After uploading IOS5 I now have 2.7 GB of Other - what is this and how do I remove it?

I updated the software for my 8G Ipod Touch 4th Generation on Saturday morning and have had nothing but problems.  At first it would not let me get past the setup portion for Wi Fi which I do not have.  Then after fussing with it for about an hour I was able to start listening to my music.  But I noticed I am unable to load as much music as the past.  I have found that out of my 6.35 GB (instead of 8 that I bought) there is now 2.7GB of Other which takes away over a third of my storage.  Does anyone know what this is and how to remove it? 

The excessive "other" is due to some files that got corrupted during the update.  You need to restore the iPod to get it reduced to its normal (<0.5 GB) value. Firs try restoring from backup.  If not successful, restore to factory defaults/new iPod.

Similar Messages

Maybe you are looking for

  • Beta driver for Titanium Fatal1ty Pro and windows 7 64 bit

    I see there are beta drivers on the website for the X-Fi Titanium Fatalty Pro on Windows 7 64 bit. The drivers are dated June 23, 200. Are there any known problems with this set of drivers?

  • Steps to convert access point from LightWeight mode to Autonomous mode

    I need steps to convert the following access point from Lightweight mode to Autonomous mode AIR-AP1242AG-E-K9 Regards, Majid

  • BW: Transaction Key  in 2LIS_02_ITM

    Hi , In the datasource for Purchasing 2LIS_02_ITM and it is also there in the Schedule line item 2LIS_02_SCL, there is a field called BW: Transaction Key mapped to BWVORG in R/3. It looks to me, that it provides information about, whether it is a inv

  • Unknown devices issue

    I installed Windows 8.1, but my devices manager is showing 5 device errors under "Other devices" They are as follows: Unknown Device ( Location: on Microsoft ACPI-Compliant System‎) ACPI\VEN_HPQ&DEV_6001 ACPI\HPQ6001 *HPQ6001 Unknown Device ( Locatio

  • Incorrect Caller ID on calls from outside line via FXO port.

       Have a public phone line connected to my CUCME 2801 router VIC2-2FXO card. All inbound calls are passed to DN-5001 (group number). Can receive and send calls without a problem, but incoming calls all show "911" for caller ID. Think this is simply