4s phone will not power off

i need help

Your question is a bit vague. If the iPhone is shutting down but then turning right back on. The fix can be to clean the iPhone charging port with a clean dry toothbrush. See if fixed. If still problem, and there is Warranty or AppleCare make Genius reservation and take to Apple for resolution. If no coverage, then clean the iPhone charging port again with the toothbrush and small amount of Isopropyll Alcohol. If still problem, some users have been able to turn it OFF, by connecting just the USB cable and then turning it OFF.

Similar Messages

  • HT1349 Phone will not power off or take picture

    My iPhone will not power off.

    Try to reset it: hold the on/off and home buttons until you see the Apple logo (ignoring the off slider that appears first), then release.  If it won't reset just let the battery run down until it turns off, then recharge it.

  • Phone will not power off

    Phone does not power off. It only does in safe mode. Once in safe mode still can not normally power off but only on safe mode.
    Any advise?
    Thanks
    T

    And ticked the enable quick boot mode. Deactivated and now is fine.
    Sorry and thansk

  • IPhone Will Not Power Off or Go Into Silent Mode

    Yesterday I discovered that I had my phone switch flipped to Silent Mode, and my phone was still making the General Sounds and Still Ringing. No matter what I do I can't get it to Vibrate instead of ring.
    Also it will not power off, no matter how long I hold the button nothing happens, it wont even lock. I tried performing a hard rest by holding the Home Key & Power Button, but instead of reseting the Voice Control pops up and my iPod starts playing.
    Any Help Is Greatly Appreciated ♥

    - Try another cable.
    - Try on another computer
    - Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
    - Make an appointment at the Genius Bar of an Apple store.
      Apple Retail Store - Genius Bar

  • My iPhone will not power off. It automatically turns back on after trying to shut it off. Any Ideas?

    My iPhone 5 will not power off. I hold the power button down and it lets me turn it off but then it automatically turns back on. It is as if I am just restarting it. Any ideas on how to fix it? I already had it exchanged and the replacement is now doing it.

    I had this same problem about a year ago. It is most likely because debris has been caught in the cable connector. Get a cotton bud or something soft so that you don't cause any damage, and gently clean the inside of the dock connector of your phone. Do not use any liquids. Hope this helps.

  • Phone will not power down?

    Phone will not power down?

    I lost my slide to power down after updating. Now I got to hold the buttons longer than normal and it just shuts off.. Not to mention lost my iMessage & FT(activation pending) problems. Hope theres some fixes soon

  • HT201401 4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out l

    4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out loud.

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
    Be sure to make an appointment first...

  • Updated to 4.5, Phone will not power on

    I just upgraded to 4.5 software for my blackberry 8110 (AT&T), and my phone will not power on... Nor will it connect to Desktop manager.... nor will it do anything.
    I've done a battery pull, I've attempted re-installing 4.5, I've attempted restoring to previous status using my recent backup file, and nothing works. Any advice...?

    You've tried every possible alternatives. Nothing to suggest!!!
    If you can  warranty then take to your operator and ask for replacement/repaid otherwise...
    tanzim                                                                                  
    If your query is resolved then please click on “Accept as Solution”
    Click on the LIKE on the bottom right if the post deserves credit

  • HT201401 My home button does not respond and the phone will not shut off

    Has anyone had a similar problem where the phone will not shut off and the home button does not respond

    You should try taking it to the Apple Store and asking for a replacement.
    Or you could enable Assistive Touch from Settings>General>Accessibility.

  • HT6147 i need help, i did the update on my iphone 5s and now the phone will not power on?

    hey, i need some help with my iphone 5s, i did the update ios 7.0.6 and now my phone will not power on?? can someone please help me!

    Hello ABrosz
    If you are not able to get your iPhone to power on, try to reset it by holding the Sleep/wake button and Home button at the same time for about 10 seconds and see if it turns on. Check out the articles below to troubleshoot your iPhone further.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/ts3281
    If you can't update or restore your iOS device
    http://support.apple.com/kb/HT1808
    Regards,
    -Norm G.

  • My iphone will not power off

    My Iphone 4s will not power off and the battery is draining with a couple of hours ? Help please

    Try an iPhone reset first which is done by pressing and holding the home button and the sleep/wake or on/off button simultaneously until you see the Apple logo and then release. This is similar to a computer restart.
    Try powering the iPhone off again after doing so.

  • IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software is up to date with 6.1.6.  PLEASE  HELP!

    version 6.1.6(10B500); model#MC547LL/A; 60GB (40 used/20 avail)
    IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software states up to date with iOS 6.1.6.  PLEASE  HELP!

    Try:
    - Reset the iOS device. Nothing will be lost      
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes      
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar

  • My iPad will not power off

    I have a 32GB iPad 1st Gen. It sits with a pinwheel rotating, but will not power off. When I tried connecting it to iTunes, it says there is an unknown problem connecting this iPad. What Can I do?

    I'm sure you've tried the hard reset using the home and power button?  If that won't work, next check your cables.  If you own a iPod, or iPhone and have mixed up the sync cables, that can sometimes cause an issue depending on how old they are.  If that doesn't work, I'd try a different computer with iTunes on it, if you have it, or a buddy to see if it recognized then.
    Let us know how it goes.

  • My iPad will not power off. Buttons won't work

    My iPad will not power off. Buttons won't work

    Hi Try a Reboot press & hold power button & menu button hold both down until you see Apple Logo Try this with ipad conected to charger. Cheers Brian

  • HT201412 My ipad mini will not power off. The ICloud Backup  reminder is stuck on the screen and will not clear off.

    My ipad mini will not power off, nor will it respond to any commands.  The ICloud Backup reminder (which I do not use and have not activated)is stuck on the screen and will not clear.

    Hold down the sleep and home keys for about 20 seconds and see if you can get it to reboot.

Maybe you are looking for

  • SharePoint Foundation 2010 Search returns no results

    Hi, SharePoint foundation 2010 Search is not showing any results after configuring the step from the below link. http://wiki.sirkit.ca/2011/04/sharepoint-foundation-2010-search-returns-no-results/ My Server Setup :  SharePoint Foundation 2010 SQL Ser

  • How does the interclass call the outerclass's method?

    Compile the following code, public class q extends JFrame class c2 implements ActionListener{ public void actionPerformed(ActionEvent e7){ System.out.println(q.getTitle()); Get the errors: non-static method getTitle() cannot be referenced from a stat

  • Hoe to save file in oracle dataBase

    hi how can i save and retrive any type of file in the oracle

  • HP Officejet 6500A Printer Assistant

    This may have been asked before and I thought I found the answer, but I can't find it again.  I have an HP Officejet 6500A Plus.  I have a shortcut on my desktop that is called "HP Printer Assistant - Shortcut".  When I click on it, nothing happens a

  • Pass button instance name to a function when button is in ScrollPane?

    I have a ScrollPane component which holds a movieclip from my library. I am trying to set up a funtion to read the movieclip.button instance name when I click a button. On a trace, all I receive is "spContentHolder." How can I capture the button inst