ACE30 module with 4 devices in HA mode

Question

Hi, 
I have two ace module in ha mode, each ace are inside of a catalyst 6509, the catalyst  are in vss mode.
Iam going to install another vss with two ace module, I would like to know if is possible to configure the four ace module in  ha mode?
Regards
Fidel Gonzalez

Answer 1

Hi Fidel,
You might want to check out this new product called ITD.
Simple and faster solution:
ITD provides :
ASIC based multi-terabit/s L3/L4 load-balancing at line-rate
No service module or external L3/L4 load-balancer needed. Every N7k port can be used as load-balancer.
Redirect line-rate traffic to any devices, for example web cache engines, Web Accelerator Engines (WAE), video-caches, etc.
Capability to create clusters of devices, for example, Firewalls, Intrusion Prevention System (IPS), or Web Application Firewall (WAF), Hadoop cluster
IP-stickiness
Resilient (like resilient ECMP)
VIP based L4 load-balancing
NAT (available for EFT/PoC). Allows non-DSR deployments.
Weighted load-balancing
Load-balances to large number of devices/servers
ACL along with redirection and load balancing simultaneously.
Bi-directional flow-coherency. Traffic from A-->B and B-->A goes to same node.
Order of magnitude OPEX savings : reduction in configuration, and ease of deployment
Order of magnitude CAPEX savings : Wiring, Power, Rackspace and Cost savings
The servers/appliances don’t have to be directly connected to N7k
Monitoring the health of servers/appliances.
N + M redundancy.
Automatic failure handling of servers/appliances.
VRF support, vPC support, VDC support
Supported on both Nexus 7000 and Nexus 7700 series.
Supports both IPv4 and IPv6
N5k / N6k support : coming soon
Blog
At a glance
ITD config guide
Email Query or feedback:[email protected]