What is the Current ABAP Kernel version for SAP ERP 6 (ECC6)..?

What is the Current ABAP Kernel version for SAP ERP 6 (ECC6)..?

Hi,
Login to  http://service.sap.com/swdc using your S user-id
Serach for kernel
Check for your relevent kernel patch (unicode/non-unicode , NW release etc.)
Regards,
Rajneesh

Similar Messages

  • What is the current AE firmware version for MacBook Pro 2Ghz Core Duo?

    My losing connection every so often MPB shows:
    Wireless Card Type: AirPort Extreme (0x168C, 0x86)
    Wireless Card Locale: USA
    Wireless Card Firmware Version: 0.1.27

    Good question. They basically said I needed to send it in for repair. Afterward I brought up the version and was told it would be up to date if Software Update was completed. I mentioned the difference between the version on my iMac and the MPB and was told that perhaps the MPB AE is defective and not updating. I am just curious to know what others have.

  • Kernel version for SAP ERP 6 Ehp4

    Hi all,
    We have installed ERP 6 Ehp 4 with SAP kernel 7.01. Is it possible to upgrade kernel to version 7.20 without upgrading other components (basis) to Ehp 5?
    Thank you for your answers
    Andrej

    Hi, this is so called Rolling Kernel switch.
    you can replace to the release 720 without much problems. I have done this in release 710.
    However, could exist some situations that you have to update the support package like in my case that I had the short dump DDIC_TYPELENG_INCONSISTENT after the kernel update. You can check further details in note  1636252.
    this is the main note about the project: 1616491
    Cheers,
    Clébio

  • What are the minimum hardware Server requirement for SAP BI BO

    I would be thankful if someone can please tell me  What are the minimum hardware Server requirement for SAP BI BO. if a separate Desktop is used for the server or local server purpose.
    In the Desktop
    I have 8 GB RAM
    2.60 Ghz Processor ( CPU)
    System type: 64 bit OS
    regards
    ranendra

    Hi,
    Refer the attached PAM for BO 4.0 and 4.1.Minimum hardware details are listed there.
    http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/f0134dbb-8f10-3010-5084-cf90dbb35284?QuickLink=index&overridelayout=true&58879706677537
    http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/507d3365-009b-3010-04b0-e5abc8f00c91?QuickLink=index&…
    I haven't try with your similar specification but  in the below link some one tried with similiar one.
    What are the minimum system requirements to install SAP BO 4.0/4.1
    Amit

  • What r the industries suuporting or helping  for SAP project implemetation?

    what r the industries suuporting or helping  for SAP project implemetation

    Hi
    The project team selects the processes that best fit your business from R/3’s functional offering, using the following tools:
    AcceleratedSAP Implementation Assistant
    Question and Answer Database (Q&Adb)
    Business Process Master List (BPML)
    R/3 Structure Modeler
    Business Navigator and external modeling tools
    Regards
    Manoj

  • What is the Best After Effects Version for my Computer?

    Hey I have a Windows 7 with a Pentium (R) Dual Core CPU T4400 @2.20GHz   2.20GHz
    RAM 3.00 GB 64bit Oberating System
    Display Adapter: Mobile Intel (R) 4 Series Express Chipset Family
    What is the best earlier model of After Effects or maybe current for my computer type?
    Or what is the best settings for After Effects to run faster for animation?
    Thanks

    Unless you plan on using a very old version of After Effects, which will cause a bunch of other problems on Windows 7, you simply need more RAM.  3 GB is barely enough to keep Windows running smoothly, let alone running a RAM-hungry app like AE.  Your first priority is to put more RAM in your computer.

  • What is the latest Ovi maps version for E72?

