Anyone getting error -50?

I have been trying to do the upgrade since 1:30 PM EST. It will not let me get past the backup before doing the upgrade. This is the error I keep getting, "An error occurred while backing up this iPhone (-50). Would you like to continue to update this iPhone? Continuing will result in the loss of all contents on thiss iPhone." Is anyone else having the same issue?

Thanks all for trying to help. I decided last night to do a restore of the phone since I was unable to get it pass the error -50. I even followed the steps that were given to me on the apple site for this error. Thankfully the restore went through and all is well. I hope I never have this kind of a problem again with an iphone. Very frustrating.
Here is the link I went to...
http://support.apple.com/kb/TS3694#error50
Error 50: This error (and error -50) are timeout errors. Follow the steps for errors 13 or 14 above.
Error 13 and 14: These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network.
Thanks again for all that replied to this post.

Similar Messages

  • Anyone getting error -43 when backing up phone?

    After installing the new software, when backing my iphone an error continues to occur (error -43). Does anyone know how to solve this?

    Hey!!
    After many failed attempts this is what worked for me:
    Step 1. Right click on your phone in the left hand side bar and select Back Up
    Step 2. Restore your phone and use the option where you restore and update
    Step 3. When its done it will ask you to use the back up you previously completed
    Hopefully this works for you!!!

  • Anyone getting error connecting to update server, please try again later, (various error codes)

    i finally got back in town and was able to back-up my pb before updating the os.  the automatic updater window came up last weekend.  now that i'm fully backed up i keep trying to update over the air and my pb keeps telling me it can't connect to the update server.  first i got error code 65792 and now it's error code 0.
    is this happening to anyone else?  i prefer my updates over the air, all those have worked out well, but now i'm not sure what's going on.
    anyone?

    kandwsmom, please touch the battery icon > restart.
    After restart, reconnect to the WiFi and try the update again.
    1. If any post helps you please click the below the post(s) that helped you.
    2. Please resolve your thread by marking the post "Solution?" which solved it for you!
    3. Install free BlackBerry Protect today for backups of contacts and data.
    4. Guide to Unlocking your BlackBerry & Unlock Codes
    Join our BBM Channels (Beta)
    BlackBerry Support Forums Channel
    PIN: C0001B7B4   Display/Scan Bar Code
    Knowledge Base Updates
    PIN: C0005A9AA   Display/Scan Bar Code

  • While updating iphone software to 5.0.1, I am getting error message that Iphone cound not be updated because the firmware file is not compatible. Can anyone help me to resolve this issue.

    While updating iphone software to 5.0.1, I am getting error that Iphone could not be updated because the firmware file not compatible.
    Can anyone help me to resolve this issue.

    Using iTunes 10.5.2.11 on a PC running 64 bit Windows 7
    First did a full back up of  iphone using iTunes
    Put iphone into Recovery Mode ( http://support.apple.com/kb/ht1808 ). Erases all user data and settings!
    Disconnected USB cable from iphone
    Powered off iphone by holding down Sleep/Off button until slider appeared, slid to off, waited until screen dark
    Pressed and kept holding Home button while plugging cable back into phone
    I still saw the graphic on the iphone that said to plug into iTunes, so I unplugged and re-plugged cable. (I may have released the Home button too soon)
    Recovery Mode alert came up in iTunes.
    Followed all iTunes prompts to restore phone - it downloaded and sucessfully installed iOS 5.0.1
    iphone did not appear in iTunes due to missing pairing file (that made me nervous)
    iphone was now at factory settings. I followed prompts on iphone screen to start reactivation process
    Eventually the iphone asked if I wanted to restore from a back-up (whew!)
    A window opened in iTunes and I was able to select my previous back-up file for the restore
    A full restore from back-up then occured
    I also allowed a carrier settings update to occur when prompted (not sure that happens in all cases)
    When the restore was done I had to re-enter some passwords, but everything was there
    iOS is now 5.0.1 (9A406). The whole process took about an hour.

