11gr2 Dataguard Active Standby - Unable to get Real-Time apply working

Question

As above, I am unable to get real time apply to work WITHOUT it switching my standby back to MOUNT state. There does not seem to be anyting obvious from the broker, or alert logs.
On the Standby:
SQL> alter database recover managed standby database cancel;
Database altered.
SQL> alter database open read only;
Database altered.
SQL> select open_mode from v$database;
OPEN_MODE
READ ONLY
SQL> alter database recover managed standby database using current logfile disconnect;
Database altered.
SQL> select open_mode from v$database;
OPEN_MODE
MOUNTED
Primary:-
SQL> SELECT status, recovery_mode FROM v$archive_dest_status where dest_name = 'LOG_ARCHIVE_DEST_2';
STATUS RECOVERY_MODE
VALID MANAGED REAL TIME APPLY
Edited by: Imran on Apr 17, 2012 10:56 PM

Answer 1

Hello;
This is expected.
Works the same exact way on my system. How Redo Data is applied is set when the database is MOUNTED.
See - 6 Redo Apply Services
Data Guard Concepts and Administration 11g Release 2 (11.2) E10700-0
The document is vague on this at best, but think about the error you get if you try to start apply twice.
Data Guard Real-Time Apply FAQ [ID 828274.1]
Best Regards
mseberg
Edited by: mseberg on Apr 17, 2012 10:04 AM
h1. Test
Connected to:
Oracle Database 11g Enterprise Edition Release 11.2.0.2.0 - 64bit Production
With the Partitioning, OLAP, Data Mining and Real Application Testing options
SQL> alter database recover managed standby database cancel;
Database altered.
SQL> alter database open read only;
Database altered.
SQL> alter database recover managed standby database using current logfile disconnect;
Database altered.
SQL> select open_mode from v$database;
OPEN_MODE
READ ONLY WITH APPLY
SQL> So I get different results ??
Edited by: mseberg on Apr 17, 2012 10:40 AM
h2. Still more
I would like to change my answer. Based on my test and queries as shown below I believe REAL TIME apply is working. Note the last log says NO because its in progress.
Checking last sequence in v$archived_log
STANDBY               SEQUENCE# APPLIED    COMPLETIO                                               
STANDBY                     343 YES        16-APR-12                                               
STANDBY                     344 YES        16-APR-12                                               
STANDBY                     345 YES        16-APR-12                                               
STANDBY                     346 YES        16-APR-12                                               
STANDBY                     347 YES        17-APR-12                                               
STANDBY                     348 NO         17-APR-12                                               
6 rows selected.
----------------Last log on Primary--------------------------------------|
MAX(SEQUENCE#)                                                                                     
           348                                                                                     
1 row selected.Yes, I doubled check and it works on mine. I guess I read what I wanted to read.
All my Standby redo are setup correctly ( size and numbers )
READ ONLY WITH APPLYYour answer my be the Uwe answer at the end of this thread :
Enabling the Active Dataguard and Real Time Apply
Best Regards
mseberg
Edited by: mseberg on Apr 17, 2012 10:50 AM