After updating my 4s iphone i cannot com on wifi ?
After updating my Iphone 4s i cannot go on wifi and it hold the same ip adres it only works on 3G net.
Best regards
Moesper
Try the suggestions here to see if they resolve your problem:
http://support.apple.com/kb/ts1559
If these don't work you probably have a hardware problem. Visit an Apple store for an evaluation or contact Apple Support. Contact Us
Similar Messages
-
I am using Macbook ver 10.6.8 after update 10.6.8 combo i cannot join open wifi anymore.it shows me no internet connection.in fact before this i can acces any open wifi smoothly.it makes me annoyed and regret my action updating the combo.almost 3weeks i try to find the solution by read any suggestion from community but it makes me frustrated. for sure i refuse to send away my macbook to technician because what i knew they also take solution from here.i state here my macbook details :
Model Name: MacBook
Model Identifier: MacBook3,1
Processor Name: Intel Core 2 Duo
Processor Speed: 2.2 GHz
Number Of Processors: 1
Total Number Of Cores: 2
L2 Cache: 4 MB
Memory: 4 GB
Bus Speed: 800 MHz
Boot ROM Version: MB31.008E.B02
SMC Version (system): 1.24f3
Serial Number (system): W8744400Z63
Hardware UUID: 6172E4C5-C120-5C8A-9B2E-430B3D42C912
Sudden Motion Sensor:
State: Enabled
this the details my current network:
AirPort:
Type: AirPort
Hardware: AirPort
BSD Device Name: en1
IPv4 Addresses: 169.254.70.222
IPv4:
Addresses: 169.254.70.222
Configuration Method: DHCP
Interface Name: en1
Subnet Masks: 255.255.0.0
IPv6:
Configuration Method: Automatic
Ethernet:
MAC Address: 00:1d:4f:fc:c2:34
Media Options:
Media Subtype: Auto Select
Proxies:
Exceptions List: *.local, 169.254/16
FTP Passive Mode: Yes
Service Order: 2
this is the open wifi i always acces smoothly before i update the combo:
Software Versions:
Menu Extra: 6.2.2 (622.2)
configd plug-in: 6.2.5 (625.6)
System Profiler: 6.0.1 (601.1)
Network Preference: 6.2.2 (622.2)
AirPort Utility: 5.6.1 (561.3)
IO80211 Family: 3.2 (320.1)
Interfaces:
en1:
Card Type: AirPort Extreme (0x14E4, 0x88)
Firmware Version: Broadcom BCM43xx 1.0 (5.10.131.42.4)
Locale: APAC
Country Code: MY
Supported PHY Modes: 802.11 a/b/g/n
Supported Channels: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, 161, 165
Wake On Wireless: Supported
Status: Connected
Current Network Information:
TM WiFi:
PHY Mode: 802.11g
BSSID: 0:19:be:80:20:1a
Channel: 1
Country Code: MY
Network Type: Infrastructure
Security: None
Signal / Noise: -77 dBm / -94 dBm
Transmit Rate: 36
Other Local Wireless Networks:
TM WiFi:
PHY Mode: 802.11g
BSSID: 0:19:be:80:21:96
Channel: 6
Network Type: Infrastructure
Security: None
Signal / Noise: -78 dBm / -99 dBm
Location (8/1/12 8:22 AM):<<<<<<<<<-------------------------At this time i can acces this open wifi with auto-login
Active Location: No
Services:
Ethernet:
Type: Ethernet
BSD Device Name: en0
Hardware (MAC) Address: 00:1b:63:a6:2e:44
IPv4:
Configuration Method: DHCP
IPv6:
Configuration Method: Automatic
Proxies:
Exceptions List: *.local, 169.254/16
FTP Passive Mode: Yes
FireWire:
Type: FireWire
BSD Device Name: fw0
Hardware (MAC) Address: 00:1d:4f:ff:fe:72:00:d4
IPv4:
Configuration Method: DHCP
IPv6:
Configuration Method: Automatic
Proxies:
Exceptions List: *.local, 169.254/16
FTP Passive Mode: Yes
AirPort:
Type: IEEE80211
BSD Device Name: en1
Hardware (MAC) Address: 00:1d:4f:fc:c2:34
IPv4:
Configuration Method: DHCP
IPv6:
Configuration Method: Automatic
DNS:
Search Domains: , 94C723E0-B495-45CF-8ACE-279AF0F2D687
Server Addresses:
Proxies:
Exceptions List: *.local, 169.254/16
FTP Passive Mode: Yes
IEEE80211:
Join Mode: Automatic
JoinModeFallback: Prompt
PreferredNetworks:
SecurityType: Open
SSID_STR: TM WiFi
Unique Network ID: 94C723E0-B495-45CF-8ACE-279AF0F2D687
after i update the combo:
and the page which the open wifi load automatically did not appear as before.
