4200v2 looses wireless connection after 24hrs

Question

Hello All
I upgraded my Linksys from 160n router to 4200V2 router.  I configured 3 wireless Linksys webcams and they work fine. After 24hrs they i cannnot connect the via HTTP and webcames IP addresses disapear from the DHCP client table.  If reboot the webcames the it works fine for next 24hrs.  I did not make any modification to any settings and the setting looks just like i had on the 160N router.  Any help/suggestions please??

Answer 1

You could have tried the following settings as well:
A] With the help of Cisco Connect Software (if at all you have installed the router with the help of this software)
          1] Open the software and go to the option which says "Router Settings"
          2] Then click on the option which says "Advanced Settings" which will take you to the router's configuration page.
         3] Lower the MTU (Maximum Transmission Unit) from 1500 to 1400 or less (usually found on your router's main/ basic setup page). Here is the link for determining and setting up the correct MTU size: http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=fbf8e8564632422eaa8ea80bf9dcba64_386.xml&pid=80&re...
B] If you haven't installed Cisco Connect then you can log on to the router's user interface using it's default IP address in the browser which is 192.168.1.1 and type in 'admin' as the password leaving the user name field blank. This will take you to the router's web interface and then follow steps as mentioned above to make the changes.
Then check the connectivity status…