8300 won't turn on after desktop manager problems

I tried to install the Blackberry Desktop manager here and during installation my usb connection became undone between the computer and the phone. I was able to make it halfway through setup to where I have an IPD file of my backup information. I just need to get pointed in the right direction to get this resolved so I can start up the phone and get the backup information restored.
Thanks for any and all help

Hi and welcome to the forums!
If you were installing the desktop software and the phone was connected to the USB:
Pull the battery wait a minute and replace the battery, see if it reboots.
If you were installing DEVICE OS software and the phone died you will have to reload the OS.
Let us know exactly what you were installing, OK?
Thanks
Click Accept as Solution for posts that have solved your issue(s)!
Be sure to click Like! for those who have helped you.
Install BlackBerry Protect it's a free application designed to help find your lost BlackBerry smartphone, and keep the information on it secure.

Similar Messages

BLACKBERRY TORCH - won't turn on and desktop manager won't recognise it - I can't get my contacts

Hi all,
I'm new to this so please bare with me.
I'll try and be as brief as possible. Up until last week I had the Blackberry Torch 9800. I was due an upgrade and about two days before I went to contact my network provider my Torch battery died (it wasn't broken at this point, it just was drained and needed charged) so I went to charge it and it did that thing where the battery was so dead it wouldn't even switch on whilst charging.
I plugged it in and rather than charge like normal it was completely dead and the only activity it offered me was two red flashing lights as it 'charged'. From that moment on it has not turned on. Dead as can be. If I plug to charge (wall charger OR USB port) I get the two bright red flashing notification lights but it will not go on.
Anyway rather than send it to be repaired I opted for a new phone as I was due an upgrade anyway and intended on doing so whether the Torch was alive and kicking at this point or not. Cut a long story short I got my new blackberry (9360 curve) it is all set up with my e-mail etc, media card and same sim card swapped over but as Blackberry insist on your contact numbers being saved to the handset and not the sim my contacts are stuck in my Torch 9800.
When I go to plug the Torch in to Desktop manager to get the contacts saved to there and then sync over to my new handset the Torch is so dead that DManager won't even read/recognise it. My network say since this is not an issue with network etc they can't really help and gave me a number for Blackberry services in England somewhere (they are office hrs so can't phone until Monday morning).
Please can someone help? I have my new 9360 all up and running but my contacts are stuck in my Torch and that is the only place they are? DManager won't recognise the Torch because it is dead - except the two flashing lights - and therefore won't let me at the contacts that way.
ANY help would be appreciated - please not too techinal as not great with all of that side of things!
Sorry for the long post.
Sco123.

Sco123 wrote:
Sorry for the long post.
Sco123.
Then let me counter with a short reply:
www.blackberry.com/btsc/KB10144 .
Cheers.
- If my response has helped you, please click "Options" beside my post and mark it as solved. Clicking the "thumbs up" icon near the bottom of my response would also be appreciated.

Hello... can anyone help, my late 2010 MBA's - OS X Lion 10.7.5 wifi won't turn on after a deep sleep

can anyone help, my late 2010 MBA's - OS X Lion 10.7.5 wifi won't turn on after a deep sleep.. thanks..!

Hi John,
Thanks for the additional information. What I would try next is resetting System Management Controller:
Shut down the computer.
Plug in the MagSafe power adapter to a power source, connecting it to the Mac if its not already connected.
On the built-in keyboard, press the (left side) Shift-Control-Option keys and the power button at the same time.
Release all the keys and the power button at the same time.
Press the power button to turn on the computer.
Note: The LED on the MagSafe power adapter may change states or temporarily turn off when you reset the SMC.
You can find the full article here:
Intel-based Macs: Resetting the System Management Controller (SMC)
http://support.apple.com/kb/ht3964
If this still doesn't help, it would be time to take it in to be looked at. You can setup an appointment at a Genius Bar by clicking on the following link:
http://www.apple.com/retail/geniusbar/
Best,
Sheila M.

Turn on! My mac won't turn on after sleeping!

