4s has trouble with my home network

My iPhone 4S has trouble connecting to my AirPort Extreme. The only way it connects is if I lay it directly on the extreme.

Power the extreme off and wait a few minutes, the Power ON again.
On the 4S reset networking settings.  You will have to re-enter your network's password, but it should be able to connect.

Similar Messages

  • How do I add a desktop link to gmail?  I have one email account as my safari home page because it has trouble with apple mail, but I want a one-click link to two other email accounts.

    How do I add a desktop link to additional email accounts?  I have one email account as my safari home page because it has trouble with apple mail, but I want a one-click link on my desktop that takes me to two other email accounts.

    Can you set up a rule in your old account to forward mail to your new account and then delete it from the old account?
    (1012)

  • Only had my iPhone 5 a week and already I'm having trouble with the home button? Any soloutions

    Only had my iPhone 5 a week and already I'm having trouble with the home button? Any soloutions

    Sure. Take it back. If you got it from new it has a warranty.
    Or describe the problem fully in case we can help.  "Having trouble with the Home button" doesn't give much of a clue....

  • I have an IPAD 2 that I use to view an IP camera over a Wifi network.  The Ipad is in a vehicle that leaves the Wifi range and then returns to the range.  Upon returning to the range, the Ipad has trouble connecting to the network. (30 seconds)

    I have an Ipad 2 that I use to view an IP camera over a Wifi network.  The Ipad is in a vehicle that leaves the Wifi range and then returns to the range.  Upon returning to the range, the Ipad has trouble connecting to the network. (30 seconds)  The Ipad will eventually connect to the network, but by this time the driver is frustrated.  I have moved the antenna to within 20' of where the vehicle comes to a stop.  My Iphone does not have a problem connecting or reconnecting when used side by side with the Ipad.  Both the Ipad and Iphone have Otter box covers.  Has anyone run into this problem or have any suggestions?

    30 seconds to reconnect to a WiFi network is not unusual, especially in an environment where other radio signals on similar frequencies are present.  Sorry about that.
    You might get better times by letting the WiFi base station pick another channel.  But you might not.

  • Having trouble with the home button

    I'm having trouble with my home button. It works when it wants to. Has anyone else had this trouble?

    Try these three very basic troubleshooting steps and see if any of them help.
    Restart the iPad by holding down on the sleep button until the red slider appears and then slide to shut off. To power up hold the sleep button until the Apple logo appears and let go of the button.
    This involves using fhe home button but try it anyway .....
    Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.
    Quit all apps and restart. If you have multitouch gestures turned on, you can swipe up from the bottom of the screen to get to the task bar.
    Go to the home screen first by tapping the home button. Double tap the home button and the task bar will appear with all of your recent/open apps displayed at the bottom. Tap and hold down on any app icon until it begins to wiggle. Tap the minus sign in the upper left corner of the app that you want to close. Tap above the task bar. Restart the iPad.
    Restart the iPad by holding down on the sleep button until the red slider appears and then slide to shut off. To power up hold the sleep button until the Apple logo appears and let go of the button.

  • Having trouble with Yahoo home page sign in. Some time it brings up my wife's Yahoo log in instead of my log in how can I fix this?

    When I open Firefox it is suppose to take me to my Yahoo home page. But it opens up showing my wifes Yahoo sigh in page in stead of mine. Having trouble with Yahoo home page sign in. Some time it brings up my wife's Yahoo log in instead of my log in how can I fix this?

    Did your wife tick the box on the Yahoo sign in page to remember her for two weeks?
    It would be best two have two separate Firefox profile folders, one for each of you to prevent such problems.<br />
    Then you also do not have problems with deleting or changing bookmarks.
    * http://kb.mozillazine.org/Creating_a_new_Firefox_profile_on_Windows
    * http://kb.mozillazine.org/Shortcut_to_a_specific_profile
    * http://kb.mozillazine.org/Using_multiple_profiles_-_Firefox

  • Im having trouble with my home page alignment.

    Im having trouble with my home page alignment. If you look at all the other pages within my site you will see how the alignment should be... trunderground.com.  I have tried chaning master pages for my home page, and still nothing.... Please someone help.

