Accept tab not activated for characteristics in result recording screen

Question

Hi,
'Accept and Reject tab' is active only for few characteristics in result recording screen.After entering all the inspection data's system is manually valuating each MIC.
Pls. help me on how to activate the 'Accept and Reject tab'  in results recording.
Regards,
Shrini

Answer 1

Dear Gajesh,
Thanks for your prompt reply.
I have created a SAMPLING PROCEDURE --> QUAL-DMS.
IN ASSIGNMENTS,
Sampling type  --> 300 -- USE SAMPLING SCHEME
Valuation mode  --> 1000 - ATTRIBUTIVE INSPECTION NON CONFIRMING UNITS
(I have selected the system defined Sampling Scheme-> 252 ISO 2859-1 / Level II / multiple)
Sampling scheme   -->      252       ISO 2859-1 / Level II / multiple( SYSTEM DEFINED)
Determination rule    30        Use sampling scheme
Sampling scheme       252  ISO 2859-1 / Level II / multiple
Inspection severity -->  4   -  Normal inspection
   AQL value      -->      15.000
THIS TABLE CONTAINS C1,D1;C2,D2;etc  --> System Defined.
AS I have selected 252 - ISO 2859 -1/ Level II / multiple,
all values of the above sampling scheme must be copied.
It has calculated the sample size 40 for the sample lot 280 correctly
--> sample size is 8
5 samples are to be considered
5 x 8 = 40 samples --> System calculated the 40 samples correctly
SAMPLE LOT --> 280
SAMPLE SIZE --> 8
FIRST SAMPLE C1 --> 0 AND D1 --> 5;
SECOND SAMPLE C2 --> 3 AND D2 --> 8
THIRD SAMPLE C3--> 6 AND D3 --> 10
FOURTH SAMPLE  C4 --> 9 AND D4 --> 12
FIFTH SAMPLE --> C5 12 AND D4 --> 13
I have not defined. I have selected the --> SAMPLING SCHEME 252,
I feel that all its value have to be copied.
Am I correct?
Please advice.
With Best Regards,
Raghu Sharma