2xPC3200 to go with 2xPC2600; Which Slots?

I have bought 2x512Mb PC3200 RAM to go with 2x512Mb PC2600 already in my MDD dual 1.25 GHz G4.
Does it matter which slots the faster / slower RAM goes into?

Well, I now have a 2 GB RAM dual 1.25 GHz G4 MDD.
And, I will say, if you run with a lot of programs open, the extra 1 GB does help A LOT !
As I remember one of my mentors saying back in 1971 ( about the DEC PDP-6 at NIH ):
"Nothing makes virtual memory run like Real Memory!"

Similar Messages

I just put 8 gb of memory into my new mini, but the computer is only reading 4gb. It tells me that bank 0 has 4 gb and that bank 1 is empty. Which slot is "o" and which slot is "1" ? I re-wiggled the new memory sticks, but it still only reads one of them.

I just added two new memory sticks to my new mac mini, each stick has 4 gb. The computer tells me that it now (with the new memory) only has 4 gb total, however. It says that bank "O" had 4 gb and bank "1" is empty. My two questions are... Which slot is bank o and which slot is bank 1? The computer didn't beep or anything, so I think its just that it doesn't recognize one card. I wiggled them again, in case maybe I didn't put them in tight or something, to no effect. Any suggestions on what I may not have done right???

Same issue here. All chips, old and new working in bottom slot 0 but nothing working in slot 1 (top.)
It also seems to be important to make the insertion at the right angle that was actually steeper than I thought at first. I also got a nice click when it slipped into place. You can also look at the position of the center slot/protrusion on the bottom chip to get an idea of how far the stick needs to be in.
Another thread pointed out that you have to make sure that the retaining clips don't engage before you get it into place as they prevent further movement.

Which slot should i install my X-Fi

I'm about to change my motherboard soon to a Gigabyte GA-965P-DS3 rev 3.3. Which slot on that board doesn't share its IRQ with other devices, or in other words, which slot is the safest to install the soundcard in (to avoid potential resource conflicts)?
Would appreciate a quick reply. Thanks!

Put the card in the slot far away from graphic card. This is because of EMI disturbing your sound-output. In windows, if you PC supports APIC your chances are very good do not have any IRQ-Sharing. The BIOS- Message wont give you the needed info for IRQ sharing anymore. In windows there are 24! IRQ' s , your BIOS only has access to 6.

I have a iMac and want to know if I can add an additional hynix memory to it? It currently has one with an open slot next two it.

I have a iMac and want to know if I can add an additional hynix memory to it? It currently has one with an open slot next two it.

You can install up to 6 GBs of RAM. You have two RAM slots so you could max out the machine by installing one 2 GB module and one 4 GB module. The largest supported module is 4 GBs, but you could use only one. Best memory performance would be attained by installing two 2 GB modules to provide 4 GBs of RAM. Installing two matching modules implements dual-channel memory that will provide a small increase in memory speed.
Sorry for my memory: Good places for RAM are OWC and DataMem. You do not have to use Hynix RAM. Any RAM will be fine as long as it meets the computer's requirements which are outlined in the section of your use manual for adding memory.

How to configure the wifi access with specific time slot for kids?

how to configure the wifi access with specific time slot for kids?

Which model of AirPort base station do you have? Which version of OS X is your MacBook Pro running?
Wi-Fi access can be limited using the Timed Access feature of the AirPort routers. You would do so using the AirPort Utility.

Which slot for the airport extreme card?

