Video playback from albums won't work when AV cable connected

I have created an Album on my iPhone 3G that has stills & video content. Previewing & playback on my phone works fine. However, when I playback the album hooked up with an Apple Composite AV cable, everything plays fine until it gets to the video where it just gives a black screen with the audio only playing. If I play the individual clip from iTunes on my phone, it plays back perfectly over the AV cable. Has anyone had any success playing back video in an Album over an Apple AV cable? Is it because I'm using an older model phone? Any help would be appreciated.

Are you sure it is not plugged into an Ethernet port on the back by mistake? That would present a 150 ohm short circuit. The sockets are very similar, and some Ethernet sockets will take a phone cable as well.
I am surprised that a Freesat box needs a phone line, unless its for some form of remote control.
There are some useful help pages here, for BT Broadband customers only, on my personal website.
BT Broadband customers - help with broadband, WiFi, networking, e-mail and phones.

Similar Messages

  • IPod won't work when iTrip is connect to car charger

    When I connect my itrip to the car cigarette lighter the iPod won't work, i.e. it will plsay the current tune but the controls don't respond and it stops playing when the current tune ends. It works ok when I disconnect the power.
    Ipod model M9244B version 2.3
    Any ideas?

    Try the following to rule out a software problem:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Unsync all music and resync
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up           
    - Restore to factory settings/new iOS device.
    If still problem that indicates a hadware problem, likely a bad battery. Make an appointment at the Genius Bar of an Apple store.
    Apple Retail Store - Genius Bar

  • Mail won't work when VPN is connected

    I use VPN to blog for a newspaper, from home. I don't access the company's internal mail system--I just use VPN to get through security and use wordpress on the in-house servers.
    But when I connect with VPN, mail stops working (for gmail, verizon.net, hotmail). I otherwise have full access to the internet; I can get gmail through the web, for example. But since I use Mail extensively, I'd like to be able to have it and VPN active at the same time.
    My current workaround is just to use VPN for posting, then I get out. But this is a big hassle. Is there a mail setting that I can change that will let it work while (Cisco) VPN is active?
    (I'm a freelancer using my own iMac, so I get no tech support from work.)

    http://docs.info.apple.com/article.html?path=Mac/10.6/en/11941.html
    Any chance that you have "Send all traffic over VPN connection" enabled ?
    I use the OSX internal VPN to connect to my Office PC and can use Mail while VPN-connected.
    Stefan

  • Printer won't work with Ethernet cable connected to AEBS

    I've been using my AEBS with built-in modem for a year with no problems. Today I got a DSL modem (finally available in my area) and when I connected the ethernet cable from the DSL modem to my AEBS, my printer stopped working. It now gives the following error message: "Printing Problem - the process "mdns" stopped unexpectedly with status 1". The printer is still available from the printer setup utility and I tried deleting and reinstalling the printer
    I have tried several different variations of restarting the modem and AE in various orders, but no joy. However, when I disconnect the ethernet cable from the AE and restart it, I can print fine.
    I have three computers on the network (G4 MDD PowerMac, G5 iMac, and C2D MPB) and I get the same error message from all three.
    Any suggestions (perhaps an interpretive dance to the network gods?) on how to get both the DSL and printer to play nice at the same time??
    Thanks, Eric

    see if anything in the Printer Troubleshooting Guide helps.

  • Firefox doesnt work when LAN cable connected but does with wireless

    When connected to the LAN (provided by a cable company) I get server not found messages but woeks okay when using a wireless connection. I have cleared recent history = cache and cookies, rest proxy server to no proxy and put firefox.exe into my firewall exceptions and still no go. I am borrowing the wireless connection, my connection is through the cable.
    == This happened ==
    Every time Firefox opened
    == within the last 24 hours

    Hello.
    When using a LAN cable, can you connect to the internet using other software (such as download managers, other browsers, IM clients, update software...)?

  • After upgrading to yosemite my magic mouse won't work when I wake up my mac mini. I have to power down then restore power to get it to function.

    after upgrading to yosemite my magic mouse won't work when I wake up my mac mini. I have to power down and restore power for it to function. Also cannot send email from mac mini or iPad.

    after upgrading to yosemite my magic mouse won't work when I wake up my mac mini. I have to power down and restore power for it to function. Also cannot send email from mac mini or iPad.

  • Video playback from PB17 to Sony TV firewire port ?

    I'm wondering if it's possible to get video playback from my PowerBook 17 to a Sony HDTV firewire port ? I can't see in prefs where you can do this. Is there some software that enables this? I tried to select firewire playback from Final Cut Pro even and that didn't work either. The TV recognises the Powerbook. I don't think it's possible but why not try?
    Powerbook G4 1.33GHz   Mac OS X (10.4.7)   2 GB RAM + I want Seagate Momentus 5400.3 160GB HD

    This is what abrody has to say on the subject.
    Yes, but only at 720 x 480 resolution. Some TVs offer higher resolutions and DVI ports where you can do a DVI to DVI connection. And actually there was a dongle which came with your Powerbook which supports S-Video via its S-Video port.
    Cheers Don

  • My 8 key won't work when I press it to put in my password, what can I do?

    my 8 key won't work when I press it to put in my password, what can I do?