    Ask in whatever forum of whatever web design app you use.
    Mylenium

  • Mountin Lion has trouble with external monitors

    Not so much a question as a shout-out. Since going to Mountain Lion, my pretty new (February this year) MacBook has been having no end of trouble with external monitors. I use it a lot with the clamshell closed with two different external monitors of two different sizes, one at home, one at work. It sometimes thinks the one is the other, or if I unplug the monitor in sleep, when I later open the clamshell, the screen stays black and I have to force a reboot with the power button. Never had these problems with exactly the same set-up in Lion. Sometimes it also refuses to find a connected monitor or projector, I have to pull the dangle and put it in again.

    If memory serves, one of the 'flaws' with BM's hardware is that it will not convert on-the-fly.  So if your sequence doesn't match what the TV is accepting, you get black.
    For example, my TV will not accept 1080p, only 1080i, so working in a 1080p sequence would produce no image for me as the BM will only output exactly what's in the sequence, it can't convert my 1080p/24 sequence into 1080i/30 for output.
    Now I'd expect your TV would have no trouble accepting a 720p signal but, maybe the above data will lead you down a path of investigation.

  • My iphone 4S is not able to connect to my home wifi network although it easily connects to others. Infact, i have tried connecting another iphone with my home network without any difficulty. So its just my new iphone 4S that is not connecting.

    My iphone 4S is not able to connect to my home wifi network (BSNL). It does detect it and even tries to connect to it but in vain. However, it connects to all other available networks easily. Another interesting thing is that all other devices including an iphone 4 easily connects to this home network. So what is the problem with iphone 4S???

    There are two ends to a wireless network. Try rebooting your router. Just pull the power for a few seconds and replug. No settings are lost.
    (The fact that all your other devices connect to the internet is irrelevant)

  • I am finding FCPX has trouble with mixed audio sample rates

    I am just putting this thread out there to ask if anyone has experienced issues with mixed sample rates in the timeline?  Specifically I have noticed that a timelilne with an audio rate of 48KHz with have troubles with a song at 44.1KHz - this is irrespective of what sort of video codec I am using. It happens to me a lot lot with stills actually.
    If I preconvert to 48KHz, I do not have the same issue. Just asking if this has been discussed or mentioned elsewhere so I can figure out if it is just me.
    Thanks

    You might want to duplicate the capture preset for DV/NTSC 48k and change the audio to 32k.
    Then try that.
    But I'd also change the JVC's audio settings to record in 48 while you're waiting. Should be able to do it... cheap or not.
    CaptM

  • Assistance with Wireless Home Networking

    Hello-
    I am struggling to get my house set-up properly for a strong wireless signal strength. I could use some advice.
    My current set-up includes:
    1) A 2Wire gateway broadcasting wirelessly at 2.4GHz (b/g)
    2) A Time Capsule connected to the gateway via Ethernet and broadcasting wirelessly at 5GHz (n).
    My signal strength is very poor in some portions of the house. Most noticeably where I need it the most... My media room (which has the Apple TV, PS3, etc.). Oddly, my Time Capsule has 30% less strength than the 2Wire.
    From reading posts here, it appears I have the following options:
    a) Get an airport express and use it as a range extender.
    b) Get a power line home networking device and hook-up my devices via Ethernet.
    I would appreciate any suggestions on the proper way to go, and, if there are any other things I should try besides what I listed above.
    To help, I have linked to 2 images: The first is the layout of my house and the second is my signal strength:
    http://www.malphurs.com/shared/LayOut.jpg
    http://www.malphurs.com/shared/Strength.jpg
    Thanks again!

