When syncing iPod the PC lost power. once power restored synced iPod but the sleeve detail has been blanked. Also when syncing a 'miss-match' message is reported on iTunes. how do I get the sleeve detail back onto iPod?

Question

When syncing iPod the PC lost power. once power restored synced iPod but the sleeve detail has been blanked. Also when syncing a 'miss-match' message is reported on iTunes. how do I get the sleeve detail back onto iPod?

Answer 1

http://ww2.cs.fsu.edu/~rosentha/linux/2.6.26.5/docs/DocBook/libata/ch07.html#excatATAbusErr wrote:
ATA bus error means that data corruption occurred during transmission over ATA bus (SATA or PATA). This type of errors can be indicated by
ICRC or ABRT error as described in the section called “ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION)”.
Controller-specific error completion with error information indicating transmission error.
On some controllers, command timeout. In this case, there may be a mechanism to determine that the timeout is due to transmission error.
Unknown/random errors, timeouts and all sorts of weirdities.
As described above, transmission errors can cause wide variety of symptoms ranging from device ICRC error to random device lockup, and, for many cases, there is no way to tell if an error condition is due to transmission error or not; therefore, it's necessary to employ some kind of heuristic when dealing with errors and timeouts. For example, encountering repetitive ABRT errors for known supported command is likely to indicate ATA bus error.
Once it's determined that ATA bus errors have possibly occurred, lowering ATA bus transmission speed is one of actions which may alleviate the problem.
I'd also add; make sure you have good backups when ATA errors are frequent