I just picked up an airport extreme card for my mac pro. I located the slot in the mac pro, but there are two on top of each other.
Question: which slot do I have to use: the upper or lower one?
Iemke

Thanks for the answer, however inserting the card was
not the difficult thing. Finding the correct wire for
the antenna was the difficult thing. A apple
certified technician helped me with that issue.
Iemke
I want to buy the mac Pro and install the airport extreme card - what is the model number of the new card (apple tech tell me it is different from the old G4 card of the same name) and which is the correct wire to attach it to?
BTW I know my way around the G4 desktop having upgraded &/or replaced everything screwed down in those
this knowledge will speed up the purchase process-thanks
G4 powerbook 17" Mac OS X (10.4.8)

How to detect as to which slot the SCXI module is present

i want to detect to which slot the scxi module is connected . I have used get scxi info vi , but the
disadvantage is that it does not give the exact slot position the module is present . Please let me know any vi which does this function
Suresh Thangappan

Hello Suresh,
Thank you for contacting National Instruments.
If you have LabVIEW 7.0 or higher, you can use the DAQmx Device Property Node with our NI-DAQmx driver. I have attached an example VI to demonstrate just how easy this can be accomplished.
Regards,
Bill B
Applications Engineer
National Instruments
Attachments:
Acq_Thermocouple_Sample.vi ‏54 KB
DAQ_Device_Property_Node.JPG ‏77 KB

Fibre card which slot?

Does it matter which slot the fibre card goes in? This is for a dual 2.5 G5 with Atto PCIX card.

Nope. Just one that fits.
Sapridyne

I have a dv2-1003ax laptop with a sim slot and unable to install drivers for that sim slot on win7

Hi all
I have a Pavilion dv2-1003 ax with a sim slot. for which i am unable to install driver on windows7 pro 32 bit.
Please help
Thanks

Hey LogicSystems,
What driver are you trying to install? If you could give me some more information on what you are trying to achieve I will be able to help you better.
Thanks,
Sean
-------------How do I give Kudos? | How do I mark a post as Solved? --------------------------------------------------------

MSI K8T Neo-FIS2R - Which slot sound card?.

Hi all,
I have a MSI K8T Neo-FIS2R and was wondering which slot to put my sound card in?.
At the mo it's in pci slot 4 i only have 3/4and 5 availible becuase of my arctic cooler on my rad 9800 pro.
The sound card is on IRQ 19 sharing with the IEE1394 host controller, i dont use firewire so could i disable it in the bios?.
Cheers all.

Hi
Should not make any differance, don't worry about the IRQ, let the comp sort it out, it knows whats where, better than humans do.
Any probs, disable the onboard sound. maybe change PCI slot, but there should not be.
cheers
jocko

I have a Bootcamp partition on my Imac with Mavericks which I can't delete because the Partition Layout is greyed out and is stuck on 'Current'. What can I do?

I have a Bootcamp partition on my Imac with Mavericks which I can't delete because the Partition Layout in Disk Utility is greyed out and is stuck on 'Current'. What can I do? I was trying to install Windows 8.1 but apparently, this is not yet possible.
I was originally able to restore to my original Mac OSX partition using Boot Camp Assistant but then after entering Disk Utility and re-RAIDing the default RAID 1 to RAID 0 in the BootCamp partition (I suspect this is the cause of the problem but why was it defaulted to RAID 1 in the first place?!!!!), forever afterwards, I couldn't restore the single OSX partition.
Whenever I used BootCamp Assistant my choice to 'Install or remove Windows 7 or later version' was greyed out. Finally I went to Disk Utility to repartition but the Macintosh HD and BootCamp disk partition functions were also greyed out (even if I started up from Recovery mode holding down option, command and 'R' and choosing Disk Utility). BootCamp Assistant gives the error message 'The startup disk cannot be partitioned or restored to a single partition' with additional small script 'The startup disk must be formatted as a single Mac OS Extended (Journaled) volume or already partitioned by Boot Camp Assistant for installing Windows', and DU gives the error message 'The full size of the Fusion drive is not available for repartitioning'.
What can I do to fix this problem? How can I make the Partition Layout button active in DU so I can change the partition to all OSX? I'm prepared to wipe off all my data etc to repartition and have backed up all to disk using Time Machine.

