Another Fix for Spotlight! Oh Boy!!

Question

There must be a couple hundred lines of code circulating these threads to "fix" spotlight. Other fixes include removing folders adding folders, reinstalling systems, migrating...bla, bla, bla...
Here is another fix.
Start your system as you normally do. Go out into your car, start it, then shut it off. Come back into your house, restart your system. Go back out to your car, this time after getting in touch the rear view mirror three times while saying "Oingo-Boingo_".
Now go back into your house, and spotlight should have finished indexing. If it has not then you forgot to pronounce the "_" at the end of "Oingo-Boingo" as prescribed.
Good luck.

Answer 1

Ok, here's the RAM type that I currently have:
KVR1333D3N9K2/2G
2GB (1GB 128M x 64-Bit x 2 pcs.) PC3-10600 CL9 240-Pin DIMM Kit
DESCRIPTION:
ValueRAM's KVR1333D3N9K2/2G is a kit of two 128M x 64-bit 1GB (1024MB) DDR3-1333 CL9 SDRAM (Synchro- nous DRAM) memory modules, based on sixteen 64M x 8-bit DDR3-1333 FBGA components per module. The SPDs are programmed to JEDEC standard latency 1333Mhz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
JEDEC standard 1.5V ± 0.075V Power Supply VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 5,6,7,8,9,10 Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 9(DDR3-1333) 8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset
1066Mbps CL7 doesn’t have backward compatibility with 800Mbps CL5
Anyone have any ideas what manual memory settings I should try?