What is the resource control corresponding to each kernel parameter

Question

Hi
I am trying to prepare (i.e. tune) a Solaris 10 instance for an Oracle 10g install using a Solaris 10 project.
I am new to using Solaris 10 project resource controls so I might get some of this totally wrong.
I know all of the "old" kernel parameter names: what each represents and its' required value and I know some of the corresponding resource controls but not all of them.
That is I do not know the resource control corresponding to each and all of the kernel parameters.
e.g. I know:
semsys:seminfo_semmsl == process.max-sem-nsems == The maximum number of sempahores that can be in one semaphore set
shmsys:shminfo_shmmax == project.max-shm-memory == The maximum size(in bytes) of a single shared memory segment
shmsys:shminfo_shmmni == project.max-shm-ids == The number of shared memory identifiers
But I do not know, for example, what resource control corresponds to:
semsys:seminfo_semmns == The number of semaphores in the system
Is there a list somewhere of the resource control corresponding to each of the kernel parameters ?
I know I can set some kernel parameters in /etc/system but that should only be used for system - wide kernel parameters, right ?
I know there are project, process, task and zone classes of resource controls.
Can a resource control of any and all of these types be set in a project ?
Are zone resource controls equivalent to system-wide resource controls ?
Are there corresponding resource controls to all kernel parameters e.g. such as noexec_user_stack ?
I have set noexec_user_stack in /etc/system.
And finally - just to be sure - using a project makes the resource control values permanent, right ?
Thanks
Brett.

Answer 1

Hi;
Please check below which could be helpful for your issue:
Kernel setup for Solaris 10 using project files [ID 429191.1]
Regard
Helios