10.4.3 and Airport Extreme 5.6 incompatibility

Network stopped after upgrading 10.4.3 followed by Airport Extreme upgrade to V5.6. Works again if you downgrade base station firmware to 5.5.1

Network stopped after upgrading 10.4.3 followed by Airport Extreme upgrade to V5.6. Works again if you downgrade base station firmware to 5.5.1

Similar Messages

  • How to connect my iPad, Brother printer, and AirPort Extreme?

    How to connect my iPad, Brother printer, and AirPort Extreme?

    I don't believe any of the Brother printers are AirPrint-enabled. Is your Brother printer network-ready? That is, does is support either/both a wired or wireless connection or just uses USB to connect?

  • Extending a network with Time Capsule and AirPort Extreme (via Belkin powerline)

    Hello -
    I've seen many topics about extending wireless networks here, but none seems to resolve the issue I'm having. I currently have a setup where a DSL cable modem is connected to a Time Capsule and I need to extend this network to another room using an AirPort Extreme.
    I live in a very old apartment in Brazil and the walls seem to block the signal from one room to another, hence the need to extend it. Since wireless signal is very weak between rooms, I bought a Belkin powerline AV500 so I could connect both Time Capsule and AirPort using the electrical power at home (just installing a regular Ethernet cable between rooms is not an option).
    I started with the basics: configure the Time Capsule + DSL as a standalone network, and it works perfectly within it's range. Then I connected the Belking powerline, plugged a MacBook via Ethernet on the other end and still got very good results (actually better speed than expected). Used it for a while with streaming and other network intensive tasks to make sure it could sustain the connection.
    Finally, pluggned the AirPort Extreme on the Belking powerline and this is where the problems started. AirPort Utility 6.3.1 only gives me the option of extending a network wirelessly - it doesn't seem to give me the option of extending it via Etherenet (roaming), which is not good in my case. Luckly I had a copy of AirPort Utility 5.6 which seems to do the job (or I thought so), but it's still not working well.
    Although I managed to configure both with the same name, it doesn't seem reliable and some devices (the iPhone 5, for example) are unable to connect and end up with a self-asigned IP address. I'm almost sure I'm doing something wrong on the setup, as I've seen a similar setup working before, so if anyone out there has any clue of what can be done, it will be much appreciated.
    Attached the screenshots of both Time Capsule and AirPort Extreme configurations.
    Thanks a lot,
    -TM
    AirPort Exteme:
    Time Capsule:

    Hello JuliaApple. Welcome to the Apple Discussions!
    You have several ways to configure both base stations for what you are trying to do.
    The simplest would be to configure the Time Capsule (TC) to "join" (AirPort Utility > Manual Setup > Wireless tab > Wireless Mode = Join a wireless network) your existing 802.11n AirPort Extreme Base Station (AEBSn). In this type of configuration the TC would perform as any other wireless client and not perform as a router. It will; however, still allow for both backups and sharing USB devices attached to it.

  • Can a time machine usb drive backup the data from an external usb drive connected to and airport extreme*

    can a time machine usb drive conected to my mac book backup the data from an external usb drive connected to and airport extreme ?

    Hi Adam, if you think yoiur HD may be failing you could do a TM restore onto the new disk. I would rather see you do a clone either SuperDuper or CarbonCopy Cloner.Of your internal drive. That way you have a bootable backup in case it does fail.
    btw - what are the symptoms of your failing drive?
    -mj
    Message was edited by: macjack

  • Macbook pro and airport extreme don't work

    A friend (and all those tv commercials) say everything just works with Macs. Well, not exactly. New Macbook Pro and Airport Extreme can't connect me to the internet. I still have PC connected via ethernet cable to my cable modem and router which is in the basement where the cable enters the house. I've tried the different options in Airport Extreme setup and nothing works. It doesn't help Apple assumes I know everything about DHP PPPOE NAT or whatever all those silly things are.
    Can anyone explain in +very simple+ terms how I get this expensive piece of aluminum connected to the internet?
    Thanks.

    Hello sofarapplesux. Welcome to the Apple Discussions!
    I assume that you will continue to use the modem and router in the basement to get your Internet access ... correct? What is the make/model of this router?
    If that's the case, I will also assume that you have the 802.11n AirPort Extreme Base Station (AEBSn) connected by Ethernet to this router ... correct?
    So your overall network configuration should look something like the following:
    Cable modem > (Ethernet cable) > \[Internet port] router \[LAN port] > (Ethernet cable) > \[WAN port] AEBSn ... close?