if the update affect the wifi,cant i just downgrade and remove the annoyed combo?any expertise r welcome to give great solution..plzz!!!need your help!!!!cant believe it nobody reply.. very dissapointed ..i bring my mac to experrt and he reset my mac to the original version 10.6.8 .. n seriously after it done.. the connection as i mentioned which annoyed me settled and it works like a charm.. when i try to check update my software ...it showned combined software for 10.6.8.. however i still afraid to update it.. i'm still in trauma...
-
MY iphone 4s cannot connect to wifi after updating to ios 8.1.1
after updating to ios 8.1.1, my iphone 4s cannot connect to wifi at all.
at first, connection will show up, but when i tried to connect, i will see the wifi logo but after 15 or 30 seconds, connection will be lost again.
i will try again, but this time, my phone will hang, i need to restart but then, wifi will not work at all.
it will show that its searching for network but its not. then it will hang again,
after this, give up already.
my phone is working perfectly fine until updating my ios to 8.1.1.
the problem is i cannot upgrade again as i cannot connect to wifi.Settings/General/Reset - Reset Network Settings. If you can't turn WiFi on see: http://support.apple.com/kb/TS1559
-
IPhone 3GS after updating Ios 6.1.3 cannot be activated
iPhone 3GS after updating Ios 6.1.3 cannot be activated. When I connected my iPhone to iTunes on PC, iTunes said that there was no SIM card on iPhone. I also took out the SIM Card and took in the SIM Card, but it wasn't working. I activated iPhone through WIFI but it said that the server was temporarily not available. I tried again more and more times but nothing's changed. Please help me.
See here > http://support.apple.com/kb/TS3424
Also see this discussion.
https://discussions.apple.com/message/21189708 -
Dear Community,
Please can someone assist me on what to do on the following;
After update of my iphone 3GS ios. I found out that my iphone has returned back to factory setting and it shows No Service on the top left corner of my iphone screen. It equally shows on the screen that I have to set up the iphone before using it again. I followed the on screen display then get connected to a WiFi, but the response I was getting is that the Set up Server cannot be contacted please try again latter. I chose the option of using itune through my Laptop. The response I was getting here is that my iphone cannot be connected the itune store because my iphone was not found.
I am regretting why I updated the ios. Please, can someone advise me on what to do please.
I am ernestly waiting for your kind response.
Regards
DanielHi iPheariPhoPad,
Welcome to Apple Support Communities.
It sounds like there’s an issue with Settings, the Notes app entry isn’t showing up as expected. Take a look at the article linked below and try restarting your iPhone 3GS.
Restart or reset your iPhone, iPad, or iPod touch - Apple Support
If that doesn’t do it, try restoring your iPhone as shown in this article:
Use iTunes to restore your iOS device to factory settings - Apple Support
Take care,
-Jason -
After updating to iOS 5, I cannot retrieve Yahoo Mail
After updating to iOS 5, I cannot retrieve up to date Yahoo Mail. It successfully connects. But it only shows some old emails. Nothing current. I've deleted the Yahoo connector and recreated it. Same thing. I know I have new emails waiting in my Yahoo Inbox, yet they're not showing on my iPhone.
Any ideas?I fixed Yahoo Mail on my 3GS with iOS 5: In Settings, "Mail, Contacts, Calendars", I reduced "Show" to "50 Recent Messages"
It had been set to "200 Recent Messages"
I also have an Exchange and MobileMe account setup on the phone.
I guess that there is not enough memory or something with iOS 5 on some devices to hold 200 Recent Messages from multiple accounts.
Hope this helps! -
What is wrong?
Why itune can't syn my musics, videos, etc to my phone after updating both my iphone 4s to IOS 7 and itunes to 11.1.0.126??what doe you mean you tried "basically everthing?" Did you follow http://support.apple.com/kb/ts1538?
