ACE - show ft track detail - don't show 'hsrp' info

Question

Hi,
I tried configure FT tracking by HSRP group configured on MSFC:
ft track hsrp HSRP-01
track-hsrp hsrp-Vl26-0
priority 100
peer priority 150
and verify it:
ace-lab/Admin# sh ft track ?
<1-255> Please enter FT Group ID
detail Display FT Track detail
status Display FT Track status
summary Display FT Track summary
ace-lab/Admin# sh ft track detail
FT Group : 1
Status : in-service
Maintenance mode : MAINT_MODE_OFF
My State : FSM_FT_STATE_ACTIVE
My Config Priority : 100
My Net Priority : 100
My Preempt : Enabled
Context Name : FE
Context Id : 5
...but I didn't get no information about 'hsrp'. by cisco documentation I'll get something like this:
Track type : TRACK_HSRP
HSRP Group Name : test
State: TRACK_DOWN (HSRP Group is Standby on the Supervisor)
Priority : 20
Transitions : 1
I did something wrong, or it's a bug? (I didn't find any bug with this symptoms)
ACE version: Version 3.0(0)A1(3b)
martin

Answer 1

By the following example I am demonstrating tracking configuration for an HSRP group on the active member of an FT group.
ft track hsrp TRACK_HSRP_GRP1
track-hsrp HSRP_GRP1
priority 50
In the above configuration example, if the HSRP_GRP1 group goes down, the ACE reduces the priority of the FT group on the active member by 50. If at any time the priority of the FT group on the active member falls below the priority of the FT group on the standby member, a switchover occurs.