  • Is anyone using NETGEAR Push2TV with a MacBook Pro and AirPort Extreme and does it work well for you?

    I am interested in buying a NETGEAR Push2TV display TV streamer to use with my MacBook Pro and AirPort Extreme.
    I saw on the Netgear site that a Intel Wireless Display/WIFI driver software is required for PC's; do we have this software installed already on our MacBook Pro's? Is any one using this box and does it work well for you, any problems or setup issues?

    trying to find out same thing , store said works with new intel processor, My mini dont finding.....

  • Verizon DSL and Airport Extreme

    I'm going to add aniBook (oe whatever Apple will call it by then) this spring, as I want to enjoy the wi fi fun like evryone else. My ISP is Verizon DSL, and I was wondering if anyone else here in the discussion board is currently using an Ibook with Verzion DSL and Airport Extreme. I think Verizon has a modem that supports both wired and wireless networking--which is what I'll need since I won't be retiring my iMac G5 anytime soon. So any adive or info would be appreciated.

    I currently have the ActionTech Modem (supplied by Verizon) as my wireless router, but would like to replace that with my Airport Extreme. Can this be done?
    You will need both. Since both supply NAT, DHCP services and WiFi Access Point, you will have to turn off all three of those in one of them. This is usually called putting the device in "bridge" mode. My recommendation is to turn off those features on the Actiontech modem/router/access point, turning it into a plain DSL modem, and let the AEBSn do all the 3 features (NAT, DHCP, AP).

  • MacBook pro and airport extreme router. How to print wirelessly to an old HP wireless photosmart all in one printer

    With MacBook pro and airport extreme router, how can I print wirelessly to an old HP wireless photosmart all in one printer?  What is needed or what process?

    You need to make sure that the HP has an updated printer driver that works with 10.6 for that printer. You can check here:
    http://www8.hp.com/us/en/support-drivers.html

  • I am trying to hook up my Airport Express to my current network and AirPort Extreme but keep getting the same error message: "This version of AirPort Utility doesn't support this base station. Go to AirPort Service and Support for more information."

    I am trying to hook up my Airport Express to my current network and AirPort Extreme but keep getting the same error message: "This version of AirPort Utility doesn’t support this base station. Go to AirPort Service and Support for more information." Any thoughts?

    This sounds as if you have an older AirPort Express that is no longer supported by the newer Mavericks operating system.
    To check and see if  that might be the case, locate the model number on the side of the AirPort Express. It will start with an "A" followed by four numbers. Hard to see in the faint print.....so you may need reading glasses or a magnifying class to see the model number clearly.
    Model numbers A1084 and A1088 of the AirPort Express are no longer supported by AirPort Utility in Mavericks.
    You will need to use a Mac running Leopard, Snow Leopard, or a PC to be able to administer the older AirPort Express.

  • Are there any compatibility issues with Sonos and Airport extreme??

    are there any compatibility issues with Sonos and Airport extreme??

    Sonos uses its own priopietory wireless protocol SonosNet to distribute audio data among all its products, thus it should not affect other network devices which use standard WiFi 802.11a/b/g/n protocol at all though they may share the same radio channel for wirless signaling.
    On my dual-band (5 GHz / 2.4 GHz) Airport Extreme staion, I select the option "802.11n Only (5GHz) - 802.11n (2.4GHz)" and turn on "Use wide channels" in Wireless configuration in order to use only 802.11n protocol and more radio channels to achieve maximum wireless bandwidth of 400 Mbps. This bandwidth is necessary for quick Time Machine backup to NAS connected to the Airport Extreme station through Ethernet cable. So my iMac and MacBook Pro always connected to the Airport Extreme through 5 GHz radio channel with 802.11n protocol whereas my iPhone 4S always connected through 2.4 GHz radio channel with the same protocol.
    In my living room Sonos ZP-90 (same as new CONNECT model) zone player is connected to Airport Extreme directly through Ethernet cable (recommended by Sonos) and Sonos S5 (same as new PLAY:5 model) zone player in bedroom is connected wirelessly through SonosNet protocol to the ZP-90 zone player in living room.
    These devices are in operation simutaneouly most of the time. Music is playing through the Sonos ZP90/S5 zone players througout the day, I am streaming viedo through Internet (fibre broadband 25 Mbps) on my MacBook Pro in bedroom or iMac in living room or reading news on my iPhone. So far so good and have no encounter any interference problem for about three years. Further more bandwidth for 802.11n protocol does not seem to be affected at all.
    In fact with a low power Fujitsu USB drive (2.5" / 500 GB, designed for notebook) plug into USB port of Airport Extreme, it can be used as NAS drive for Sonos music distribution system without any problem. Just transfer all files from Music folder in my home directory on iMac into this NAS drive and set it up as music source in "Manage > Music Library Settings" in Sonos Controller for Mac application will do. Though the same drive can be served as Time Machine's backup disk as well, an independent full-fledged NAS drive for Sonos and Time Machine backup is better long-term solution for reliability and performance. With the NAS configured as sole music source, you do not need to keep any computer powered on all the time in order to play music through the Sonos system.