-
How can I restore iPhoto 9.4.3 to Mt Lion after updating to Mavericks. I cannot open iPhoto in Mt Lion.
-
After update iOS7, my iphone 4s not able to connect any Wi-Fi. I tried all the possible ways, but faild.
Settings > General > Reset > Reset Network Settings
-
HT201210 after updating my my Iphone 4 I lost all contacts - anyone else - how to resolve?
after updating my my Iphone 4 I lost all contacts - anyone else - how to resolve?
If updating to iOS 7 caused your contacts to disappear, please call your AppleCare number and tell the advisor your issue. He should have you escalated to a senior advisor in which they can further assist you as far as trying to get your contacts back to you.
Source: I am an AppleCare advisor. -
After updating iTunes and iPhone 3gs AppleMobileDeviceService.exe has been taking over 50% of my CPU. When i attempt to sync my iPhone iTunes hanges on backing up. I have uninstalled all the apple software and reintalled it. This fixed the problem until QuickTime updated. Immediately following the update Apple...Services.exe went haywire agian. Any help?
Thanks wjosten. I've now been through all this, and there was a lot of old 3d party phone stuff to remove.
However, I have not progressed really. Any other thoughts on this please? -
HT4623 after update my 3gs iphone not activating now
after update my 3gs iphone not activating now
That tends to happen if you hacked your phone to unlock it.
-
I've seen all the posts for fixing the wifi on the 4s, none of them work! So, who can tell me why my iPhone 4S cannot find any wifi when it used to find wifi, and when it does find a wifi network it can never connect? You think apple would have a clue how to fix it! Because turning the wifi on and off doesn't work, resorting network settings doesn't work, even restoring phone to factory default doesn't work...
Did not work. I've selected iMessage to ON and left it. After a few hours I recieved a message "activation unsuccessful. Turn on iMessage to try again". This has been going on for the past 3 days.
-
After the new update 5.1 whenever the iPhone locks and sleeps it changes from wifi to 3G. Before the update whenever even in the lock screen the wifi bars were strong and seemed as if it's working even when the phones asleep. Now with the new 5.1 update in lock screen after the phones been asleep for a minute or two it shows 3G then like after 5 seconds or so the wifi comes on.
For some reason, today whenever I wake my phone from sleep the wifi seems to be running. A few days ago when I first posted the 3G would be on then a few seconds later it would change to wifi. Does this mean it's transferring data in my pocket all morning so far?
-
Missing music after updating iTunes and iPhone os
After updating to the latest iTunes, I have lost huge amounts of music, and I can't find them on my computer at all. We wanted to install the latest OS on our phones, and to do so, you need the latest itunes version. After intalling the latest itunes, and subsequently the latest software for the iphones, a large amount of the music has disappeared. It has all come off of the iMac (which holds our entire library) and includes a mixture of purchased from two different accounts and songs from CDs that have been imported.
I have tried searching for the files on my computer and they cannot be located. Stranger still, I have Apple's Time Machine and have looked back to before the update, and they aren't there either, which is completely bazaar as they are in the itunes library and we used to listen to them on this computer? Is it possible that the files names have become corrupt and the tracks are there but don't associate with the names?
Please can anyone help?This forum is for questions from those managing sites on iTunes U, Apple's service for colleges and universities to post educational material in the iTunes Store. You'll be most likely to get help with this issue if you ask in the general iTunes forums.
Regards.
Maybe you are looking for
-
I need to run a pc scan for something but it keeps telling me that, the page can't open.
-
Problems when printing Sapscript...
We have imported a number Sapscripts in Russian into our unicode system. Looking at the Sapscript I can see Russian text in both the first and next page of the form. However, when printing the first page looks perfect and displays in Russian, however
-
Ihave the Surface Pro touch. I just bought Adobe Pro 11. I opened the forms center and the page is to large for my screen. I cant shut it down I cant get to the (X) and the touch doesn't do anything. help
-
Can not use Silverfast scanning technology or my Epson 2100 Colour Stylus printer since upgrading to Mac OS X Lion. I had been assured that Silverfast would work and had no idea the printer would become redundent! Not Good information from Apple!! An
-
I need to upload pictures from my ipad to pinterest