AP HREAP NOT WORKING - NO DHCP, NO INTERNET ACCESS

Question

Current Setup
WLC  > WAN < AP
AP is in HREAP mode
The Wireless SSID shows up at the remote site
Clients can associate to the SSID on the AP (HREAP)
But it's not handing out DHCP address
From the AP (HREAP mode) I cannot ping the WLC (connected via WAN link)
From the AP (HREAP mode) I cannot ping any network on the remote site.
I can access the WLC remotely.
From the WLC i can ping default gateway for the AP dhcp server
From the WLC i cannot ping the AP
On the WLC i cannot see any AP
AP2-1262#show capwap reap association
SSID: WirelessWLAN on Dot11Radio1
bssid: f4ea.67c1.618e  Mode: 0x192, WLAN: 2 , VLAN name: 002   VLAN ID: 66
Key Mgmt 12, Reap flags 0x1, Guest Yes, Current Users 0, Open Auth
SSID: WirelessWLAN on Dot11Radio0
bssid: f4ea.67c1.6181  Mode: 0x192, WLAN: 2 , VLAN name: 002   VLAN ID: 66
Key Mgmt 12, Reap flags 0x1, Guest Yes, Current Users 0, Open Auth
Please HELP
Thanks!

Answer 1

First off, makes sure the h-reap ap is connected to a trunk port. The native vlan on the trunk port should be the vlan the ap management is on. Now on the WLAN SSID, make sure local switching is enabled in the advanced tab. Go to the h-reap ap and there is a tab on the top that says either h-reap or FlexConnect. Enter the native vlan and hit apply. Go back to that page and click on vlan mapping. Now set your WLAN SSID to the vlan out at the remote site you want to put traffic on.
If you want traffic to come back to the wlc, then you do not need to enable local switching in the WLAN said advanced tab. Your traffic will be tunneled back to the wlc and placed on the interface you chooses in the WLAN general page.
Sent from Cisco Technical Support iPhone App