    Presumably you are connecting it from the *Dock Connector.* In this case, the controls on the car stereo should be controlling the iPod and the iPod's controls are disabled.
    If you are using the car's connection interface, consult the car manual to find out how to control the iPod. If you are using an adaptor between the iPod and car, ask the adaptors installer or manufacturer.
    Phil

  • Since I updated to Yosemite my mouse won't work when I turn on, unless I unplug it and put it in again

    I have a mini mac updated to Yosemite, since I updated,  my mac mouse won't work when I open ...So I have to unplug from my mac keyboard and plug back in again . Does anyone have the same problem?

    Thanks Eric...a few other things have happened too...still working on them, I like the change just updating and figuring out why I might have some other problems...thånks again

  • Installed Windows 7 on bootcamp but now my wireless mouse won't work when in windows. What can I do?

    Installed Windows 7 on bootcamp but now my wireless mouse won't work when in windows. What can I do?

    assuming it is an optical mouse (no ball etc.) then there aren't any moving parts involve in the motion detection
    so there's a faulty component or connection
    from what you describe it could be just a loose/broken connection, so if you know someone familiar with electronics see if they can open it up and have a look

  • Movies won't work when a DVD is inserted ?

    Movies won't work when a DVD is inserted.  What do I do to watch a movie ?

    Just one DVD or all of them?
    Some DVD's just need a gentile cloth and rubbing alcohol wipe on the bottom to rid of fingerprints etc.
    If your using out of region code DVD's (each area of the world has regions codes assigned to the computer and disks) then that needs to be changed.
    This can happen if you buy a Mac used from another part of the world or use DVD's from another region.

  • HT1430 my iPhone4 will not turn on or show that is working at all, i have tried to charge it so that the screen will light up but it won't work, when plugged into the computer iTunes does not show any sign it is plugged in, what do i do?

    my iPhone4 will not turn on or show that is working at all, i have tried to charge it so that the screen will light up but it won't work, when plugged into the computer iTunes does not show any sign it is plugged in, what do i do?

    There is a hardware problem.  Whether it's worth it to you to have no working phone for 2 months until you can update vs paying for replacement/repair now is a question only you can answer.

  • Video playback issue for Adobe Presenter 9 when publishing to Adobe Connect Pro 7

    Hello!
    I am having an issue with video playback for Adobe Presenter 9. When I preview the presentation on my computer there are no issues with any of the MP4 videos that I have loaded into my presentations. However, when I publish the presentation to Adobe Connect and access the URL the videos are either delayed or do not appear at all.  We are using our own Adobe server which we purchased in 2008, along with Adobe Connect Pro 7. We recently updated our Adobe Presenter software to version 9. Is there an incompatibility issue between Adobe Presenter 9 and our current Adobe Server/current version of Adobe Connect? Or do I need to do something different in Adobe Presenter when importing the videos?  Note: I have tried FLV videos and had the same issue.
    We are trying to launch of series of webinars (each webinar has between 15-42 slides), which was the whole purpose of updating our Adobe Presenter and Adobe Captivate software....hopefully we can resolve this video issue.
    Thanks!
    Dana

    Connect 7 didn't support MP4 video content, as I recall. Another issue is that Connect rooms are using Action Script 2 (AS2) while Presenter 9 uses AS3, and the two code languages don't play well together. You don't mention if you are using the meeting application to display the presentation, but it is worth mentioning. If the presentations are stand alone, then the AS3 issue should be non-existent, but the MP4 support may be.
    Is there a reason you haven't updated the Connect software to Connect 9 (or at least Connect 8.1 where the Connect application became AS3 as a whole and supported MP4 content)?

  • My nano works when connected to a computer but won't work when unconnected.  The battery is full.

    My nano won't work when it is not connected to a computer.  It won't even reset.  If I pull it into my computer it will work and it shows that the battery is full.  What might be the problem?

    Then that sounds to be the Apple ID that owns this Mac, the OS and any preinstalled apps. Did that Apple ID set the Mac up when new?

  • I am having problems with video playback from the Internet such as you tube on my iPad. What's up?

    I am having trouble with video playback from the Internet such as you tube. What's up?

    Your video playback will also depend on your net speed. If you have slow internet, you will stream video slow. If your video stops and starts, you can try pausing it for a minute or so and then try to watch. Let more of it buffer before you try to watch.
    Sometimes your connection is so slow you literally play faster than it buffers, which means it stops and stutters continually

Maybe you are looking for