Ever had a problem where your computer won't turn on after sleeping for a few minutes? (I've discovered that too many downloads cause this) Anyway... have you ever tried pushing the power button for one second? Try it! It's been working for me! Hope this helped!
(If it still won't turn on, try typing in letters randomly for one minute. Just type anything like: asdjhas)

Try resetting the SMC and PRAM
Intel-based Macs: Resetting the System Management Controller (SMC)
About NVRAM and PRAM

What to do now when my iPad won't turn on after I turn it off. It shows only the apple logo. I am sure it has above 70% charge as when I sync my iPad it shows necessary detail in iTunes. I have tried, HOME & POWER button, but did not work.

What to do now when my iPad won't turn on after I turn it off. It shows only the apple logo. I am sure it has above 70% charge as when I sync my iPad it shows necessary detail in iTunes. I have tried, HOME & POWER button, but did not work.

First try a Reset ( No Data will be Lost )
Press and hold the Sleep/Wake button and the Home button at the same time for at least Ten seconds... (But can take Longer)... until the Apple logo appears. Release the Buttons
If no joy... Try a Restore...
1: Connect the device to Your computer and open iTunes.
2: If the device appears in iTunes, select and click Restore on the Summary pane.
Restoring > http://support.apple.com/kb/HT1414
Make sure you have the Current Version of iTunes Installed on your computer
iTunes free download from www.itunes.com/download
3: If Unable to Restore, try using the Steps in this article to force the device into Recovery Mode.
Note on Recovery Mode.
You may need to try this More than Once... Be sure to Follow ALL the Steps...
After you have Recovered your Device...
Re-Sync your Content or Restore from the most Recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766

MacBook Pro 15" won't turn on after a shut down.

My MacBook Pro 15" late 2008 mavericks won't turn on after a shut down. Tried SMC reset, plugged and unplugged charger multiple times as well as installing the battery. It has started that after a while I have replaced my old battery with a new one,upgraded to Mavericks and increased my memory to 4GB. In the beginning after I would install every time the battery ,it' would turn on after 8-10 tries. Today it's completely unresponsive . Tested different outlets, with and without battery,nothing worked. I also heard that some other people have this issue once they have updated their operating system from 10.5.8 to Mavericks. Is that the problem.? Has anyone found a solution to this?

Hi there Olgabinou,
You may find the troubleshooting steps in the article below helpful.
Troubleshooting: My computer won't turn on
http://support.apple.com/kb/ts1367
-Griff W.

My N73 ME won't turn ON after I install PC Suite.

My Nokia N73 Music Edition won't turn ON after I update the version of my PC Suite from V 3.0638.0.0.30 to V 4.0727.2.2.1
can somebody help me with this I can no longer use my N73 ME now
and I don't what to do to resolve this problem and I need your help.
Personal Information RemovedMessage Edited by adisaily on 10-Sep-2007 06:30 AM

Hey! Don't mind.
First Off, you upgraded your phone, not PC Suit.
You most probably did it by using PC Suit (PC suit uses Nokia Software Updater) to upgrade it.
I suspect there was some fall out while downloadin or installin the updates.
Earlier I would advise people to go to nearest Nokia Care centre.
Now, the 3 fingers action might cure it well,though I'm not sure.
The method:
--The number 3---the * star----The green call key--- .
If the phone still cant turn on.
Then, if you have any warrenty and have a nokia care centre near you, make a trip to there.
They will cure it.

3G still won't turn off after hitting home and sleep button at same time. Any other ways to try?

3G still won't turn off after hitting home and sleep button at same time. Any other ways to try it?

And when you held them neither the red Off slider nor the Apple logo appeared?
If not then your sleep button is broken, you will need to get it serviced.

Mac 10.6 won't turn off after update

Macbook air a1304 won't turn off after updating unless you push on/off button.

Phone your nearest HP Support to request warranty service. Worldwide contact info can be accessed here>Contact HP
******Clicking the Thumbs-Up button is a way to say -Thanks!.******
**Click Accept as Solution on a Reply that solves your issue to help others**

IPhone won't turn on after brief blue screen.

My iPhone is currently broken, won't turn on after a blue screen appeared briefly. Won't even connect to my PC or iTunes. Won't even charge with my charger or using a new charger from a family member. Won't hard reboot by holding home top button. Anyone know what my situation is? Checked over the internet and couldn't find any similiar situations. Also this occured after i was browsing Reddit so nothing intense was occuring on my phone at the time.

