to Re-Install because it thinks i already have the APP - any advice?
restore your app from the trash and then properly uninstall.
if that fails, CC desktop lists applications as "Up to Date" when not installed
Maybe you are looking for
-
Problem_in_CREATE_MVIEW_REPGROUP
hi all, i have 2 databases, master HBFP, and its materialized view HBFM. i have created the master group but mv_repgroup is giving me problems. the copy of the spool is as below: SQL> conn mvadmin/mvadmin@hbfm Connected. SQL> BEGIN 2 DBMS_REPCAT.CREA
-
Macbook Air. Unable to send or receive e mails.
We have just changed from EE broadband to BT Infinity. Coincidently, the same day I could no longer receive e mails. EE say this is nothing to do with them, BT say it is nothing to do with them. I am a complete techno phobe and have now played aroun
-
Segment field mandatory in Profit Center Master
Hi guys, Can anyone suggest, where can we make Segment field mandatory in the Profit center master data?
-
Synching old Nano songs to new Apple ID
Hello, I have an iPod Nano which I bought 6 years ago. I uploaded all my songs from cd's on to it. Now i have an iPhone and iPad under a new apple id (i don't know the iPod Nano's id), i cannot synch my songs from my iPod to my new apple account. Doe
-
Please, Apple..... Why so slow when it comes to RAW support for new professional camera models? Nearly a month ago, Nikon has updated one of their best selling pro DX-cameras - the D300, with the D300S model. Adobe promptly released RAW-support for t