    Sorry to be vague... The Time Capsule is only for the back-up of my laptop.
    What I am attempting to do is expand my wireless network through out my house. It has not been doing so up to this point. I have a newborn on the way quite soon and had to turn my home office into a nursery. In doing so, I lost my second TV that I had my Apple TV, Playstation 3, and X-Box connected to.
    When I moved all these devices to the media room, the wireless was not strong enough for them to function. So, what I have done is:
    1) kept my 2Wire gateway broadcasting wirelessly as before
    2) set the Time Capsule up to "join a network" as opposed to "create a new network" and connected it to the gateway via ethernet
    3) connected a WD LiveWire ethernet adaptor directly into the gateway via ethernet
    4) put the second WD adaptor in my media room and connected all my devices to this via ethernet
    All seems fine, but I am not sure this is the "optimum" set-up. I also don't know if I should add an extra router in the media room to broadcast a stronger wireless signal. This router would - of course - be connected to the WD LiveWire via ethernet, as are the rest of my devices in the media room.
    Hopefully that is a tad more clear... Thanks again!

  • A pop-up message on desktop with nonexistent home network address

    A pop-up window appears sometimes on my desktop saying that no network connection to a specific home network address can be established. There is no device in that address. How to remove the pop-up?

    Actually the message is that there is no File Server on this computer associated with netwok address 192.168.1.9. Access the files manually.

  • Macbook no longer connects automatically with my home network

    When i travel and return home, my macbook no longer will automatically join my home network. Is there a way to make the current network your on a 'trusted' network or a default network to join via airport?
    thanks!

    Have you tried adding your home wireless network as a "Preferred Network" in your MacBook's AirPort settings?
    o System Preferences > Network > Show > AirPort

  • Is anyone having trouble with the "home" button not responding after upgrading to 5.1.1 OS?

    Is anyone having problems with the "home" button not responding after upgrading to 5.1.1?

    You will not belive how I accidently solved this - !!!
    Yes I had the problem immediately after the 5.1.1 'cloud' upgrade, the problems started (on my iphone 4) ... I followed the 'get power down button, then hold HOME for 30 secs' solution, but no result, nothing seemed to work and I was starting to get a bit agressive with the keep it pushed, multiple double click frustrations, icopybot multigesture solutions etc. and paid money ... but this comedy solution now works ...
    I discovered it because I ordered a waterproof case for my iphone for my motorcycle ... I've just fitted it to my iphone and all the problems have gone ??? what! ... so wondering why I looked at what the home button on the casing was doing - it was pressing ACROSS the home button i.e. it converted my finger point into a wider 'PRESS
    so taking the new case off, instead of using the point of my thumb to press HOME, I used the flat of my thumb to emulate it ....and initially nothing, so I wondered if it wa making better 'cross button' contacts, so I licked my thumb, wiped it and then tried again! - it worked!
    I can't explain it but it seems to work - try it! if the double click on HOME doesn't work lick your thumb dry it and try again! I've just done it again
    what a mad techno world we live in! :-)
    Dave

  • Having troubles setting up home networking and cant locate comcast isp # and other related info neccessary to do so

    please forgive my computer illiteracy.. I'm trying to set up home networking to include my laptop, husband's i-pad and our mobile phones if possible. I need my internet options info (isp#, etc) and can't locate them

    Sorry, that topic is beyond the range of Firefox support. Try posting in a "networking" support forum like this: <br />
    http://www.broadbandreports.com/forum/sharing

Maybe you are looking for

  • How do I change my FF4 sign on back to my customized FF4 I change it to new and I need it back the way it was

    <blockquote>Locking duplicate thread.<br> Please continue here: [/questions/826763]</blockquote><br> My god I've lost all my addons and other important info when I signed on this morning it asked me which which user I wanted to use this was the first

  • Mouse cannot scroll [Solved]

    I have a compaq mouse  that is not USB with two scrolling wheel at the top, but they are being useless since I came to arch.  My xorg.conf looks like the following Section "InputDevice" # Identifier and driver     Identifier  "Mouse1"     Driver     

  • Apple tv to i pad

    How do i transfer my film I purchase on to my ipad, I brought it on apple TV, its showing in my purchased list but not on my itunes. Do i have download it again

  • Extract DDL

    how to extract the DDL of a database object in oracle 9201? Thankx in advance for help...

  • Problem developing the HelloWorld Project for Motorola IDEN Emulator

    Hi all, I have tried to create the HelloWoirld application per the Emulator help. When I try to run the application in the emulator I get the following messages: start building... compile C:\myprj\HelloWorld.java... preverifying... packaging... addin