I'm afraid you'll have to get it looked at by visiting an Apple Store or Authorized Service Provider next to your place or by contacting Apple:
Apple - Support - Service Answer Center

My Ipad air won't turn on after the new IOS7 update

my Ipad Air won't turn on after updating to the new IOS 7.1.1. It ask me for my password I put it in, the apple logo appear and then it want off now it won't come back on. need help please

Did you try this?
Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

IPad Air won't turn on after opening the smart case

iPad Air won't turn on after opening the smart case cover, it does not do it all the time but enough to concern me

Take both the iPad and the Smart Cover back to where you bought them for an evaluation. Make an appointment at an Apple Store to have your device examined by a technician. Or contact Apple Support.

7th gen iPod nano won't turn on after disconnect.

7th gen iPod nano won't turn on after disconnect. I loaded some new music, synced and ejected correctly. screen went black on unplug. Waited, did the button trick, didn't work. plugged it back in & it is recognized immediately. restored, resynced & ejected again. same thing-black screen w/ no response. Charged it overnight. ejected, screen then went to language setting. OK for English, eject & back to black on unplug. Switched ports for cable, tried eject thru PC...all resulting in dead nano after unplug. I really don't want to charge into the store & take it out on the poor kid who will catch the brunt of my frustration. anyone have a suggestion?

Hello Marie,
I would be concerned too if my iPod nano was not powering on. I found an article for the 6th generation iPod nano that has steps you can take for an issue like this (the only difference for the 7th generation iPod nano is the steps you will take for the reset. I included the steps to reset a 7th generation iPod nano below):
Will not turn on or screen remains dark
Connect iPod to power for at least ten minutes to ensure that the battery has enough charge to allow iPod to turn on.
If iPod does not turn on after ten minutes, try resetting the device while it is still connected to power. Reset the iPod by holding down the Sleep/Wake button and the Volume Down button for at least eight seconds or until you see the Apple logo appear.
If the Apple logo appears on the display, connect iPod to a computer and verify that it appears in iTunes and can play music. If iPod appears in iTunes and can play music, no further troubleshooting is needed.
If the screen remains dark and will not turn on, then your iPod may need service.
You can find the full article here:
iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/ts3474
All the steps apply to the 7th generation except the steps for the reset. To reset a 7th generation iPod nano, use these steps:
Press and hold the Sleep/Wake button and the Home button for six seconds, or until the screen goes dark. The Apple logo appears after a few seconds, and then the Home screen. You may need to repeat this step.
I got these steps from this tutorial, which may also help with your iPod not appearing in iTunes:
iPod nano not appearing in iTunes
http://www.apple.com/support/ipodnano/assistant/itunes/
Thank you for using Apple Support Communities.
Best,
Sheila M.

Iphone 5 won't turn on after a download

iphone 5 won't turn on after a download

Hello amonar,
Thank you for using Apple Support Communities.
For more information, take a look at:
iOS: Not responding or does not turn on
http://support.apple.com/kb/ts3281
If the device remains unresponsive or does not turn on (or power on), reset your device.
If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
Let it charge for at least twenty minutes, then see if it starts normally.
If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
If the screen displays a red battery icon, continue charging the device until the battery is fully charged. Learn more about charging iPhone and iPod touch, or iPad.
If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
Connect the device to your computer and open iTunes.
If the device appears in iTunes, select and click Restore on the Summary pane. Learn more aboutrestoring iOS software.
If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
Have a nice day,
Mario

HT1222 iPhone 5s won't turn on after this update. Battery was at 98%, tried holding sleep & home button while plugged in, no good. Any ideas?

iPhone 5s won't turn on after this update. Battery was at 98%, tried holding sleep & home button while plugged in, no good. Any ideas?

P.S. I just noticed; when I hold the power and home button at the same time while it's plugged in as if I was going to restart it, my computer acts as if I'd plugged it in again (it makes the USB notification sound, itunes opens up again, I get the same "your iphone is in recovery mode" message, etc.), but that's the only response I've been able to get from pressing anything on the iphone. thanks again.

8300 won't turn on after desktop manager problems

Similar Messages

Maybe you are looking for