  • Unable to publish in Swf format. Get error message: 'Swf compilation failed. Note: Please verify if any of the actionscript keywords is used as user variable name'. Anyone know how to fix?

    Unable to publish in Swf format. Get error message reads: 'Swf compilation failed. Note: Please verify if any of the actionscript keywords is used as user variable name'. Anyone know how to fix?

    Hi There,
    Can you tell me the Operating System and Captivate version you are using?
    Also can you confirm if you are getting this issue will this one project or all the projects? Try to copy paste this project on a new blank project and then try to publish.
    Regards,
    Mayank

  • I receive error messages when I am downloading free iphone apps. I get error message 9810 and 9834. Can anyone advise how to resolve this problem?

    I receive error messages when I am downloading free iphone apps. I get error message 9810 and 9834. Can anyone advise how to resolve this problem? The problem doesn't exist when I'm downloading apps for which I pay.

    Hi,
    See Here:
    http://support.apple.com/kb/TS1276
    From Here:
    http://support.apple.com/kb/TS1424

  • I have tried to download ITunes 11on Windows 7 but I keep getting error message 5 telling me it did not install correctly and to install again. Can anyone help?

    I have tried to download ITunes 11on Windows 7 but I keep getting error message 5 telling me it did not install correctly and to install again. Can anyone help?

    HI there,
    I would recommend taking a look at the troubleshooting steps found in the artilce below.
    Trouble installing iTunes or QuickTime for Windows
    http://support.apple.com/kb/ht1926
    -Griff W

  • I have a Canon MG6120. When I start it I get error code 5050. Does anyone know how to resolve this?

    I have a Canon MG6120 all in one. When I start it I get error code 5050. Does anyone know how to resolve this, besides power off/ power on?
    Solved!
    Go to Solution.

    Hello gregg.
    Please try the following to see if we can resolve your issue:
    1.  Turn the printer off.
    2.  Unplug the power from the printer for at least 5-10 minutes.
    3.  While unplugged, remove any paper from the unit.
    4.  Double check for any obstructions found in the unit or paper paths.
    5.  If no obstructions are found, plug the power back in and turn the unit on.
    If the issue persists, the unit will require service for correction.  We apologize for this inconvenience.  Please contact our support group using the "Contact Us" option below for additional assistance.
    This didn't answer your question or issue? Find more help at Contact Us.
    Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.

  • HT1725 I am having trouble down loading a uv digital copy of a movie that i recently purchased. I keep getting error code (-50) has anyone else got this and how do you resolve it?

    I am having trouble down loading a uv digital copy of a movie that i recently purchased. I keep getting error code (-50) has anyone else got this and how do you resolve it?

    Hi,
    Try the following steps:
    1. Check windows updates.
    2. Try the Microsoft Fix it in this kb to remove previous install completely:
    http://support.microsoft.com/kb/2739501/en-us
    3. Reboot.
    4. Try installing again.
    This seems helpful on the issue.
    As always, thank you for your suggestion, Don:)
    Regards,
    Melon Chen
    TechNet Community Support

  • Cant open itunes. Get error message CMBlockBufferCopyDataBytes could not be located in the dynamic link library CoreMedia.dll. Anyone know how to fix that?

    Cant open itunes. Get error message CMBlockBufferCopyDataBytes could not be located in the dynamic link library CoreMedia.dll. Anyone know how to fix that?

    For general advice see Troubleshooting issues with iTunes for Windows updates.
    The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
    Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
    The error hints at a similar pattern to those discussed in the first and third boxes of the user tip, suggesting that you've got an outdated .dll file that needs replacing. You should find CoreMedia.dll in the one of the following folders:
         C:\Program Files\Common Files\Apple\Mobile Device Support
         C:\Program Files (x86)\Common Files\Apple\Mobile Device Support
    Delete it and then repair Apple Mobile Device Support from the Programs and Features control panel. If that doesn't work go for the full tear down and rebuild.
    tt2

  • I purchase photoshop element 12 and Premiere at Office Depot. The program came in a software download card. I get error saying not vaild. anyone else had this issue?

