2 SSIDs and VLANs on each AP

Question

I'm new to configuring IOS wireless APs, in particular, a couple of 1142Ns in autonomous mode and looking for examples/answers. These APs will be connected to the POE ports on an ASA 5505 firewall. I'm also configuring the 5505.
The requirements are that each AP have an "internal" and "external" SSID and each AP will have two VLANS.
The APs should allow roaming between them.
The internal SSID will allow full access to internal corporate networks and the Internet and will use WPA2. It will use the corporate dhcp server or employ the IOS dhcp server to hand out addresses.
The external SSID will only have access to the Internet and will use WEP. The ASA 5505 will provide dhcp services to these clients.
The two PoE ports on the ASA 5505 will be trunked for both the inside and dmz VLANS.
If anyone has examples of any of these requirements, comments, and/or similar config they are willing to share, please post them.
In particular, I would like to see an examples of the roaming config, VLAN config, SSID config, and WPA2 and WEP config.
Thanks in advance.

Answer 1

Hi,
Cisco terms are sometimes Complex!! In English this means.. "broadcasting the SSID or NOT" if you want your laptop to detect the SSID while searching for wireless then this is called BROADCAST if not then NON-BROADCAST.. the command is.. Guest-mode under SSID config.. that is..
en
conf t
dot11 ssid
guest-mode                           >>>>>>>>>>>> Broadcasting the ssid
end
en
conf t
dot11 ssid
no guest-mode                      >>>>>>>>>>>> Not Broadcasting the ssid (HIDDEN) MANUALLY WE NEED TO  ENTER THE SSID ON THE LAPTOP.
end
Lemme know if this answered your question..
Regards
Surendra
===
Please rate the posts which answered your quiestion or was helpfull