    According to maps application I have:
    c3.04 10wk17 bo7 MW OpenGl LM MN
    Map Version 0.1.25.114
    is that the newest for this phone?
    Solved!
    Go to Solution.

    i hope this is not off topic, but i have a similar problem with map versions, but slightly different circumstances.
    i have firmware 051.018, with ovi maps v3.04 10wk32 b03 and map version 0.1.24.114
    i want to upgrade the firmware to the newer v071.004 with ovi map v3.04_10wk32_b04 (or so you say). 
    my question is this. does firmware v071.004 come with ovi map v3.04_10wk32_b0, and does it require maps version 0.1.25?
    if so it'll really suck to upgrade the firmware for me and i probably won't do it because i downloaded offline maps for the whole world (like 8 gigs) from a mirror site and have been happily prancing about the globe on my e72 for sometime now. my e72 has almost become more of a gps map device than a phone. honestly i would rather buy another nokia with updated maps than give up my precious world map on the old firmware.
    should i upgrade or not?
    so, coincidentally, i am also very interested in finding out the newest version of ovi maps to be included in the 070 firmware.
    thank you and i hope this wasn't too much of a curveball.

  • What is the correct Sun Java version for Plus ?

    OK so I am running Version 1.4.2_06 (build 1.4.2_06-b03) for Disco Plus.. Is that the correct version ? I am trying to debug an error (Outstanding Refresh) and I need to eliminate the Java version being the cause:
    Can anyone confirm ? thanks OBX
    OracleBI Discoverer 10g (10.1.2.1)
    Oracle Business Intelligence Discoverer Plus 10g (10.1.2.48.18)
    Discoverer Model - 10.1.2.48.18
    Discoverer Server - 10.1.2.48.18
    End User Layer - 5.1.1.0.0.0
    End User Layer Library - 10.1.2.48.18
    Oracle Database 10g Enterprise Edition Release 10.2.0.1.0 - 64bi

    Hi OBX
    Yes that is the correct version, at least that's the one that comes out of the box. You can upgrade to later versions but you have to do this both on the server and on the client. One thing that you must not do is allow the client machines to upgrade when the server is still on 1.4.2_06
    I hope this helps
    Best wishes
    Michael Armstrong-Smith
    URL: http://learndiscoverer.com
    Blog: http://learndiscoverer.blogspot.com

  • What is the latest available AsyncOS Version for the IronPort C160

    Hello @ all,
    i try to figure out if there is a AsyncOS 8.x update for the Cisco IronPort C160 available.
    My Cisco C160 cluster is running the 7.6.0-357 AsyncOS version.
    Greetings Robert

    8.0.1-023 is still the latest GA release.  If you are on that release, you won't see any of the FCS releases.  
    Q: Are there any other releases available for AsyncOS?
    A: Yes, FCS candidates are available for provisioning, but you must open a support case and request to be added to the FCS provisioning group.  Please see our other CSC blog posts for recent FCS release information.
    I'll shoot you a DM and work with you to get your SN and info, if you are wanting to get 8.5.6-073?
    I hope this helps!
    -Robert
    (*If you have received the answer to your original question, and found this helpful/correct - please mark the question as answered, and be sure to leave a rating to reflect!)

  • What is the highest os x version for a powerbook g4

    i am trying to run minecraft on my powerbook g4 but cannot.  The apple store genius told me that the g4 can only be ungraded to os x 10.5.8 Leapord and the reason minecraft will not work.  Is there a version of minecraft i can use or a way to upgrade the G4 to 10.6.6 so that it will allow minecraft to work?

    Actually, in theory, Snow Leopard should be able to run fine on some older G4/G5 systems,
    There is no theory about it.   Snow Leopard is entirely Intel CPU based.   There is no Intel architecture on the G4/G5 systems, thus they can't run 10.6 no matter how you hack it.    Unless you can show me a link where Snow Leopard in actuality can run on a G4 or G5 system, please do not state such a thing exists.  And while some people may succeed in producing a "mod" machine with an Intel CPU, it is not a Mac, and it doesn't have the correct cooling to ensure the machine doesn't overheat.  Apple machines are tightly integrated units that if done not according to design can have surprise issues with how they behave.
    Mavericks can run on some 2007 Macs.   The issue has to be with the GPU that is being addressed.      And there is a hack to make the original Mac Pro models run Mountain Lion, and possibly Mavericks.  Here is the hack: http://www.jabbawok.net/?p=47

  • What were the transactions that was used for a period in ECC6

    How to get a list of transactions that have been used for last 3 months.

