4s screen went black after updating to iOS 8.2

So i updated my iPhone 4s to iOS 8.2 and the screen just went black after that. The phone is on but nothing appears to the screen and booting doesnt help. What should i do?

Try waiting about 30 - 60 minutes to make sure that it isn't just the software being installed. After that, press and hold the Sleep/Wake button and the Home button together for 10 - 20 seconds until the apple logo appears.

Similar Messages

  • I have an ipad mini with ios 7.1.1 it lags a lot and the lower part of the screen is shaky after updating to ios 7.1.1

    i have an ipad mini with ios 7.1.1 it lags a lot and the lower part of the screen is shaky after updating to ios 7.1.1

    Thank you for the advice Randy. Very helpful of you to jump in with a post that adds so much value for the OP.
    A bit of advice for you as a new user. Please refrain from making assumptions and using hyperbole. Both get in the way of providing useful support. Not "everyone" has tried the basics, let alone know what they are. That's why they're here. These first steps in troubleshooting often fix the issue being asked. If this thread doesn't answer your question, move on and find one that does. Feel free to skip the thousands that advise a reset.

  • I lost safari from home screen and settings after updating to iOS 7.0.2 on Iphone 5

    Lost safari from home screen and settings after updating to iOS 7.0.2 on Iphone 5

    Settings > General > Reset > Reset Home Screen Layout
    If no joy, check whether you have Restrictions set.

  • Screen went black after contact with water

    Good evening together, I got my tablet a few days ago and todays it got it's first conact with water. The screen went black instantly and I couldn't turn it on again. I turned it off with the red button at the MicroSD slot. All water caps were closed when it came in contact with water. The strange thing is that I can't register it at Sony Xperia Support because it says the ID 1100-4001-073433-6 is not valid. I already wrote an e-mail at the support but I don't know what will happen now. Did someone else had the same problems?  Thank you for your replys and have a nice day together!

     I'm sorry to hear that, contact your local Xperia care and request a vacuum test http://support.sonymobile.com/global-en/contactUs/  

  • Computer screen went black after trying to adjust settings

    Hello, I prior to upgrading to win8, I was using two screens with my b320.  After upgrading I could only use the main screen.  I was trying to adjust the settings to extend the view to the second monitor when...the main monitor b320 went black.  I know it is on in the background.  When I restart the screen flashed Lenovo...the window 8 emblem appears...then nothing, but the sound at startup.  I don't know what to do, since I can't SEE anything..can't adjust anything etc...any advise?

    hi Sassygurl,
    Welcome to the Lenovo Forums.
    Your display might be switched to the Second Screen (external monitor).
    Can you try to:
    1. Press the Windows Key+P and press the Up Arrow 3 times then press Enter (check this thread)
    2. Unplug the external monitor and change the screen source.to PC Screen
    Link to picture
    3. If same problem, try to boot into safe mode by prssing Shift+F8 (might require a few attempts as dicussed here)
    Let me know your findings.
    Cheers
    Moderator note; pictureconverted to link
    Did someone help you today? Press the star on the left to thank them with a Kudo!
    If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
    Follow @LenovoForums on Twitter!

  • My iphone 4 works but the screen went black after it got shot with a paintball. What is wrong with it?

    I went paintballing and i forgot i had my iphone in my pocket. I realized I was getting a call and my phone screen didnt work. It didnt crack it just went black. Everythin else works just not that. What is wrong with it?

    try holding and pressing the sleep button and home button together for a few seconds and see if there will be any change in the screen and apple logo should appear after 10 seconds or so if not i guess its a problem with the screen itself maybe darkened pixels or maybe a wire is cut off

  • HT1349 My camera screen went black after I took a picture

    I just took a picture and my camera screen  went black

    Try a Reset...
    Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
    http://support.apple.com/kb/ht1430
    iPhone User Guide

  • IPod screen went away after updating to 1.3

    wishing everyone a very happy, healthy and prosperous new year of 2009!
    i have an ipod 5th gen 30gb (model number a1136), which i use very sparingly. i have had it since 2005. today i connected it to my computer which has itunes 8. itunes asked me to update the software on the ipod to version 1.3. i do not remember very well, i just have a hunch that my ipod originally had 1.2.1 version.
    as soon as the update was done, itunes gave me a message that the ipod will restart. after that, my ipod went for a toss. i see some coloured stripes, mostly white screen. itunes recognises the ipod, and i can even hear the clicking when i use the click wheel. the screen brightness goes high and low as it would when it used to work.
    please help me fix this issue. thanking in anticipation...
    regards.

    chris,
    restore did not work. i followed the 5 R's. the display remained white, with vertical coloured lines.
    regards.

  • Blank screen in iTunes after updating to iOS 6 on new iPad

    I installed iOS 6 on my new iPad yesterday. When I open iTunes, it opens as blank white with black bar at top and rest white blank. My WiFi and everything else is working perfectly including Siri. I have tried rebooting the iPad (using both the normal shutdown and re-start method as well as pressing Home and Sleep buttons together for 10 seconds till Apple logo appears and then it shuts down). I am able to use App Store perfectly fine and have also been able to download apps and them successfully. I have tried re-setting the router and switched off and on the WiFi. The problem still persists. I have also searched the web for a way to re-install iTunes, but haven't found anything. Does anyone know of a solution? Please help as I would like to use iTunes on iOS 6. I do not want to be stuck with a non-functional iTunes till the new version, ie iTunes 11 arrives in late October.