    I purchase photoshop element 12 and Premiere at Office Depot. The program came in a software download card. I get error saying not vaild. anyone else had this issue?

    I just bought Elements 12 at Best Buy & I'm having the same problem. My serial number retrieval redemption code is invalid every time I type it in...I'm VERY FRUSTRATED!

  • I cannot share photos with anyone ,for i select someone i get error code 400.

    I cannot share photoss with anyone for when ii try to select someone i get a error code 400.

    Version  9
    "domnic.rj23" <[email protected]> wrote:
    domnic.rj23 http://forums.adobe.com/people/domnic.rj23 created the discussion
    "Re: I cannot share photos with anyone ,for i select someone i get error code 400."
    To view the discussion, visit: http://forums.adobe.com/message/5781697#5781697

  • I am trying to download itunes 10.7 and keep getting "error writing to file C\config.msi\6f8a6.rbf.  Can anyone help?

    I am trying to download itunes 10.7 and keep getting "error writing to file C\config.msi\6f8a6.rbf"  Can anyone help?

    Are you running Kaspersky security software on that PC? (There's been a few reports in recent times of Kaspersky interfering with iTunes installs, with that message being produced.)
    If there is Kaspersky on board, we should try some general-principles getting-past-security-software-interference troubleshooting.
    Download and save a fresh copy of the iTunesSetup.exe (32-bit installer file) or iTunes64Setup.exe to your Hard drive. (Don't run the install on line, and don't start the install just yet.)
    http://www.apple.com/itunes/download/
    Restart the PC. After the PC restarts do not open any applications. Disconnect from your network and/or the internet. Now switch off all your security software (firewall, antivirus, antispyware).
    Now start the install by doubleclicking the iTunesSetup.exe (or iTunes64Setup.exe) file you downloaded earlier.
    Reenable all security software prior to reconnecting to your network and/or the internet.
    Any better luck with the security software shut down?

  • TS1424 i'm getting 'Error 306' when trying to log into itunes. Does anyone know how to fix this?

    I'm getting 'Error 306' when trying to log into itunes. Does anyone know how to fix this?

    Perhaps try the iTunes Store loads partially or returns "Error 306" or "Error 10054" section in the Specific Conditions and Alert Messages: (Mac OS X / Windows) section of the following document:
    iTunes: Advanced iTunes Store troubleshooting

  • I'm trying to sync my iPhone 5 and keep getting error message "Device is timed out", can anyone help me please?

    I'm trying to sync my iphone 5s with itunes and keep getting error message "Device is timed out", can anyone help me please?

    Try here first:
    iTunes: Error 13019 during sync
    Then here:
    Help Unknown Error 13019 (Updated)

Maybe you are looking for

  • Item text not populating in sales order

    Hi All,              I have a scenario where in we get the sales order created through a inbound 850 idoc . The trading partner sends the sales order information which gets through GENTRAN and gets posted as inbound idoc in SAP . The problem here is

  • 3G Network unusable after a phone call

    My 3G network tend to disappear after a phone call and I have to switch on and off my 3G to make it work again. I am using bb 9360. Anybody experience this?

  • Can't uninstall/reinstall itunes on ipod.

    Hi, Can anyone help me? My iPod got left in the sun at the weekend and now wont turn on - it goes to the apple logo and then to the "folder + exclamation mark" screen that directs you to the support pages. I followed the instructions I found there -

  • Accessing dynamic field names?

    I want to be able to create text fields with unique names and set values in them within a For-loop without having to reference the field names in the code. Consider the following code snippet: this.createTextField("field" + i, this.getNextHighestDept

  • Need help: enter flash file in Dreamweaver site with dark background

    Hi, I've entered a SWF in a dreamweaver site with a dark blue background. When you view the site in a browser there is a white square (the size of the flash file) that flashes up for a second before the file starts loading. This is rather ugly and I