13" MacBook Pro early 2011 model Randomly Shutsdown and Battery goes to Zero

Question

Hi,
I have an early 2011 13" Macbook Pro that randomly shuts down.  It just happend to me when battery was plugged and fully charged. After it shuts down the battery indicator on the side of the computer shows one blinking green light.
I have done a clean installation and problem persists. Any help will be greatly appreciated.
Battery Information:
  Model Information:
  Serial Number:          W0********3BA
  Manufacturer:          SMP
  Device Name:          bq20z451
  Pack Lot Code:          0
  PCB Lot Code:          0
  Firmware Version:          201
  Hardware Revision:          000a
  Cell Revision:          158
  Charge Information:
  Charge Remaining (mAh):          1827
  Fully Charged:          No
  Charging:          Yes
  Full Charge Capacity (mAh):          5120
  Health Information:
  Cycle Count:          321
  Condition:          Normal
  Battery Installed:          Yes
  Amperage (mA):          3023
  Voltage (mV):          11957
System Power Settings:
  AC Power:
  System Sleep Timer (Minutes):          10
  Disk Sleep Timer (Minutes):          10
  Display Sleep Timer (Minutes):          10
  Wake on AC Change:          No
  Wake on Clamshell Open:          Yes
  Wake on LAN:          Yes
  Current Power Source:          Yes
  Display Sleep Uses Dim:          Yes
  PrioritizeNetworkReachabilityOverSleep:          0
  Standby Delay:          4200
  Standby Enabled:          0
  Battery Power:
  System Sleep Timer (Minutes):          10
  Disk Sleep Timer (Minutes):          10
  Display Sleep Timer (Minutes):          2
  Wake on AC Change:          No
  Wake on Clamshell Open:          Yes
  Display Sleep Uses Dim:          Yes
  Reduce Brightness:          Yes
  Standby Delay:          4200
  Standby Enabled:          0
Hardware Configuration:
  UPS Installed:          No
AC Charger Information:
  Connected:          Yes
  ID:          0x0100
  Wattage (W):          60
  Revision:          0x0000
  Family:          0x00ba
  Serial Number:          0x00b2632f
  Charging:          Yes
<Edited by Host>

Answer 1

If you have more than one user account, you must be logged in as an administrator to carry out these instructions.
I've tested these instructions only with the Safari web browser. If you use another browser, they may not work as described.
Triple-click anywhere in the line below on this page to select it:
syslog -k Sender kernel -k Message CSeq 'n Cause: -' | tail | open -ef
Copy the selected text to the Clipboard by pressing the key combination command-C.
Launch the Terminal application in any of the following ways:
☞ Enter the first few letters of its name into a Spotlight search. Select it in the results (it should be at the top.)
☞ In the Finder, select Go ▹ Utilities from the menu bar, or press the key combination shift-command-U. The application is in the folder that opens.
☞ Open LaunchPad. Click Utilities, then Terminal in the icon grid.
Paste into the Terminal window by pressing the key combination command-V.
The command may take a noticeable amount of time to run. Wait for a new line ending in a dollar sign (“$”) to appear.
A TextEdit window will open with the output of the command. If the command produced no output, the window will be empty. Post the contents of the TextEdit window (not the Terminal window), if any — the text, please, not a screenshot. The title of the window doesn't matter, and you don't need to post that.