    Hi all...I just got a solution to the problem. It's foolproof. Connect your iPad to your PC and re-install iOS 6. In case you would like to know how - Click on iPad in iTunes and then click on restore button. Then just follow the steps from there on. It worked for me. I know this is a "not-the-desired" solution, but it will fix your problem. For me it solved another problem - I had noticed a deterioration in speed when I had originally upgraded from 5 to 6. After doing this re-install, I can confirm, there is a noticeable difference in speed...across the board, including Siri responses. Thanks and best of luck.

  • Iphone 4 information went missing after updating to iOS 7!

    Please help I just updated my iphone 4 to ios 7 and i chose to to backup my information, but once it had finished downloading all my old information had been gone! Is tree a way i can restore it back? I checked my iCloud and tunes but it isn't there! I have very important contacts tere that are all gone now!

    Welcome to the Apple Community KawaiiHelper.
    it's not really clear what you are trying to say. Are you restoring from an earlier back up.

  • I updated my ipad today to 5.1.1 right after it updated, the screen went black and i have not been able to turn on my ipad at all. I have tried everythig I know to do. What next?

    I updated my ipad today. right after it updated, the screen went black. Since then I have not been able to turn on my ipad. I am recharging it. It has been recharging for 55 minutes. I have tried to reboot, nothing. I have tried everything i know to do. Nothing What else can I do?

    You may need to try recovery mode now. Read this.
    iOS: Unable to Update or Restore

  • HT4061 had new ipad air 5 hours, got message to update ios, started, screen went black with apple logo, over two hours, cannot shutoff device. seems locked, no response.

    new ipad air 5 hours ago. got message ios update available. i started install, screen went black with apple logo, has been "frozen" over two hours with no apparent activity. cannot use Home button or Sleep wake button. how do i restore original ipad start? what is ctl alt delete equivalent?

    Thank u, this reply helped.
    SergZak
    Currently Being Moderated  Re: black screen wont turn on
    Oct 10, 2013 3:44 AM (in response to Apfelwurm)
    The following is how to do a proper reset of an iDevice:
    Device Reset (won't affect settings/data/music/apps/etc)
    1. Press and hold (& continue to hold) BOTH the Sleep/Wake button & the Home button.
    2. Continue to hold BOTH (ignoring any other messages that may show) until you see the Apple logo on the screen.
    3. Release BOTH buttons when you see the Apple logo and allow the device to boot normally.

  • HT201210 Attempting to download IOS6 onto iPad2.  2 minutes after download began, the screen went black.  2 Hours later and I still cannot get the iPad to power back on.  Battery was 90% when download started

    Attempting to download IOS6 onto iPad2. Two minutes after download began, the screen went black. Over two Hours since download began and I still cannot get the device to power back on. Battery was 90% when download began. Is there a way to force the power on?

    worked for me, then general software update showed "ios 7.0.4" is up to date. awful long and frightening update but all well that ends well. this Sleep/wake AND Home worked to shut off.
    SergZak
    Currently Being Moderated  Re: black screen wont turn on
    Oct 10, 2013 3:44 AM (in response to Apfelwurm)
    The following is how to do a proper reset of an iDevice:
    Device Reset (won't affect settings/data/music/apps/etc)
    1. Press and hold (& continue to hold) BOTH the Sleep/Wake button & the Home button.
    2. Continue to hold BOTH (ignoring any other messages that may show) until you see the Apple logo on the screen.
    3. Release BOTH buttons when you see the Apple logo and allow the device to boot normally.

  • Am facing issue on my iphone 5s after updating to ios 7.1.1, every while the phone hang after lock it and cannot unlock and even cannot turn on the screen this is so annoying, kindly advice if i have to go back to the store as device still under warranty

    Am facing issue on my iphone 5s after updating to ios 7.1.1, every while the phone hang after lock it and cannot unlock and even cannot turn on the screen this is so annoying, kindly advice if i have to go back to the store as device still under warranty, and if its a hardware issue or software ??

    Hello HaithamOkeely,
    We've an article that provides the following troubleshooting steps that may help stabilize your iPhone.
    If the device is unresponsive or if certain controls aren't working as expected, restart your device.
    If the device remains unresponsive or does not turn on (or power on), reset your device.
    If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
    If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
    Let it charge for at least twenty minutes, then see if it starts normally.
    If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
    If the screen displays a red battery icon, continue charging the device until the battery is fully charged. Learn more about charging iPhone and iPod touch, or iPad.
    If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
    Connect the device to your computer and open iTunes.
    If the device appears in iTunes, select and click Restore on the Summary pane. Learn more aboutrestoring iOS software.
    If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
    If the above steps do not resolve the issue, contact Apple.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    Cheers,
    Allen

  • IdeaPad S500 Touch - Screen goes black after driver update

    I have a Lenovo IdeaPad S500 Touch. It is running the most recent update of Windows 8.1. It suggested an update to the Lenovo Video Driver. After downloading and installing the update, the screen went black. When rebooting, the Lenovo logo appears on the screen, and it goes black again. No matter what I try, that's it.
    Anyone have a suggestion?
    Thanks,
    James
    Solved!
    Go to Solution.

    hi Scoutmaster316,
    Welcome to Lenovo Community Forums!
    You will need to boot the system into safe mode.
       the only option to boot there based on your situation is to crash boot the system
    When you turn on the system, Lenovo Logo Appears then Black screen wait maybe a minute the hold the power button down to crash it you may need to reapeat this 4 to 5 times until it boots to a page like this
    Once you got that proceed with these selection
    Troubleshoot / Advanced Option / Startup Settings
    Then you should rerach options with Safemode Select that.
    If the driver is the problem you should be able to boot here,
    Open device Manager and rollback the Video Driver
    Regards
    Solid Cruver
    Did someone help you today? Press the star on the left to thank them with a Kudo!
    If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
    Follow @LenovoForums on Twitter!

Maybe you are looking for