    Please do excuse me... i have typed my message giving a wrong understanding to you allu2026
    Let me phrase my question clearly this timeu2026 I am extremely sorry for taking your time on this and appreciate for the quick respondu2026
    My requirement is to know few things:
    1. When was a program, transaction last used?
    2. How to know which users are using which transaction or executing which program?
    3. Which are the most frequently used programs or transaction?
    I tried working on ST03N but seems like I either am using it wrongly so I cannot view what I really wantu2026 Also one more thing to add we have not enabled audting becase of the performance issues...
    We are using ECC 6.0 with AFS 6.0
    Thanks alot for all the help...

  • What is the 'bwuser' under security setting for SAP DB

    Forum,
    Could anyone advise what the 'bwuser' is and what it's purpose is. This is something which has been found under the security settings for a SAP database. This data has recently been migrated across to a new SQL 2008 STD server.
    Regards,
    Juan

    Hi Juan,
    This user is only used in connection between SAP B1 and Business Warehousing. It should not be deleted without purpose.
    Thanks,
    Kumar

  • What is the name of PAR file for SAP logo?

    We want to know  the exact name for the PAR file for the SAP logo at the upper
    right conner of the EP, and the PAR file for the picture before the SAP logo.
    We know it is in the pcd directory but there are too many.
    Points guaranteed. Thanks!

    Hi Jennifer,
    That par file name is "com.sap.portal.navigation.masthead.par.bak".
    It is available at System Administration>Support>Portal Runtime>Browse and Deployments>ROOT/WEB-INF/deployment/pcd.
    If u download that file to ur NWDS u can see the logo icon and pictures used inside the image folder presents in dist folder.
    In the coding part they have used the url to this pictures and logos.
    Note:
    While downloading that file from pcd save it with the extension .par remove that .bak from the name.and import that par file to ur NWDS.
    Regards,
    Tamil K

  • CRM 5.0 Compatibility with backend upgraded to EHP4 FOR SAP ERP 6.0 / NW7.0

    Hello,
    What are the  compatibility issues for EHP4 FOR SAP ERP 6.0  Upgrade with CRM 5.0 ? Are there any OSS notes to address upgrade specific issues?
    Following are the System Details:
    Upgraded EHP4 FOR SAP ERP 6.0 / NW7.01
    Component: SAP_APPL 
    Release:      604
    Support Pack: SAPKH60402
    Level:  0002
    Existing CRM 5.0
    Component:     BBPCRM
    Release: 500
    Support Pack: SAPKU50006
    Level: 0006
    Thanks,
    AG
    Edited by: Arijeet Ganguly on Sep 15, 2009 11:49 PM

    Hi Amirsd,
    You will need to use your Solution manager system to apply EHP 4 to your newly installed system.
    Use MOPZ to generate XML file which contains the packages to be downloaded to upgrade your current system to EHP 4.0
    After that download EHPI tool from SAP Marketplace and use EHPI tool to install downloaded packages.
    It would run in 7 phases including downtime phase.
    Let me know if you have any queries. !!!!
    Regards,
    Shobhit Garg

  • What is the latest kernel version for OL6

    Hi,
    After a yum update, this is what I got:
    2.6.32-300.39.1.el6uek.x86_64
    I am using a SSD and it seems (based on en.wikipedia.org/wiki/TRIM) that
    support for ATA TRIM was added in 2.6.33.
    My question is what is the latest kernel version for OL6?
    Thanks,
    Zhe

    alwu wrote:
    My question is what is the latest kernel version for OL6?2.6.39-300.17.2 (which is actually 3.0.17 under the hood) is available in the ol6_x86_64_UEK_latest channel. You will need to modify your ULN channel subscription or which channels are enabled from public-yum.oracle.com to install this kernel.
    Edited by: Avi Miller on Dec 6, 2012 10:41 AM

Maybe you are looking for