My problem is fixed now, thank you. It was caused by my changing the Boot Camp partition's 'RAID1' to 'RAID0'. If I hadn't done that, Boot Camp would still have been able to 'restore' back to the one partition. It was fixed with the help of Applecare by using a terminal and typing a command to erase the IP of the Macintosh disk (not the volume) as well as the IP of the Bootcamp partition (if I remember correctly), but then I had to restore the OS and all my applications and data etc which I had previously backed up using Time Machine. I haven't taken note of the exact command terminology used. It would be wise to speak to Applecare about this if possible.
Two words of warning, 1. According to the cause of this problem, it might be wise, after reinstalling the ops system to reinstall all extra applications one by one, manually, in case a similar problem arises again. Then manually copy back all data. Or the Mac user could use the Time Machine backup and then uninstall all the added apps then re-install them one by one manually. 2. Beware as after all this the user might not have the 'Recovery partition'. There is a small recovery partition (a few 100 Mb is size) which comes with all later Macs. After all this is done this tiny partition might not be there anymore and the user might have to re-install Mavericks again to get it back, or just install the upcoming update of Mavericks due in a month or so.

Can I run Apple TV 1 and 2 together on the same iTunes account and on the same tv with two hdmi slots?

Can I run Apple TV 1 and 2 together on the same iTunes account and on the same tv with two hdmi slots?

Yes.
Captfred

With icloud set up on my 4GS I deleted photos from camera roll. I run an older PPC G5 with Lion which wont run icloud. Can I transfer pics from i stream to camera roll to allow a non-icloud back up to my PPC? Precious photos are close to 30 day cut-off

With i cloud set up on my 4GS I deleted photos from Camera Roll to make space knowing I would have them backed up on icloud via Photo Stream. I now find that my older PPC G5 with Lion which wont run icloud. I have an ipad3 too, which of course does. I want to copy photos from Photo Stream back to Camera Roll on the phone so that I can back up "old school" to iphoto on my ancient mac. The controls seem to suggest that as an option but when I select multiple photos in Photo Stream and select "Save to Camera Roll" the photos do not appear on Camera Roll as expected. I am running close to the 30 day limit and do not want to lose hundreds of precious photos (or have to email them to myself individually). Can the ipad3 help at all? Any ideas good people? Dan

If only it were that easy Winston. I connect with a USB cable, iphoto opens and I can only see the photos in Camera Roll, not Photo Stream. There does not seem to be a way of aceessing other files in the phone from iphoto and, as in my initial message, I can not transfer the photos to Camera Roll on the phone. My iphone and ipad software is up to date, but my iphoto is '08 version 7.1.5 with my mac running 10.5.8 which is the best I can do on the PPC without messing everything up. I dont have the dough for a new mac or I would have gone for that option...am I stuck?

I have a Time Capsule with 2tb of storage, and an I-Mac with 500Gb. (which is at capacity) Can I use the Time Capsule to store data in addition to backing up the hard drive?

I have a Time Capsule with 2tb of storage, and an I-Mac with 500Gb. (which is at capacity) Can I use the Time Capsule to store data from my hard drive that I want to access later in addition to backing up the hard drive?

Can I use the Time Capsule to store data from my hard drive that I want to access later in addition to backing up the hard drive?
Yes, but if you move the "original" data on your iMac to the Time Capsule....then the "original" data is now on the Time Capsule disk.
When...not if...the Time Capsule disk has a problem, you have no backups for this data.
Perhaps a much safer plan might be to add an external hard drive attached directly to your iMac. Then, move the data to that drive from the iMac.
Now, Time Machine will back up both your iMac and the external hard drive so you have "originals" on one drive and backups on another. Would that plan work for you?

HT1476 my iPhone 4 will no longer charge. It is also not recognised in iTunes. There seems to be a problem with the connector slot. I've tried other cables and other computers/plugs but the connection is not being made. Any suggestions?

my iPhone 4 will no longer charge. It is also not recognised in iTunes. There seems to be a problem with the connector slot. I've tried other cables and other computers/plugs but the connection is not being made. Any suggestions?
It seems to me that the connection port is faulty.
George

Looks like a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
Be sure to make an appointment first...

2xPC3200 to go with 2xPC2600; Which Slots?

Similar Messages

Maybe you are looking for