  • Difference between Airport Extreme 2011 and Airport Extreme Model

    Is there a difference between Airport Extreme MD031LL/A and Airport Extreme MC340LL/A?

    To get a detailed review of the 5G AirPort Extreme please check out this SmallNetBuilder article.

  • Power backup for dsl modem and Airport Extreme

    Does anyone here have backup power for a dsl modem and Airport Extreme that is successful? I have a name brand power backup and when the power goes off both the dsl modem and Airport Extreme remain on; however, the network connection is lost so the fact that they remain on doesn't help. I have been unable to find anything about this problem on the internet generally and consultation with a well-known squad person has not helped. Any thoughts about this will be welcome.

    Yes, I agree. But since the backup power keeps the modem powered, why doesn't the dsl connection continue? The squad person I talked with told me that the speed with which the backup power units replace power during an outage is about the same across different backup brands/units (I don't recall the speed but it was in milliseconds) and should be quick enough to retain the dsl connection. Doesn't happen.

  • PC Used to work with XP and airport Extreme Basestation but not with Vista

    Please help, my PC Used to work with XP and airport Extreme Basestation but not now with Vista. I have a MacBook Pro connected and also a Mac Pro connected to the network on it and they still work, i have put the latest software on the PC and the firmware is up to date. The only thing i can see on the network on the PC is the basestation Hard Disk (shared also to the Macs) but i cannot connect with the password, i have tried everything in my knowledge, including formatting the machine and reinsatlling OS and changing security setting to no avail. Any ideas anyone?

    With regard to your printer problem - take a look at this discussion:
    http://discussions.apple.com/thread.jspa?messageID=6312413&tstart=0

  • What's the difference between airport express and airport extreme?

    airport express and airport extreme? whats the difference??

    http://store.apple.com/ca_epp_5000967/product/MC414/airport-express-base-station
    http://store.apple.com/ca_epp_5000967/product/MD031AM/A/airport-extreme-base-sta tion

  • Airport Express and Airport Extreme

    Hello,
    I am trying to setup a wireless network. What is the difference btw Airport Express and Airport extreme. Do i need both? If yes then why?
    Would appreciate a solution from layman's perspective.
    Thanks

    Hello Indian71. Welcome to the Apple Discussions!
    Check out this excellent iFelix table to help show the differences (features-wise) between the AirPort base stations: AirPort base station differences

Maybe you are looking for

  • Itunes and Quicktime wont install

    When I tried to update my iTunes and Quicktime recently, it succesfully downloaded, began installing, and once the progress hit Quicktime, and error showed "an older version of quicktime cannot be removed." Now the issue is, that before this happened

  • 10g Full Database Dump Takes more than 2 Hours Still not finished

    Hi all, Full Database Dump Takes more than 2 Hours, Still not finished. Version - Oracle 10g 1.0.2.0 Database Size is Around 160GB. Used Below Query to take Full Database Dump. expdp user/pwd@10gdb full=y directory=test_dir dumpfile=curent10g.dmp log

  • Sql server edmx to oracle edmx converstion

    in my project i migrate Edmx from sql to oracle: for this i did generated scripts from sql server to oracle using Database script generation in entity framework. In this i got number datatype for boolean,bit datatypes when i place this code          

  • Schema tool simply doesn't output anything

    In what situations does the ant schematool not output anything and simply let the ant script continue? I have the following piece of ant script: <antcall target="compile"/> <taskdef name="schematool" classname="com.solarmetric.modules.integration.ant

  • Bridge no longer opens files using ACR!

    I do have ACDSee Pro Photo Manager and perhaps this mucked with my installation. I can no longer open pictures in ACR -- it defaults all formats to ACDSee Pro. Even though the preference is set to use ACR, no matter what I do ACR will not open in Bri